Looking for lighting or other parts for the John Deere 5090? The page offers more than 110 parts that fit this model, so you can quickly pick the right item.
More than 110 replacement parts for the John Deere 5090 are collected on this page, from GRANIT, Dayco, FEBI, ROCKINGER and Optibelt. They cover the areas that tend to need attention as the hours build up: the driving clutch, the belt drive, the cab door, and a set of sensors and seals.
Cab door hinges, vented tank caps and contact switches, for instance for the differential lock, are all here. If the vent in a tank cap blocks, a vacuum builds in the tank and the engine can start to falter after a while.
Multi-rib belts and V-belt tensioners keep the alternator and water pump turning. When a tensioner spring weakens, the belt slips, and you hear it as a squeal on start-up or under throttle.
Internal and external plates are available for the driving clutch. When rebuilding a clutch pack, soak the new friction plates for a while in clean oil of the grade specified for the transmission. Plates fitted dry can be damaged the first time the clutch engages. Always replace the plates as a full set.
Around the engine there are O-rings, including one for the thermostat, thermostats, crankshaft seals and gaskets. A rail pressure sensor and an air sensor belong to the engine electronics, and rubber pressure elements complete the group.
A new crankshaft seal running on a shaft with a worn groove soon starts leaking again. Press the new seal in slightly deeper or slightly shallower so the lip rides on an undamaged surface. Wipe the lip with a little oil and drive the seal in square with a suitable drift, never by tapping round the edge.
Whenever you fit a new thermostat, renew its O-ring as well. An old ring is usually flattened and lets coolant seep out. With a differential lock switch, check the plug first, as moisture in the connector produces exactly the same fault.
Start with the type plate to confirm you have a 5090. Sensors, hinges and shaft seals often carry a reference number that you can compare with the product details. With clutch plates, the inner and outer diameter of the old plate help, and with belts the number of ribs.
Every other model from the brand is gathered in the overview of John Deere parts, where each type has its own page.