Menu
EUR

Case IH MXU 115 tractor parts & technical data

Engine components, electrics and trailer couplings for the Case IH MXU 115 are lined up here. The page holds more than 250 parts for this MXU series model.

265 parts found for Case IH MXU 115
Show:
Eaton Shift ring 616 g Case IH, Ford, New Holland, Steyr
Eaton
Reference no.: E6NN7106AA More
Reference no.: E6NN7106AA
€114,83 €94,90 €109,00 €90,08
You save 5%
GRANIT Seal kit hydraulic steering Case IH, New Holland
€102,00 €84,30 €96,90 €80,08
You save 5%
Seal kit hydraulic steering Case IH MXU 100-115, New Holland
€55,67 €46,01 €52,85 €43,68
You save 5%
GRANIT Seal kit hydraulic steering Case IH, New Holland
€45,80 €37,85 €43,50 €35,95
You save 5%
Ball joint 106 mm, taper 20 - 22 mm, M18 x 1,5, M24 x 1,5
A: 106 mm. C: M18 x 1,5 mm. D: M24 x 1,5 mm. E: 20 mm. F: 22 mm. Taper: 20 - 22 mm. More
A: 106 mm. C: M18 x 1,5 mm. D: M24 x 1,5 mm. E: 20 mm. F: 22 mm. Taper...
€57,56 €47,57 €54,65 €45,17
You save 5%
LUK Torsion damper 16 teeth, tooth profile 31X35 Case IH, Steyr, New Holland
LUK
Number of teeth: 16. Tooth profile: 31X35. More
Number of teeth: 16. Tooth profile: 31X35.
€551,15 €455,50 €523,55 €432,69
You save 5%
LUK Torsion damper 16 teeth, tooth profile 31X35 Case IH, Steyr, New Holland
LUK
Number of teeth: 16. Tooth profile: 31x35. Menke no.: 92343. More
Number of teeth: 16. Tooth profile: 31x35. Menke no.: 92343.
€734,02 €606,63 €697,30 €576,28
You save 5%
Compressed air sensor M12 x 1,5 Case IH, New Holland
Connection: M12 x 1,5. More
Connection: M12 x 1,5.
€278,45 €230,12
Outer plate hand brake Case IH, New Holland, Steyr
€120,93 €99,94 €114,85 €94,92
You save 5%
Brake disc Ø 327 mm, thickness 10 mm, 12 teeth
€233,24 €192,76 €221,55 €183,10
You save 5%
GRANIT Brake band PTO shaft Ø 210,1 x 19,1 x 1,5 mm Case IH, Ford
GRANIT
Version: Ø 210.1 x 19.1 x 1.5 mm. More
Version: Ø 210.1 x 19.1 x 1.5 mm.
€37,75 €31,20
ROCKINGER Drawbar KS80 rail 336 mm, pin Ø 22 mm, 4000 kg, black
ROCKINGER
Rail width: 336 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 4000 kg. D-value: 100 kN. Colour: Black. Lock: KS80. Menke no.: 67134. More
Rail width: 336 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load cap...
€1.682,20 €1.390,25
VICTOR REINZ Valve cover gasket Case IH, Steyr, New Holland
Borg Warner Fan clutch Ford, Case IH, Steyr, New Holland
€329,00 €271,90 €288,75 €238,64
You save 12%
GRANIT Fan clutch M30 x 2 L, hole spacing-Ø 96,77 mm
GRANIT
Thread: M30 x 2 L. PCD: 96,77 mm. More
Thread: M30 x 2 L. PCD: 96,77 mm.
€216,15 €178,64 €205,30 €169,67
You save 5%
Sealing ring water pump Ø 98,59 x 88,27 x 5,16 mm Case IH, New Holland
Ø: 98.59 x 88.27 x 5.16 mm. More
Ø: 98.59 x 88.27 x 5.16 mm.
€4,24 €3,50
Idler pulley Ø 65 / 32 mm Case IH, Steyr, New Holland
€121,56 €100,46 €115,45 €95,41
You save 5%
GRANIT Heating flange Case IH, Steyr, New Holland
€127,79 €105,61 €121,40 €100,33
You save 5%
GRANIT Cylinder head gasket 1,25 mm engine Iveco F4D Case IH, New Holland, Steyr
€248,63 €205,48 €236,15 €195,17
You save 5%
GRANIT Feed pump Case IH, New Holland engine F4C, F4DE04, F4DE06, 667TA
€37,44 €30,94 €35,55 €29,38
You save 5%
Bosch/Rexroth Hydraulic pump clockwise 45 cm³/rpm., 13 splines SAE-B
Bosch/Rexroth
Output volume: 45 cc/rev. Drive shaft: Splined shaft 13, SAE-B. Direction of rotation: Right. More
Output volume: 45 cc/rev. Drive shaft: Splined shaft 13, SAE-B. Direct...
€3.513,54 €2.903,75 €3.337,85 €2.758,55
You save 5%
Showing 145 - 168 of 265

Case IH MXU 115 parts

If the driveline of your MXU 115 rattles at idle or clunks as the clutch takes up, the torsion damper between engine and transmission deserves a look first. It is one of more than 250 new replacement parts for this Case IH on this page, from GRANIT, Scharmüller, ROCKINGER, GRAMMER, PROBOSS and others.

Torsion damper and linkage seals

Replacing the torsion damper means splitting the tractor. While it is apart, inspect the splines on the shaft the damper slides onto. Worn splines will wear out a new damper early.

For the rear linkage there are lift arm shaft seals and complete seal kits. If oil is weeping from the lift arm shaft, clean the shaft and feel for a groove where the old seal ran. A new seal on a grooved shaft soon leaks again. Always fit the lip facing the oil. Separate sealing rings and ball joints for the front axle complete this area. Play in a ball joint shows up quickest when someone rocks the steering wheel while you watch the front wheel.

A leaking linkage seal kit often shows itself before oil appears on the floor, as an implement slowly sinks while the tractor is parked. Replace the full kit in one go, otherwise the neighbouring ring will start leaking a few months later. Deburr sharp edges on grooves and bores before fitting, and cycle the lift fully a few times afterwards before checking the oil level.

Hitching up

For the back end there are ROCKINGER automatic hitches, drawbar retrofit kits, height adjustable adapter plates and the Scharmüller Piton Fix system, so the hitch can be set up for the job in hand.

Seat and cab

Long days call for a decent seat. There are GRAMMER tractor seats from the Maximo line and air suspended PROBOSS seats, some with a seat heater. Mirrors, gas struts, rocker switches and sensors for the electronics complete the cab side.

Matching parts to your MXU

The type plate tells you which model you have. Look for a reference number on the old part and compare it with the number shown with the product. Before ordering a hitch or adapter plate, measure the rail width on the drawbar frame.

Running another MXU alongside the 115? Each of these models has a page of its own:

All other tractors of the brand are listed under Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart