Your New Holland TS100A is covered by more than 250 parts on this page. The TS-A series range includes trailer couplings, electrics and lighting.
This page lists more than 250 parts that fit the New Holland TS100A, sourced from GRANIT, Scharmüller, ROCKINGER, Cobo and Walterscheid. They cover the hitch, steering, hydraulics, switches and the sensors that keep the dashboard honest.
The rear of a TS100A takes plenty of punishment. Here you will find automatic drawbars, Piton Fix hitches, adapter plates and a drawbar retrofit kit. If you are changing from one hitch system to another, check the rail width on the tractor first, because the adapter plate has to suit both the rail and the new drawbar. Inspect the locking pin while you are at it, since that pin carries the full load of whatever is hitched behind.
Play in the steering usually starts at a worn ball joint, and ball joints for the track rod are listed for this model. A workshop tip: count the turns as you unscrew the old joint and wind the new one in by the same amount. The toe-in will then be close, and you only need to measure and fine-tune it.
If the linkage drops or oil weeps from the lift shaft, it is time for new seals. There are piston sealing rings, lift shaft seals and complete seal kits. On the engine side, oil pressure switches warn you when lubrication pressure falls, and sensors such as the transmission oil temperature sender keep the gauges reading correctly. A ventilated tank cap is also available. Keep its vent clear, otherwise a vacuum builds in the tank and the engine starts to starve of fuel. In the cab you will find contact switches, rocker switches, push button switches and work lamps.
Check the serial plate to make sure you have a TS100A and not another model from the TS-A range, since they look very much alike. With the old part in your hand, look for its reference number. On switches it is usually on the back, on sensors on the hex or the plug. For a ball joint, compare the thread and the taper too. A rocker switch also has to match on connections, so count the terminals on the old one before you order a replacement.
The other tractors in the TS-A range have their own pages showing only the parts that fit them.
For the rest of the brand, go to New Holland parts.