Menu
EUR

Case IH MXU 115 tractor parts & technical data

Engine components, electrics and trailer couplings for the Case IH MXU 115 are lined up here. The page holds more than 250 parts for this MXU series model.

265 parts found for Case IH MXU 115
Show:
GRANIT Lift shaft New Holland T6.120-T7.210
€1.070,57 €884,77 €1.017,00 €840,50
You save 5%
Seal kit Hürlimann, Deutz-Fahr, Steyr
Reference no.: 47436943. More
Reference no.: 47436943.
€78,26 €64,68 €74,30 €61,41
You save 5%
Pressure switch air conditioning line with union nut, connection cable and plug
Version: Connection with union nut, Connection cable and plug. More
Version: Connection with union nut, Connection cable and plug.
€130,07 €107,50 €123,55 €102,11
You save 5%
Cobo Number plate light W5W, 12 V, AMP connection
Cobo
Bulb: 12V5WGLLS / W5W. Connection: AMP plug connection. Nominal voltage: 12 V. Type: Bulb. More
Bulb: 12V5WGLLS / W5W. Connection: AMP plug connection. Nominal voltag...
€32,60 €26,94
GRANIT Relays N/O-contact 12 V / 2x 20 A, 5-pin, with holder, blade terminal
GRANIT
Version: 12 V / 2 x 20 A, with holder, 5-pin, blade terminal. More
Version: 12 V / 2 x 20 A, with holder, 5-pin, blade terminal.
€10,65 €8,80
Scharmüller Drawbar frame 82,4 kN, rail width 330 mm, nose weight 3000 kg
Scharmüller
Detent pin Ø (mm): 25 | Lock: Ball 80 manual | Category: Bearing supports | Guide width (mm): 32 | Load capacity (kg): 3000 | Colour: AGCO grey | D-v... More
Detent pin Ø (mm): 25 | Lock: Ball 80 manual | Category: Bearing supp...
€2.156,70 €1.782,40
GRANIT Aircon compressor 12 V, pulley-Ø 112 mm, 4 grooves
GRANIT
Oil quantity (ccm): 200 | Pulley Ø (mm): 112 | Suitable oil: PAG 46 | Refrigerant: R 134a | Nominal voltage (V): 12 | No. of grooves: 4 | Fixing: DM More
Oil quantity (ccm): 200 | Pulley Ø (mm): 112 | Suitable oil: PAG 46 |...
€493,21 €407,61 €468,50 €387,19
You save 5%
MAHLE Alternator 14 V, 120 A, fastening 82 / 8,2 / 86 mm, pulley-Ø 61 mm
MAHLE
Pulley Ø (mm): 61.0 | Flange size (mm): 82,0 | Nominal voltage (V): 14 | Mounting L / d / R (mm): 82,0 / 8,2 / 86,0 | Mounting hole Ø / R (mm): 8,2 ... More
Pulley Ø (mm): 61.0 | Flange size (mm): 82,0 | Nominal voltage (V): 1...
€502,92 €415,64 €314,30 €259,75
You save 38%
LUK Torsion damper PTO shaft 8 teeth, 31,9 x 35
LUK
Number of teeth: 8. Tooth profile: 31.9x35. More
Number of teeth: 8. Tooth profile: 31.9x35.
€280,72 €232,00 €266,65 €220,37
You save 5%
GRANIT Brake lining hand brake pad on both sides Case IH, Steyr, New Holland
€54,39 €44,95 €51,65 €42,69
You save 5%
Dayco V-belt air conditioning 990 mm, 4 ribs Case IH, Steyr, New Holland
Dayco
Length: 990 mm. Ribs: 4 n. More
Length: 990 mm. Ribs: 4 n.
€30,95 €25,58
GRANIT Clamp Steyr, Case IH
€44,79 €37,02 €42,55 €35,17
You save 5%
Radiator Steyr, Case IH, New Holland
To fit as:
Steyr Series Profi: 4100, 4115 Tier 3, 6115–6135 Profi
Case IH Series Farmall: 110A–125A; Series Maxxum: 100–115 Tier 3; Series MXU...
More
To fit as:
Steyr Series Profi: 4100, 4115 Tier 3, 6115–6135 Profi
...
€1.116,81 €922,98 €1.060,95 €876,82
You save 5%
GRANIT Thermostat gasket Case IH, Steyr, New Holland
€32,03 €26,47 €30,40 €25,12
You save 5%
Cooling fan Ø 500 mm Ford, Case IH, Fiat, Steyr, New Holland
GRANIT Hinge for rear screen, left Case IH, New Holland
€102,12 €84,40 €97,00 €80,17
You save 5%
GRANIT Hinge for rear screen, right Case IH, New Holland
€102,15 €84,42 €97,00 €80,17
You save 5%
GRANIT Bearing for lower link shaft Ø 30 mm Ford, Case IH, Fiat, Steyr, New Holland
€62,28 €51,47 €59,15 €48,88
You save 5%
Spiegelarm right Case IH, New Holland
€163,34 €134,99 €147,75 €122,11
You save 10%
Showing 217 - 240 of 265

Case IH MXU 115 parts

If the driveline of your MXU 115 rattles at idle or clunks as the clutch takes up, the torsion damper between engine and transmission deserves a look first. It is one of more than 250 new replacement parts for this Case IH on this page, from GRANIT, Scharmüller, ROCKINGER, GRAMMER, PROBOSS and others.

Torsion damper and linkage seals

Replacing the torsion damper means splitting the tractor. While it is apart, inspect the splines on the shaft the damper slides onto. Worn splines will wear out a new damper early.

For the rear linkage there are lift arm shaft seals and complete seal kits. If oil is weeping from the lift arm shaft, clean the shaft and feel for a groove where the old seal ran. A new seal on a grooved shaft soon leaks again. Always fit the lip facing the oil. Separate sealing rings and ball joints for the front axle complete this area. Play in a ball joint shows up quickest when someone rocks the steering wheel while you watch the front wheel.

A leaking linkage seal kit often shows itself before oil appears on the floor, as an implement slowly sinks while the tractor is parked. Replace the full kit in one go, otherwise the neighbouring ring will start leaking a few months later. Deburr sharp edges on grooves and bores before fitting, and cycle the lift fully a few times afterwards before checking the oil level.

Hitching up

For the back end there are ROCKINGER automatic hitches, drawbar retrofit kits, height adjustable adapter plates and the Scharmüller Piton Fix system, so the hitch can be set up for the job in hand.

Seat and cab

Long days call for a decent seat. There are GRAMMER tractor seats from the Maximo line and air suspended PROBOSS seats, some with a seat heater. Mirrors, gas struts, rocker switches and sensors for the electronics complete the cab side.

Matching parts to your MXU

The type plate tells you which model you have. Look for a reference number on the old part and compare it with the number shown with the product. Before ordering a hitch or adapter plate, measure the rail width on the drawbar frame.

Running another MXU alongside the 115? Each of these models has a page of its own:

All other tractors of the brand are listed under Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart