Menu
EUR

Case IH CVX 150 tractor parts & technical data

With more than 400 matching items, this range covers the Case IH CVX 150 well. Product groups include lighting, electrics and trailer couplings, among others.

428 parts found for Case IH CVX 150
Show:
GRANIT Seal PU 55 x 70 x 7 mm
GRANIT
Seal PU 55 x 70 x 7 mm
€12,45 €10,29
 
GRANIT Bearing wheel hub 109,5 x 159 x 24 mm Carraro front axle 642680 Case IH
5%
GRANIT
Bearing wheel hub 109,5 x 159 x 24 mm Carraro front axle 642680 Case IH
€69,04 €57,06 €65,55 €54,17
 
GRANIT Sealing ring 115 x 154 x 5,5 mm Ford, Case IH, Steyr, New Holland
5%
GRANIT
Sealing ring 115 x 154 x 5,5 mm Ford, Case IH, Steyr, New Holland
€38,18 €31,55 €36,25 €29,96
 
Carraro Bush axle housing 35 x 52 x 20 mm Case IH, Massey Ferguson, New Holland
5%
Carraro
Bush axle housing 35 x 52 x 20 mm Case IH, Massey Ferguson, New Holland
€48,52 €40,10 €46,00 €38,02
 
GRANIT Sealing ring 150 x 180 x 14,5/16 mm Carraro front axle 644662
5%
GRANIT
Sealing ring 150 x 180 x 14,5/16 mm Carraro front axle 644662
€52,43 €43,33 €49,80 €41,16
 
Carraro Bearing bush front axle 40 x 44 x 35 mm
Carraro
Bearing bush front axle 40 x 44 x 35 mm
€8,85 €7,31
 
Carraro Combi ring 48 x 65 x 11 mm Case IH, New Holland, Steyr
Carraro
Combi ring 48 x 65 x 11 mm Case IH, New Holland, Steyr
Inner Ø: 48 mm. Outer Ø: 65 mm. Thickness: 11 mm.
€20,15 €16,65
 
ZF Shim brake Ø 248 mm, thickness 3 mm, inner-Ø 156 mm
5%
ZF
Shim brake Ø 248 mm, thickness 3 mm, inner-Ø 156 mm
€86,39 €71,40 €82,00 €67,77
 
Shim foot brake 3 mm thick Deutz Agrotron 6120.4-6160.4
5%
Shim foot brake 3 mm thick Deutz Agrotron 6120.4-6160.4
€60,44 €49,95 €57,40 €47,44
 
GRANIT Master brake cylinder mineral oil Ø 31,4 mm Case IH, New Holland, Steyr
5%
GRANIT
Master brake cylinder mineral oil Ø 31,4 mm Case IH, New Holland, Steyr
Piston Ø: 31,4 mm.
€265,58 €219,49 €252,30 €208,51
 
GRANIT Clutch pedal return spring 98 mm, Ø 3 mm
GRANIT
Clutch pedal return spring 98 mm, Ø 3 mm
€21,80 €18,02
 
ROCKINGER Drawbar KS80 rail 336 mm, pin Ø 22 mm, 4000 kg, black
ROCKINGER
Drawbar KS80 rail 336 mm, pin Ø 22 mm, 4000 kg, black
Rail width: 336 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 4000...
€1.682,20 €1.390,25
 
Front cover gasket Case IH, New Holland, Steyr
5%
Front cover gasket Case IH, New Holland, Steyr
€109,05 €90,12 €103,55 €85,58
 
GRANIT Air receiver gasket CS 68, 75, engine Sisu 320D
GRANIT
Air receiver gasket CS 68, 75, engine Sisu 320D
€18,20 €15,04
 
Clamp New Holland, Steyr, Case IH
5%
Clamp New Holland, Steyr, Case IH
€55,91 €46,21 €53,10 €43,88
 
GRANIT Tank cap thread 45 mm, for expansion tank
GRANIT
Tank cap thread 45 mm, for expansion tank
Version: Thread: 45 mm, For expansion tank.
€16,00 €13,22
 
V-belt set Case IH
V-belt set Case IH
€19,65 €16,24
 
Thermostat Ø 54 mm, 79 °C
Thermostat Ø 54 mm, 79 °C
Ø: 54 mm. Temperature: 79 °C.
€18,95 €15,66
 
Optibelt V-belt John Deere, New Holland, Case IH
Optibelt
V-belt John Deere, New Holland, Case IH
€30,45 €25,17
 
Showing 217 - 240 of 428

Case IH CVX 150 parts from front linkage to drawbar

Walk round a Case IH CVX 150 from the nose to the rear and there is something at every corner that will need replacing sooner or later. This page holds more than 400 parts for this tractor, from GRANIT and from makers such as HELLA, Scharmüller, ROCKINGER and Carraro.

Front end and engine bay

The front linkage is operated with push button switches, such as the green button for lowering. The bonnet is held up by gas struts, and when it drops on its own in the wind or on a slope, they have had their day. Under the bonnet you will find alternators, V-belts, water pump gaskets, O-rings for the feed pump and sealing rings.

Before you condemn an alternator, check the tension and condition of the V-belt and make sure the battery terminals and earth strap are clean and tight. A slipping belt or a poor earth produces exactly the same symptoms as a failed alternator. If it does have to come off, fit a new belt at the same time. A stretched old belt rarely runs true on a fresh pulley.

In and around the cab

Inside there are rocker switches and push buttons for the controls, and tractor seats for long working days. Work lamps come in many shapes, including LED flood beams that light up a wide area around the tractor. On the outside of the cab, combined indicator and position lights complete the picture.

Rear linkage and hitching

At the back it is all about hitching and lifting. There are automatic drawbars, adapter plates to mount a hitch at the right height and bushes for the lower link shaft. A seal for a lubrication line belongs here too.

Which part fits your CVX 150

The CVX 150 belongs to the Case IH CVX range. With so many models and versions in that range, the type plate is your starting point, since it gives the exact model and serial number. The old part usually carries a reference number of its own. On an alternator it is on the unit's own plate, on a gasket it is sometimes pressed into the edge. Compare it with the product description before ordering. For a drawbar or adapter plate, also measure the rail width and hole pattern of what is fitted now.

Other CVX models with their own page:

The CVX 1155 and CVX 1170 are part of the same range. Every other model from the brand is under Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart