Menu
EUR

New Holland T7.290 tractor parts & technical data

Engine parts, electrics and trailer couplings for the New Holland T7.290 share one page here. In total there are more than 110 parts for this T7 series model.

112 parts found for New Holland T7.290
Show:
AdBlue injection unit DM 2.5, 7,2 kg/hr
Description: DM 2.5, 7.2 kg/hr. More
Description: DM 2.5, 7.2 kg/hr.
€381,26 €315,09 €362,15 €299,30
You save 5%
GRANIT Seal Case IH, Steyr
€20,60 €17,02
Thrust bearing Maxxum, Optum, Puma, Vestrum Case IH, New Holland, Steyr
GRANIT Cylinder head bolt M12 x 150 mm Case IH, Steyr, New Holland
GRANIT
Dimensions: M12 x 150 mm. More
Dimensions: M12 x 150 mm.
€5,50 €4,55
GRANIT Cylinder head bolt M12 x 130 mm Case IH, Steyr, New Holland
GRANIT
Dimensions: M12 x 130 mm. More
Dimensions: M12 x 130 mm.
€4,54 €3,75
Frame fender R950-300 CCM HD
Reference no.: 47741331. More
Reference no.: 47741331.
€205,82 €170,10 €195,50 €161,57
You save 5%
ROCKINGER Adaptor plate rail width 390 mm, hole pattern 160 x 100 mm, M20
ROCKINGER
Load capacity: 4000 / 1000 kg. D-value: 98,1 kN. Rail width: 390 mm. Hole pattern: 160 x 100 mm. Pin Ø: 25 mm. Guide width: 32 mm. Colour: black. Des... More
Load capacity: 4000 / 1000 kg. D-value: 98,1 kN. Rail width: 390 mm. H...
€574,63 €474,90 €462,00 €381,82
You save 20%
Oil sump gasket Case IH, New Holland, Steyr
€118,37 €97,83 €112,45 €92,93
You save 5%
AdBlue-filter Fendt, John Deere, Massey Ferguson
Description: for AdBlue supply unit. MANN no.: U5001KIT. Donaldson no.: P956170. Fleetguard no.: UF101. Hifi no.: SD70380. Hengst no.: E103UD295. More
Description: for AdBlue supply unit. MANN no.: U5001KIT. Donaldson no....
€56,70 €46,86 €53,85 €44,50
You save 5%
NOX sensor at catalytic output, 5-pin, 915 mm
To fit: Case IH, New Holland, Steyr. Installation location: At the catalytic converter outlet. Cable length: 915 mm. More
To fit: Case IH, New Holland, Steyr. Installation location: At the cat...
€449,33 €371,35 €426,85 €352,77
You save 5%
Crankshaft seal for Case IH, Steyr, New Holland
€34,58 €28,58 €32,85 €27,15
You save 5%
GRANIT Frame fender R950 dark gray
GRANIT
Reference no.: 47814947. More
Reference no.: 47814947.
€132,25 €109,30 €125,60 €103,80
You save 5%
GRANIT Frame fender R850-245 CCM HD
GRANIT
Reference no.: 47741332. More
Reference no.: 47741332.
€226,27 €187,00 €214,95 €177,64
You save 5%
Rear-view mirror 487 x 228 x 130 mm, heated, 12 V, right
Dimensions: 487 x 228 x 130 mm. Height: 130 mm. Width: 228 mm. Length: 487 mm. Radius of curvature: 1200 / 300 mm. Version: Heated. Operating voltage:... More
Dimensions: 487 x 228 x 130 mm. Height: 130 mm. Width: 228 mm. Length:...
€299,46 €247,49 €270,90 €223,88
You save 10%
Showing 97 - 112 of 112

New Holland T7.290 parts for exhaust aftertreatment, engine and hitch

When a warning light comes on in a New Holland T7.290, the exhaust aftertreatment is a frequent suspect. A NOX sensor at the catalytic converter outlet or a temperature sensor sending implausible readings can push the engine into limp mode. That is why this page starts with the engine and moves to the hitch afterwards. You will find more than 110 parts for the T7.290 here, from Scharmüller, GRANIT, ROCKINGER, Walterscheid and FEBI.

Sensors, seals and bolts

Alongside NOX sensors and temperature sensors there are crankshaft seals and cylinder head bolts. A weeping seal at the front of the crankshaft throws oil onto the belt drive and shortens belt life. On many engines the head bolts are stretch bolts, so never reuse them and tighten them in the sequence and to the angle given in the workshop manual.

Route the cable of a new NOX sensor exactly as the old one ran and use the existing clips. A cable resting against the hot exhaust or rubbing as the tractor steers will bring the same fault code back within weeks.

Drawbar, Piton Fix and hydraulics

At the back of the T7.290 it is all about coupling up. There are automatic drawbars, automatic hitches, top drawbars and complete drawbar frames, plus Piton Fix and adapter plates. For steered trailers there are forced steering parts, and for the PTO there are clutch carriers and balls from Walterscheid. A hydraulic cylinder and a fender frame complete the picture.

Making sure it fits

The T7.290 is one of the larger types in the T7 series. Related models look alike from the outside, so the type plate is the first thing to check. If the old part is already off, look for a stamped or printed number and compare it with the parts on this page. With sensors the connector matters too, as a plug with a different pin count simply will not mate.

If there are more T7 tractors on the farm, each type has a page of its own:

The T7.260 and the T7.190 are part of the same series as well. For every New Holland model in one overview, go to New Holland parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart