Menu
EUR

Case IH JXU 95 tractor parts & technical data

Trailer couplings, electrics, brakes and transmission: the range for the Case IH JXU 95 counts more than 200 parts, all selected to fit this model.

208 parts found for Case IH JXU 95
Show:
LUK Single clutch 310TBFR Case IH, Fiat, Ford, New Holland
€378,98 €313,21 €360,00 €297,52
You save 5%
Thrust bearing driving clutch complete Case IH, Fiat, Ford, New Holland
Eaton Drive pinion transmission 1,37 kg
Eaton
Reference no.: 5179673 More
Reference no.: 5179673
€218,77 €180,80 €207,80 €171,74
You save 5%
Eaton Main shaft transmission Case IH, Fiat, Ford, New Holland, Steyr
Eaton
Reference no.: 5161817 More
Reference no.: 5161817
€415,03 €343,00 €394,25 €325,83
You save 5%
GRANIT Sealing ring 150 x 180 x 14,5/16 mm Carraro front axle 644662
€52,43 €43,33 €49,80 €41,16
You save 5%
Wabco Antifreeze pump 13 bar, 0,2 cm³, without control connection 4
Wabco
Connection: 1x M12 x 1.5 / 3x M22 x 1.5. Operating pressure max.: 13 bar. Delivery volume: 0.2 cm³. Contents: 500 ml. Version: • Prevents equipment... More
Connection: 1x M12 x 1.5 / 3x M22 x 1.5. Operating pressure max.: 13 b...
€288,66 €238,56 €274,20 €226,61
You save 5%
Thrust washer Ø 325 mm Case IH, Fiat, New Holland
€101,58 €83,95 €96,50 €79,75
You save 5%
VICTOR REINZ Valve cover gasket Case IH, Steyr, New Holland
Sealing ring water pump Ø 98,59 x 88,27 x 5,16 mm Case IH, New Holland
Ø: 98.59 x 88.27 x 5.16 mm. More
Ø: 98.59 x 88.27 x 5.16 mm.
€4,24 €3,50
GRANIT Water pump with gasket Case IH, Steyr, New Holland
GRANIT
Reference no.: S.68286. More
Reference no.: S.68286.
€93,30 €77,11 €88,60 €73,22
You save 5%
GRANIT Feed pump Case IH, New Holland engine F4C, F4DE04, F4DE06, 667TA
€37,44 €30,94 €35,55 €29,38
You save 5%
GRANIT Door lock, left Case IH JX 70U, MXM 190, New Holland T5030, TS120
€211,65 €174,92 €201,00 €166,12
You save 5%
GRANIT Door lock, right Case IH JX 70U, MXM 190, New Holland T5030, TS115
€211,65 €174,92 €201,00 €166,12
You save 5%
GRANIT Lock rear window lower
€26,50 €21,90
GRANIT Handle right and left Case IH, New Holland
€89,49 €73,96 €85,00 €70,25
You save 5%
Replacement key
€9,95 €8,22
Pick-up hitch hook ISO 60 x 60 mm, 280 mm, bore Ø 22,5 mm
Hole Ø: 22.5 mm. Width x height: 60 x 60 mm. Length: 280 mm. Hole spacing: 115 mm. More
Hole Ø: 22.5 mm. Width x height: 60 x 60 mm. Length: 280 mm. Hole spa...
€323,72 €267,54 €307,50 €254,13
You save 5%
GRANIT Sensor power take-off speed 23,5 mm with connection cable and plug
GRANIT
Version: Sensor, PTO shaft speed, 23.5 mm long, Connection cable with plug. More
Version: Sensor, PTO shaft speed, 23.5 mm long, Connection cable with ...
€63,15 €52,19
Sensor transmission PTO shaft, connection cable with plug, 3-pin
Version: For PTO shaft, connection cable with plug connection, 3-pin. More
Version: For PTO shaft, connection cable with plug connection, 3-pin.
€94,14 €77,80 €85,15 €70,37
You save 10%
Push button switch rear PTO shaft 48 V, button yellow, Ø 30 mm, stroke 5 mm
Version: 48 V switching voltage, Yellow button, break contact External switch on the rear mudguard, Total button travel: 5 mm, Ø 30 mm, plug connecti... More
Version: 48 V switching voltage, Yellow button, break contact External...
€45,80 €37,85 €43,50 €35,95
You save 5%
Contact switch gear switch gray, with connector
Version: Grey, connection cable with plug. More
Version: Grey, connection cable with plug.
€138,26 €114,26 €125,00 €103,31
You save 10%
Showing 121 - 144 of 208

Case IH JXU 95 parts

Replacing the clutch on a JXU 95 means splitting the tractor, and nobody wants to do that twice. It pays to order everything that belongs to the clutch in one go. This page lists more than 200 replacement parts for the Case IH JXU 95, with makers including LUK, GRANIT, Sauermann, ROCKINGER and GRAMMER.

Doing the clutch once

For the travel clutch there are clutch plates with a torsion damper, a single clutch pressure assembly and a thrust bearing. Fit a new plate but leave the old thrust bearing in, and it will often start whining again before long. Replace plate, pressure assembly and bearing together, check the flywheel face for scoring and put a light film of grease on the input shaft splines.

If there is oil on the old plate, trace the leak first, or the new clutch will soon slip as well. Sealing rings and seals for several positions are also on this page, including a piston sealing ring and a thermostat gasket.

Cab, electrics and hitching

For the cab there are gas struts for the roof window, seals for the front and rear window hinges, a mirror and a GRAMMER Compacto seat. The electrical side includes an alternator, a contact switch, a rear light and a PTO sensor with connecting cable and plug. If the PTO drops out without warning, check that plug and cable before anything else.

At the back, drawbars and a Piton Fix fit the hitch rail.

The seat deserves attention too. Worn suspension is more than a comfort issue, as your back then takes every jolt. On the Compacto seat you set the suspension to your own weight, and it is worth retightening the mounting bolts after a few hours of use. As for the roof window, once it will not stay open on its own the gas strut has had its day.

Finding the matching part

Start at the type plate and make sure the tractor is a JXU 95. For clutch parts, look for the number on the pressure assembly or plate, and count the splines if in doubt. With seals, write down where the old one was fitted.

The JXU 95 belongs to a range of types that each have their own parts page:

For items that apply across the brand, see Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart