Menu
EUR

John Deere 6010 tractor parts & technical data

Trailer couplings, lighting and electrics are just a few of the more than 450 parts listed for the John Deere 6010 from the 6010/6010SE series.

462 parts found for John Deere 6010
Show:
GRANIT Radiator hose, bottom inner-Ø 60 / 52 mm John Deere
5%
GRANIT
Radiator hose, bottom inner-Ø 60 / 52 mm John Deere
Inner Ø: 60 / 52 mm.
€31,67 €26,17 €30,00 €24,79
 
Thermostat Ø 54 mm, 78 °C John Deere Series 5M-7405, SE6010-SE6920
Thermostat Ø 54 mm, 78 °C John Deere Series 5M-7405, SE6010-SE6920
Ø: 54 mm. Temperature: 78 °C.
€34,55 €28,55
 
Repair set water pump John Deere
Repair set water pump John Deere
€289,65 €239,38
 
GRANIT Tank cap reservoir grommet-Ø 45 mm
GRANIT
Tank cap reservoir grommet-Ø 45 mm
Version: For expansion tank. Neck Ø: 45 mm.
€8,65 €7,15
 
Stop solenoid switch
5%
Stop solenoid switch
€36,78 €30,40 €34,90 €28,84
 
GRANIT Valve stem seal John Deere
GRANIT
Valve stem seal John Deere
€10,45 €8,64
 
Crankshaft seal for Ø 55,4 x 84 x 14,5 mm John Deere
Crankshaft seal for Ø 55,4 x 84 x 14,5 mm John Deere
Outer Ø: 84 mm. Width: 14,5 mm. Inner Ø: 55,4 mm.
€39,00 €32,23
 
GRANIT Front cover gasket John Deere
5%
GRANIT
Front cover gasket John Deere
€53,97 €44,60 €51,25 €42,36
 
O-ring oil pump 24,994 x 3,531 mm John Deere
O-ring oil pump 24,994 x 3,531 mm John Deere
Dimensions: 24.994 x 3.531 mm.
€4,26 €3,52
 
GRANIT Thrust bearing John Deere
5%
GRANIT
Thrust bearing John Deere
€36,26 €29,97 €34,40 €28,43
 
GRANIT Intake gasket inner Ø 54,5 mm, hole spacing 87 mm John Deere, Renault
GRANIT
Intake gasket inner Ø 54,5 mm, hole spacing 87 mm John Deere, Renault
Dimensions: innen Ø54,5 mm, Lochabstand 87 mm, Schrauben Ø 11 mm.
€2,94 €2,43
 
Outlet valve John Deere
Outlet valve John Deere
€22,35 €18,47
 
GRAMMER Tractor seat Maximo Evolution Dynamic MSG95EL/741 John Deere
5%
GRAMMER
Tractor seat Maximo Evolution Dynamic MSG95EL/741 John Deere
To fit: John Deere. Suspension: Air suspension. Upholstery type: Fabric / new de...
€6.582,40 €5.440,00 €6.253,25 €5.167,98
 
Stabilizer cat. 1, 410 mm, eye-Ø 19 mm, clevis width 44 mm
5%
Stabilizer cat. 1, 410 mm, eye-Ø 19 mm, clevis width 44 mm
Eye Ø: 19 mm. Description: Gabelkopfbreite 44 mm. Cat.: 1. Length min./max.: 410...
€604,85 €499,88 €574,60 €474,88
 
GRANIT Pin 18 x 65 mm, total length 76 mm, bore Ø 4,5 mm John Deere
GRANIT
Pin 18 x 65 mm, total length 76 mm, bore Ø 4,5 mm John Deere
Dimensions: 18 x 65, Total length = 76, Bore Ø = 4.5 mm.
€31,75 €26,24
 
Pin 19 x 92 mm John Deere
Pin 19 x 92 mm John Deere
Dimensions: 19 x 92 mm.
€29,65 €24,50
 
Seal 65 x 75 x 8 mm NBR John Deere
Seal 65 x 75 x 8 mm NBR John Deere
Dimensions: 65 x 75 x 8 mm. Material: NBR.
€10,85 €8,97
 
Washer for cab door John Deere Series 5M-6630
Washer for cab door John Deere Series 5M-6630
Reference no.: L57824.
€7,60 €6,28
 
Pin linkage John Deere
Pin linkage John Deere
€23,75 €19,63
 
Showing 265 - 288 of 462

John Deere 6010 parts

More than 450 replacement parts fit the John Deere 6010, from a small O-ring for the oil pump to a complete tractor seat. Here is how they break down across the tractor.

Engine, cooling and electrics

For the engine there are thermostats and thermostat housing gaskets, O-rings and seals for the oil circuit, hoses and bushes. The electrical side includes starter motors, alternators and micro relays.

A slow cranking starter is not always a starter problem. Check the battery and the earth cable first, because a new starter on a corroded earth will turn just as slowly. If you only hear a click, look at the relay and the supply before anything else.

Plates for the PTO and front axle

Internal plates for the PTO clutch and external plates for the front axle are on this page too. When the PTO slips under load or the front axle lock no longer holds, replace the complete pack rather than just the worst plates. Soak new plates in the specified oil for a while before fitting them, as dry plates can burn on first engagement.

Seats and hitching

  • tractor seats and seat cushions, partly from GRAMMER
  • drawbar balls and automatic drawbars
  • forced steering parts from Scharmüller and Walterscheid
  • further parts from HELLA and GRANIT

Whenever the thermostat comes out, fit a new housing gasket and scrape the mating faces clean. Old gasket residue causes leaks even with a fresh gasket. Bleed the cooling system carefully afterwards, because an air pocket at the thermostat makes it open late. A hose that feels soft or swollen is worth replacing at the same time, so you do not have to drain the coolant again shortly after.

Check the forced steering ball and its socket for play from time to time. A little grease prevents it from running dry and wearing unevenly. A worn drawbar ball shows itself through knocks when pulling away and braking.

Getting the right fit for your 6010

The 6010 also exists as the 6010SE, and the identification plate tells you which one you have. For clutch plates, compare the number on an old plate. Starters and alternators carry a label on the housing with a reference number to check against.

The same John Deere range includes these tractors, each with its own page:

For any other model, go to John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart