Menu
EUR

Case IH CS 78 tractor parts & technical data

More than 400 parts make this page a solid starting point for the Case IH CS 78. Lighting, trailer couplings and electrics for the CS series come first.

440 parts found for Case IH CS 78
Show:
GRANIT Ball joint 175 mm, M22 x 1,5, taper 24 - 26 mm
5%
GRANIT
Ball joint 175 mm, M22 x 1,5, taper 24 - 26 mm
A: 175 mm. C: M22 x 1,5 mm. D: M22 x 1,5 mm. E: 24 mm. F: 26 mm. Taper: 24 - 26 ...
€74,94 €61,93 €71,15 €58,80
 
Axial joint 204 mm, M22 x 1,5, M22 x 1,5, Ø 56 mm, Ø 40 mm, 38 °
5%
Axial joint 204 mm, M22 x 1,5, M22 x 1,5, Ø 56 mm, Ø 40 mm, 38 °
A: 204 mm. C: M22 x 1,5 mm. D: M22 x 1,5 mm. F: 38 °. Ø B: 56 mm. Ø E: 40 mm.
€54,86 €45,34 €52,10 €43,06
 
Carraro Pivot bush 115 x 125 x 42 mm Carraro front axle John Deere, Case IH
5%
Carraro
Pivot bush 115 x 125 x 42 mm Carraro front axle John Deere, Case IH
Outer Ø: 125 mm. Inner Ø: 115 mm. Length: 42 mm.
€72,24 €59,70 €68,60 €56,69
 
Wabco Reservoir for antifreeze pump
5%
Wabco
Reservoir for antifreeze pump
€106,94 €88,38 €101,55 €83,93
 
Seal brake reservoir Case IH, Steyr
Seal brake reservoir Case IH, Steyr
€10,85 €8,97
 
Spring brake cable Case IH, Steyr
Spring brake cable Case IH, Steyr
€16,30 €13,47
 
Brake mechanism foot brake Ø 242 mm Case IH, New Holland, Steyr
5%
Brake mechanism foot brake Ø 242 mm Case IH, New Holland, Steyr
€314,60 €260,00 €298,85 €246,98
 
ROCKINGER Piton Fix rail width 330 mm, locking pin Ø 25 mm, 4000 kg, 89,3 kN
20%
ROCKINGER
Piton Fix rail width 330 mm, locking pin Ø 25 mm, 4000 kg, 89,3 kN
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Load capacity: 4000...
€1.306,80 €1.080,00 €1.050,65 €868,31
 
VICTOR REINZ Valve stem seal set Ø 9 x 1,5 mm
VICTOR REINZ
Valve stem seal set Ø 9 x 1,5 mm
€37,35 €30,87
 
Solenoid switch Case IH, Steyr
5%
Solenoid switch Case IH, Steyr
€361,06 €298,40 €343,00 €283,47
 
GRANIT Flame glow plug 12 V, 12,5 A, thread 7/8" - 3/8" UNF Steyr, Case IH
5%
GRANIT
Flame glow plug 12 V, 12,5 A, thread 7/8" - 3/8" UNF Steyr, Case IH
Version: 12 V, 12.5 A, thread 7/8" - 3/8" UNF.
€33,26 €27,49 €31,55 €26,07
 
Thermostat Ø 67 mm, 83 °C Massey Ferguson, Case IH, Steyr
5%
Thermostat Ø 67 mm, 83 °C Massey Ferguson, Case IH, Steyr
Ø: 67 mm. Temperature: 83 °C.
€36,87 €30,47 €35,00 €28,93
 
Radiator hose, top Ø 50 / 37 mm Steyr, Case IH
5%
Radiator hose, top Ø 50 / 37 mm Steyr, Case IH
Inner Ø: 50 / 37 mm.
€88,73 €73,33 €84,25 €69,63
 
Exhaust valve guide Case IH, Steyr, Renault, Fendt
5%
Exhaust valve guide Case IH, Steyr, Renault, Fendt
€33,11 €27,36 €31,45 €25,99
 
GRANIT Piston ring set 3 rings Ø 105 mm, 3 mm trapezoidal ring / 2 mm / 4 mm
5%
GRANIT
Piston ring set 3 rings Ø 105 mm, 3 mm trapezoidal ring / 2 mm / 4 mm
Dimensions: 3 rings, Ø 105 mm, 3 mm (trapezoidal ring) / 2 mm / 4 mm.
€47,65 €39,38 €45,25 €37,40
 
GRANIT Connecting rod bearing standard, Ø 63 mm
5%
GRANIT
Connecting rod bearing standard, Ø 63 mm
Dimensions: Ø 63 mm.
€35,34 €29,21 €33,55 €27,73
 
Inlet valve engine MWM TD 226 Case IH, Steyr, Renault
5%
Inlet valve engine MWM TD 226 Case IH, Steyr, Renault
€63,80 €52,73 €60,60 €50,08
 
Crankshaft seal rear Ø 110 x 140 x 14 mm Case IH, Steyr, New Holland
5%
Crankshaft seal rear Ø 110 x 140 x 14 mm Case IH, Steyr, New Holland
Outer Ø: 140 mm. Width: 14 mm. Inner Ø: 110 mm.
€99,24 €82,02 €94,25 €77,89
 
Crankshaft seal for Ø 58 x 80 x 12 mm Case IH, Steyr, New Holland
5%
Crankshaft seal for Ø 58 x 80 x 12 mm Case IH, Steyr, New Holland
Outer Ø: 80 mm. Width: 12 mm. Inner Ø: 58 mm.
€100,84 €83,34 €95,75 €79,13
 
Cylinder head gasket engine Sisu 420
5%
Cylinder head gasket engine Sisu 420
€146,11 €120,75 €138,80 €114,71
 
GRANIT Cover gasket crankshaft rear engine MWM D 226, TD 226 Case IH, Steyr
5%
GRANIT
Cover gasket crankshaft rear engine MWM D 226, TD 226 Case IH, Steyr
€59,50 €49,17 €56,50 €46,69
 
Steering valve ew/dw with float position 220 bar, 70 l/min, system SB23OC
5%
Steering valve ew/dw with float position 220 bar, 70 l/min, system SB23OC
Technical data: Max. operating pressure: 220 bar, Nominal flow rate: max. 70 l/m...
€577,47 €477,25 €548,55 €453,35
 
Bosch/Rexroth Hydraulic pump 19 cm³/rpm., taper 1:8, Ø 17,46 mm, anticlockwise
5%
Bosch/Rexroth
Hydraulic pump 19 cm³/rpm., taper 1:8, Ø 17,46 mm, anticlockwise
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation...
€446,89 €369,33 €424,50 €350,83
 
Showing 145 - 168 of 440

Case IH CS 78 parts for electrics, hitching and engine

The Case IH CS 78 is well covered here, with more than 400 parts from GRANIT, Scharmüller, HELLA, ROCKINGER and MAHLE. With that many items it helps to know which part of the tractor you are working on, so here is a quick guide by system.

Charging, switches and lighting

If the battery is no longer charging, an alternator is the obvious place to start. In the cab there are rocker switches, for instance for the powershift, and push button switches for the linkage. Work lamps, partly from HELLA, and indicator position lights complete the lighting.

Before you blame the alternator, check the V-belt tension and the earth strap between engine and chassis. A slipping belt or a poor earth produces the same warning light as a failed alternator. Disconnect the battery before you fit the new one.

Drawbars, automatic hitches and adapter plates

For towing there are drawbars and automatic hitches from Scharmüller and ROCKINGER, among others. Height adjustable adapter plates let you set the hitch at the right height for your trailer. Check the pin and jaw of an automatic hitch for wear now and then. A worn pin lets the trailer eye knock when pulling away and braking, and a little grease on the mechanism keeps it locking reliably.

Engine, cooling and cab

For the engine you will find feed pump O-rings, gaskets, injector sealing rings and seal kits. On the cooling side there are radiator hoses and a water pump gasket. Fit fresh clamps with every new hose. Gas struts hold the roof hatch open. Fit them rod down so the seal stays lubricated and the strut keeps its force longer. Thrust bearings are available for the clutch, and one belongs in every clutch job even if the old bearing still runs quietly.

Confirming your model and other CS tractors

The type plate confirms if you have a CS 78. For alternators and switches, compare the reference number on the old part with the numbers shown with the item, since plugs and brackets can vary.

Within the Case IH CS series every model has a page of its own. If you also work on one of these tractors alongside your CS 78, you will find the parts for that type there:

Every other tractor from the brand can be found under Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart