Start here when you need something for the John Deere 5105M from the 5M series: more than 200 parts for lighting, electrics, steering and front axle.
On a mixed farm the 5105M does a bit of everything, from feeding to mowing to road work with a trailer. This page lists more than 200 parts that fit it, made by GRANIT, HELLA, VICTOR REINZ, MAHLE and Cobo.
Many faults on a 5105M turn out to be electrical. For the fuse box there are relays and micro relays with changeover contacts, and for the engine there are sensors, including single pin senders. When the cab stays warm in summer with the blower running, the air conditioning compressor may be at fault, and replacements are listed here. Have the refrigerant charge checked first though, since a low charge is the more common cause.
A door or rear window that will not stay open almost always has a worn gas strut. Fit the new strut with the rod pointing down. That way the seal inside stays lubricated by the oil and the strut lasts longer. Replace struts in pairs, otherwise the door or window twists and the new one wears early.
Around the engine there are gaskets such as the air receiver gasket, O-rings including one for the master brake cylinder, seals, sealing washers and bushes. For the belt drive there are V-belt tensioners. If the belt squeals on a cold start, do not just blame the belt. A tensioner arm that no longer springs back, or an idler with a rough bearing, causes slip even with a new belt. With the belt off, spin the pulley and check that it turns smoothly and silently.
Check the serial plate to make sure you have a 5105M, because tractors in the 5M series look much alike. VICTOR REINZ gaskets and many sensors carry a number you can compare with the product description. On a gas strut, the print on the cylinder is the best guide.
Each of these models has a separate page with the parts listed for it:
The 5075M belongs to the same series. Every John Deere model is collected under John Deere parts.