Menu
EUR

Case IH MXU 115 tractor parts & technical data

Engine components, electrics and trailer couplings for the Case IH MXU 115 are lined up here. The page holds more than 250 parts for this MXU series model.

265 parts found for Case IH MXU 115
Show:
GRANIT Seal glow plug Case IH, Steyr, New Holland
GRANIT
Seal glow plug Case IH, Steyr, New Holland
€1,86 €1,54
 
GRANIT Cylinder head gasket 1,25 mm engine Iveco F4D Case IH, New Holland, Steyr
5%
GRANIT
Cylinder head gasket 1,25 mm engine Iveco F4D Case IH, New Holland, Steyr
Thickness: 1,25 mm.
€248,63 €205,48 €236,15 €195,17
 
GRANIT O-ring thermostat Ford, Case IH, Fiat, Steyr
GRANIT
O-ring thermostat Ford, Case IH, Fiat, Steyr
€4,31 €3,56
 
GRANIT Feed pump Case IH, New Holland engine F4C, F4DE04, F4DE06, 667TA
5%
GRANIT
Feed pump Case IH, New Holland engine F4C, F4DE04, F4DE06, 667TA
€37,44 €30,94 €35,55 €29,38
 
Bosch/Rexroth Hydraulic pump clockwise 45 cm³/rpm., 13 splines SAE-B
5%
Bosch/Rexroth
Hydraulic pump clockwise 45 cm³/rpm., 13 splines SAE-B
Output volume: 45 cc/rev. Drive shaft: Splined shaft 13, SAE-B. Direction of rot...
€3.513,54 €2.903,75 €3.337,85 €2.758,55
 
GRAMMER Tractor seat Maximo Dynamic DDS MSG95AL/741
GRAMMER
Tractor seat Maximo Dynamic DDS MSG95AL/741
To fit: Case, New Holland, Steyr. Suspension: Air suspension. Upholstery type: F...
€2.988,60 €2.469,92
 
Replacement key
Replacement key
€9,95 €8,22
 
Stabilizer cat. 1, 410 mm, eye-Ø 19 mm, clevis width 44 mm
5%
Stabilizer cat. 1, 410 mm, eye-Ø 19 mm, clevis width 44 mm
Eye Ø: 19 mm. Description: Gabelkopfbreite 44 mm. Cat.: 1. Length min./max.: 410...
€604,85 €499,88 €574,60 €474,88
 
Fender bracket left complete sprung front axle with brake MXU 100-135
5%
Fender bracket left complete sprung front axle with brake MXU 100-135
€432,21 €357,20 €410,55 €339,30
 
Scharmüller Top drawbar rail 330 mm, pin Ø 25 mm, coupling pin 38 mm
12%
Scharmüller
Top drawbar rail 330 mm, pin Ø 25 mm, coupling pin 38 mm
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecting pin: 38 ...
€849,73 €702,26 €751,50 €621,07
 
Scharmüller Drawbar manual rail width 330 mm, coupling pin 31 mm, 82,4 kN
12%
Scharmüller
Drawbar manual rail width 330 mm, coupling pin 31 mm, 82,4 kN
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecting pin: 31 ...
€637,08 €526,51 €563,40 €465,62
 
GRANIT Mirror holder right Case IH, Steyr, New Holland
10%
GRANIT
Mirror holder right Case IH, Steyr, New Holland
€139,38 €115,19 €126,10 €104,21
 
GRANIT Sensor steering angle front axle, connection cable with plug
10%
GRANIT
Sensor steering angle front axle, connection cable with plug
Version: Steering angle (front axle), Connection cable with plug.
€529,16 €437,32 €478,75 €395,66
 
GRANIT Sensor power take-off speed 23,5 mm with connection cable and plug
GRANIT
Sensor power take-off speed 23,5 mm with connection cable and plug
Version: Sensor, PTO shaft speed, 23.5 mm long, Connection cable with plug.
€63,15 €52,19
 
Push button switch rear PTO shaft 48 V, button yellow, Ø 30 mm, stroke 5 mm
5%
Push button switch rear PTO shaft 48 V, button yellow, Ø 30 mm, stroke 5 mm
Version: 48 V switching voltage, Yellow button, break contact External switch on...
€45,80 €37,85 €43,50 €35,95
 
Rotary switch fan 4-stage, without knob, 6 connections
5%
Rotary switch fan 4-stage, without knob, 6 connections
Version: For blower, 4-speed, 6 blade terminals.
€110,10 €90,99 €104,55 €86,41
 
GRANIT Starter switch without key, connection cable with plug
5%
GRANIT
Starter switch without key, connection cable with plug
Version: Connection cable with plug, Key 50717018.
€96,81 €80,01 €91,95 €75,99
 
DANA Spicer Synchro unit, complete 12 x 12 tray 1ste / 2de Case IH, New Holland
5%
DANA Spicer
Synchro unit, complete 12 x 12 tray 1ste / 2de Case IH, New Holland
€529,33 €437,46 €502,85 €415,58
 
Scharmüller Drawbar frame 10 kN, rail 200 mm, guide 25 mm, pin Ø 16 mm
Scharmüller
Drawbar frame 10 kN, rail 200 mm, guide 25 mm, pin Ø 16 mm
Detent pin Ø (mm): 16 | Category: Bearing supports | Load capacity (kg): 295 | G...
€936,85 €774,26
 
MAHLE Alternator 14 V / 120 A, flange 81 mm, pulley-Ø 67 mm
40%
MAHLE
Alternator 14 V / 120 A, flange 81 mm, pulley-Ø 67 mm
Mounting hole Ø / R (mm): 8,2 / 86,0 | Pulley Ø (mm): 67.0 | Charging current (A...
€518,55 €428,55 €308,65 €255,08
 
SANDEN Aircon compressor 12 V, Ø 112 mm, 4 grooves Case IH, New Holland, Steyr
5%
SANDEN
Aircon compressor 12 V, Ø 112 mm, 4 grooves Case IH, New Holland, Steyr
Oil quantity (ccm): 200 | Suitable oil: SP 10 | Additional information: incl. O-...
€655,35 €541,61 €622,55 €514,50
 
FEBI Engine oil filter LF16117
37%
FEBI
Engine oil filter LF16117
€32,61 €26,95 €20,58 €17,01
 
FEBI Gas strut door 850 N, 213 mm, stroke 44 mm Steyr, New Holland
56%
FEBI
Gas strut door 850 N, 213 mm, stroke 44 mm Steyr, New Holland
To fit as: Case IH Door
€65,34 €54,00 €28,77 €23,78
 
Showing 169 - 192 of 265

Case IH MXU 115 parts

If the driveline of your MXU 115 rattles at idle or clunks as the clutch takes up, the torsion damper between engine and transmission deserves a look first. It is one of more than 250 new replacement parts for this Case IH on this page, from GRANIT, Scharmüller, ROCKINGER, GRAMMER, PROBOSS and others.

Torsion damper and linkage seals

Replacing the torsion damper means splitting the tractor. While it is apart, inspect the splines on the shaft the damper slides onto. Worn splines will wear out a new damper early.

For the rear linkage there are lift arm shaft seals and complete seal kits. If oil is weeping from the lift arm shaft, clean the shaft and feel for a groove where the old seal ran. A new seal on a grooved shaft soon leaks again. Always fit the lip facing the oil. Separate sealing rings and ball joints for the front axle complete this area. Play in a ball joint shows up quickest when someone rocks the steering wheel while you watch the front wheel.

A leaking linkage seal kit often shows itself before oil appears on the floor, as an implement slowly sinks while the tractor is parked. Replace the full kit in one go, otherwise the neighbouring ring will start leaking a few months later. Deburr sharp edges on grooves and bores before fitting, and cycle the lift fully a few times afterwards before checking the oil level.

Hitching up

For the back end there are ROCKINGER automatic hitches, drawbar retrofit kits, height adjustable adapter plates and the Scharmüller Piton Fix system, so the hitch can be set up for the job in hand.

Seat and cab

Long days call for a decent seat. There are GRAMMER tractor seats from the Maximo line and air suspended PROBOSS seats, some with a seat heater. Mirrors, gas struts, rocker switches and sensors for the electronics complete the cab side.

Matching parts to your MXU

The type plate tells you which model you have. Look for a reference number on the old part and compare it with the number shown with the product. Before ordering a hitch or adapter plate, measure the rail width on the drawbar frame.

Running another MXU alongside the 115? Each of these models has a page of its own:

All other tractors of the brand are listed under Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart