Menu
EUR

John Deere 6510 tractor parts & technical data

The John Deere 6510 from the 6010/6010SE range is well covered here, with more than 600 parts in groups such as lighting, trailer couplings and electrics.

645 parts found for John Deere 6510
Show:
GRANIT Internal plate reversing clutch 3,1 mm, inner 240 mm, outer 294 mm
GRANIT
Version: Thickness: 3.1 mm Inner: 240 mm Outer: 294 mm More
Version: Thickness: 3.1 mm Inner: 240 mm Outer: 294 mm
€76,96 €63,60 €73,10 €60,41
You save 5%
GRANIT External plate thickness 7 mm, inner 140 mm, outer 251 mm
GRANIT
Version: thickness = 7 mm inner = 140 mm outer = 251 mm | Menke no.: 221658 More
Version: thickness = 7 mm inner = 140 mm outer = 251 mm | Menke no.: 2...
€131,50 €108,68 €124,90 €103,22
You save 5%
Scharmüller Forced steering 250 mm, K50, right, 2 ton, black, 11,23 kg
Scharmüller
Description: Approved for steering forces up to 20 kN (2 t) | Connection position: 250 mm | Steering power (t): 2 | Colour: Black | Lock: K50 | Assemb... More
Description: Approved for steering forces up to 20 kN (2 t) | Connecti...
€612,85 €506,49
Sauermann Housing, pick-up hitch complete John Deere
€269,35 €222,60 €255,85 €211,45
You save 5%
FEBI Belt tensioner John Deere 6205, 6505, 6010, 6110, 6210, 6310
FEBI
Belt tensioner John Deere 6205, 6505, 6010, 6110, 6210, 6310 More
Belt tensioner John Deere 6205, 6505, 6010, 6110, 6210, 6310
€151,19 €124,95 €42,93 €35,48
You save 72%
FEBI Hydraulic oil filter HF35474
€59,76 €49,39 €39,31 €32,49
You save 34%
GRANIT Gear reduction starter 12 V, 4,2 kW, 10 teeth clockwise, flange 48 mm
€329,36 €272,20 €312,85 €258,55
You save 5%
HELLA Starter motor 12 V, 3 kW, 11 teeth, Ø 83 mm, clockwise
€790,40 €653,22 €635,45 €525,17
You save 20%
ZF Planetary bearing Ø 38 mm, width 14 mm ZF front axle 4475006011
€50,94 €42,10 €48,35 €39,96
You save 5%
ZF Planetary gear Ø 78,1 mm, 30 teeth ZF front axle 4475006011
€530,46 €438,40 €503,90 €416,45
You save 5%
Wabco Compressor 18 bar, 159 cm³, Ø 75 mm, stroke 36 mm, V-pulley 22,5 mm
Wabco
Operating pressure max.: 18 bar. Cylinder capacity: 159 cm³. Speed: 3000 1/min.. Piston Ø: 75 mm. Piston stroke: 36 mm. Cooling system: Air. Thread:... More
Operating pressure max.: 18 bar. Cylinder capacity: 159 cm³. Speed: 3...
€3.455,95 €2.856,16
GRANIT Brake disc outer-Ø 179 mm, inner-Ø 103 mm, 3,5 mm thick, 35 teeth
€36,00 €29,75 €34,20 €28,26
You save 5%
Dayco Multi-rib belt Powerband air conditioning 8 ribs, 2465 mm John Deere
Dayco
Length: 2465 mm. Ribs: 8 n. Catalogue: <a class="link link--icon entdecken-productDetails__onlineCatalogLink" href="//okat.granit-parts.com/index.php?... More
Length: 2465 mm. Ribs: 8 n. Catalogue: <a class="link link--icon entde...
€68,41 €56,54 €64,95 €53,68
You save 5%
Dayco V-belt Powerband 1920 mm, 8 ribs heavy duty
Dayco
Length: 1920 mm. Ribs: 8 n. Version: Heavy Duty. More
Length: 1920 mm. Ribs: 8 n. Version: Heavy Duty.
€57,97 €47,91 €55,00 €45,45
You save 5%
Fuel hose of filter to fuel pump 1/2" UNF John Deere
Dimensions: Thread: 1/2" UNF mm. Description: From the filter to the injection pump. More
Dimensions: Thread: 1/2" UNF mm. Description: From the filter to the i...
€19,95 €16,49
Lever for throttle linkage John Deere Series 30-8970, SE6010-SE6610
GRANIT Sealing washer filler neck Ø 70 x 4,5 mm John Deere
GRANIT
Dimensions: Ø 70 x 4.5 mm. Description: For filler neck. More
Dimensions: Ø 70 x 4.5 mm. Description: For filler neck.
€12,90 €10,66
GRANIT Clamp exhaust Ø 109 mm, width 20 mm John Deere
GRANIT
Width: 20 mm. Ø: 109 mm. More
Width: 20 mm. Ø: 109 mm.
€70,23 €58,04 €66,70 €55,12
You save 5%
Showing 265 - 288 of 645

John Deere 6510 parts

More than 600 parts are matched to the John Deere 6510 on this page, from GRANIT, HELLA, ROCKINGER, Scharmüller and Wabco. They run from an oil pump O-ring to a cab hinge, and a few groups stand out for this tractor.

Cab doors and hinges

A cab door that drops, will not stay open or rattles over rough ground usually comes down to tired gas struts or a worn hinge. For the 6510 there are door gas struts and cab hinges. Change gas struts with the door held open by a helper or a prop, and fit the new strut with the rod pointing down so its seal stays lubricated. If the hinge pin has worn, the door will sit low and the lock will not line up, which is worth fixing before the seals on the door frame start to suffer.

Engine cooling and belts

  • thermostats and gaskets for the thermostat housing
  • hoses
  • multi-rib belts
  • O-rings, including one for the oil pump
  • alternators and micro relays
  • HELLA headlights

When fitting a new thermostat, always renew the gasket and clean both mating faces thoroughly, since a scrap of old gasket is enough to cause a leak.

Front axle, steering and hitch

The 6510 also has external and internal plates for the front axle, parts for forced steering with ball ends on both sides, and automatic drawbars and drawbar frames from ROCKINGER and Scharmüller. Replace axle plates as a set and on both sides together, keeping external and internal plates in the order they came out.

Confirming the fit

The rating plate tells you it is a 6510. For O-rings, gaskets and plates, the reference number on the old part settles it. If it is unreadable, lay old and new side by side and compare shape, holes and thickness.

With forced steering, the ball ends on both sides are under real load, especially on tight headland turns. Check them for play regularly by rocking the rod by hand, and replace any ball end with play straight away, before it lets the trailer wander and wears the rest of the system.

Other tractors in the 6010 series

The 6510 is part of the John Deere 6010 series, and other tractors from that range have their own page: John Deere 6010, John Deere 6110, John Deere 6210, John Deere 6410 and John Deere 6810. Order for each type from its own page. Running another model from this maker? Browse the overview of John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart