Menu
EUR

New Holland T5040 tractor parts & technical data

Which parts fit the New Holland T5040? We have selected more than 200 for the T5000 series, with trailer couplings, electrics and lighting among the groups.

234 parts found for New Holland T5040
Show:
GRANIT Gear wheel PTO shaft 14 / 57 teeth Fiat, New Holland
GRANIT
Number of teeth: 14/57. More
Number of teeth: 14/57.
€115,68 €95,60 €109,85 €90,79
You save 5%
GRANIT Shift ring transmission Fiat, New Holland
€107,73 €89,03 €102,30 €84,55
You save 5%
VICTOR REINZ Valve cover gasket Case IH, Steyr, New Holland
Sealing ring water pump Ø 98,59 x 88,27 x 5,16 mm Case IH, New Holland
Ø: 98.59 x 88.27 x 5.16 mm. More
Ø: 98.59 x 88.27 x 5.16 mm.
€4,24 €3,50
GRANIT Water pump with gasket Case IH, Steyr, New Holland
GRANIT
Reference no.: S.68286. More
Reference no.: S.68286.
€93,30 €77,11 €88,60 €73,22
You save 5%
GRANIT Feed pump Case IH, New Holland engine F4C, F4DE04, F4DE06, 667TA
€37,44 €30,94 €35,55 €29,38
You save 5%
GRANIT Door lock, left Case IH JX 70U, MXM 190, New Holland T5030, TS120
€211,65 €174,92 €201,00 €166,12
You save 5%
GRANIT Door lock, right Case IH JX 70U, MXM 190, New Holland T5030, TS115
€211,65 €174,92 €201,00 €166,12
You save 5%
GRANIT Lock rear window lower
€26,50 €21,90
GRANIT Handle right and left Case IH, New Holland
€89,49 €73,96 €85,00 €70,25
You save 5%
GRANIT Sensor power take-off speed 23,5 mm with connection cable and plug
GRANIT
Version: Sensor, PTO shaft speed, 23.5 mm long, Connection cable with plug. More
Version: Sensor, PTO shaft speed, 23.5 mm long, Connection cable with ...
€63,15 €52,19
Sensor transmission PTO shaft, connection cable with plug, 3-pin
Version: For PTO shaft, connection cable with plug connection, 3-pin. More
Version: For PTO shaft, connection cable with plug connection, 3-pin.
€94,14 €77,80 €85,15 €70,37
You save 10%
Push button switch rear PTO shaft 48 V, button yellow, Ø 30 mm, stroke 5 mm
Version: 48 V switching voltage, Yellow button, break contact External switch on the rear mudguard, Total button travel: 5 mm, Ø 30 mm, plug connecti... More
Version: 48 V switching voltage, Yellow button, break contact External...
€45,80 €37,85 €43,50 €35,95
You save 5%
GRANIT Protective cap for rocker switch
GRANIT Rear light left / right 235 x 70 x 45 mm, 12 V
GRANIT
Bulb: 12V10WK / R10W, 12V21WK / P21W. Width: 235 mm. Form: Rectangular, short sides rounded. Height: 70 mm. Dimensions W x H x D: 235 x 70 x 45 mm. De... More
Bulb: 12V10WK / R10W, 12V21WK / P21W. Width: 235 mm. Form: Rectangular...
€94,30 €77,93
Contact switch gear switch gray, with connector
Version: Grey, connection cable with plug. More
Version: Grey, connection cable with plug.
€138,26 €114,26 €125,00 €103,31
You save 10%
Sauermann Wear plate trailer coupling HS 1710-1KUD/3KUD
€172,30 €142,40 €163,65 €135,25
You save 5%
Sauermann Hitch handle complete for 87 mm brede geleidehuls
Sauermann
Description: For 87 mm wide saddle sleeve, new version | Reference no.: 84364249 More
Description: For 87 mm wide saddle sleeve, new version | Reference no....
€370,50 €306,20 €351,95 €290,87
You save 5%
Showing 145 - 168 of 234

New Holland T5040 parts for clutch, linkage and drawbar

New Holland T5040 parts on this page number more than 200, supplied by GRANIT and by makers such as ROCKINGER, LUK, Sauermann and Eaton. They cover the clutch, the hydraulic lift, the hitch and the cab.

Many of these jobs are linked. If the tractor is being split for the clutch anyway, that is the moment to look at the gearbox seals and the PTO sensor as well. It stops you from starting all over again a few months later because of one small part.

Clutch work

Thrust bearings, single clutch pressure plates and clutch plates are all here, for example a thrust bearing for a single driving clutch. When you split the tractor for a clutch job, replace the pressure plate, the plate and the thrust bearing in one go. Reusing an old bearing that starts squealing a few months later means doing the whole job twice. While the engine and gearbox are apart, check the flywheel face for grooves and blue heat marks.

Lift cylinder, gears and sensors

Seals and sealing rings keep the linkage tight, including a seal for the outer lift cylinder and a sealing ring for the piston. There are also O-rings, springs and gear wheels, among them a gear for the reduction drive. A PTO sensor with a connection cable and plug, and contact switches, complete the electrical side.

Drawbar, seat and lights

For the rear there are drawbars, including an automatic one, and Piton Fix rails with a locking pin. In the cab you can fit an air suspended tractor seat in fabric and new gas struts, for example for the roof window. Rear lights are available as well. If an air suspended seat slowly sinks, the leak is usually at the air bag or its fitting. Brush on some soapy water with the compressor running and the bubbles will show you where.

Finding the correct part

Check the type plate to be certain the tractor is a T5040. A reference number on the old part makes the comparison much safer, especially with bearings and seals that look nearly identical from the outside. The T5040 sits in the New Holland T5000 series. If you also run another type from that series, use its own page: New Holland T5030, New Holland T5050, New Holland T5060 or New Holland T5070. All other models of the make are under New Holland parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart