Menu
EUR

John Deere 6520 tractor parts & technical data

Choose from more than 750 parts for the John Deere 6520. The range for the 6020 and 6020SE series includes trailer couplings, lighting and electrics.

762 parts found for John Deere 6520
Show:
GRANIT Intake gasket inner Ø 54,5 mm, hole spacing 87 mm John Deere, Renault
GRANIT
Dimensions: innen Ø54,5 mm, Lochabstand 87 mm, Schrauben Ø 11 mm. More
Dimensions: innen Ø54,5 mm, Lochabstand 87 mm, Schrauben Ø 11 mm.
€2,94 €2,43
Crankshaft seal rear Ø 117,8 x 146,25 x 13,8 mm John Deere, Renault
Outlet valve John Deere
GRANIT Valve guide John Deere 840-6920S
GRAMMER Tractor seat Maximo Evolution Dynamic MSG95EL/741 John Deere
GRAMMER
To fit: John Deere. Suspension: Air suspension. Upholstery type: Fabric / new design. Seat contact switch: Yes. Track gauge: 260 mm. Seat width: 550 m... More
To fit: John Deere. Suspension: Air suspension. Upholstery type: Fabri...
€6.582,40 €5.440,00 €6.253,25 €5.167,98
You save 5%
GRANIT Raamvergrendelingsset John Deere Series 5E-7950, SE6010-6930 PR
€128,62 €106,30 €122,15 €100,95
You save 5%
Stabilizer cat. 1, 410 mm, eye-Ø 19 mm, clevis width 44 mm
Eye Ø: 19 mm. Description: Gabelkopfbreite 44 mm. Cat.: 1. Length min./max.: 410 mm. Type: SLA-B-040. Assembly notes: Automatische Verriegelung. More
Eye Ø: 19 mm. Description: Gabelkopfbreite 44 mm. Cat.: 1. Length min...
€604,85 €499,88 €574,60 €474,88
You save 5%
GRANIT Pin 18 x 65 mm, total length 76 mm, bore Ø 4,5 mm John Deere
GRANIT
Dimensions: 18 x 65, Total length = 76, Bore Ø = 4.5 mm. More
Dimensions: 18 x 65, Total length = 76, Bore Ø = 4.5 mm.
€31,75 €26,24
Seal 65 x 75 x 8 mm NBR John Deere
Dimensions: 65 x 75 x 8 mm. Material: NBR. More
Dimensions: 65 x 75 x 8 mm. Material: NBR.
€10,85 €8,97
GASKET SET lift cylinder Ø 90 mm John Deere
€155,00 €128,10 €147,25 €121,69
You save 5%
GASKET SET lift cylinder Ø 85 mm John Deere
Dimensions: Ø 85 mm. Technical data: für Hubzylinder. More
Dimensions: Ø 85 mm. Technical data: für Hubzylinder.
€139,03 €114,90 €132,00 €109,09
You save 5%
GRANIT Wiper motor John Deere Series 7R-9630T, SE6010-6930 PR
€251,32 €207,70 €238,75 €197,31
You save 5%
Clevis for lifting strut length 225 - 300 mm, bolt-Ø 26 mm
Dimensions: Length = 225 - 300, Bolt Ø = 26, Clevis inside = 40, Clevis outside = 82 mm. More
Dimensions: Length = 225 - 300, Bolt Ø = 26, Clevis inside = 40, Clev...
€308,80 €255,21 €293,35 €242,44
You save 5%
Pump screenwash tank 12 V, intake-Ø 6,3 mm, press-Ø 6,3 mm
Intake Ø: 6.3 mm. Outlet Ø: 6.3 mm. To fit: Windscreen washer system. Voltage: 12 V. Connection type: 2 x 6,3. Operating mode: electric. More
Intake Ø: 6.3 mm. Outlet Ø: 6.3 mm. To fit: Windscreen washer system...
€35,71 €29,51 €32,30 €26,69
You save 10%
Washer for cab door John Deere Series 5M-6630
Reference no.: L57824. More
Reference no.: L57824.
€7,60 €6,28
Pin linkage John Deere
Threaded spindle M33 x 3,5 mm right-hand thread, cat. 2, B 142 mm, G 317 mm
I: M33 x 3,5 mm. Version: Right-hand thread. A: 25,4 mm. B: 142 mm. C: 51 mm. G: 317 mm. F: 175 mm. Category: 2 / 25.4. More
I: M33 x 3,5 mm. Version: Right-hand thread. A: 25,4 mm. B: 142 mm. C:...
€70,12 €57,95 €66,60 €55,04
You save 5%
Side part right John Deere
€170,37 €140,80 €154,10 €127,36
You save 10%
Showing 409 - 432 of 762

John Deere 6520 parts for the hitch, steering and hydraulics

The John Deere 6520 earns its keep at the back end, so that is where this page starts. Of the more than 750 parts listed for this tractor, many concern coupling and towing: drawbars with ball or automatic hitch, drawbar frames from ROCKINGER and Sauermann, and forced steering rods for trailers with a steered axle. Lift arms for the three point linkage are here too.

Looking after forced steering

Forced steering links the trailer axle to the tractor through a rod with a ball at each end. Those balls and their sockets take every turn on the headland, so check them for play whenever the trailer is unhitched. A joint that clicks or moves in its cup will make the trailer track badly and wear tyres. Keep the balls greased, fit the protective caps where they exist and replace both ends together if one is worn, so the steering stays even.

Engine, electrics and seals

Under the bonnet the 6520 needs the usual care, and this page covers it with:

  • Alternators and multi-rib belts, as well as belt kits
  • Thermostats with the matching regulator housing gasket
  • Hoses and sensors, including the engine oil pressure sensor
  • O-rings for the oil pump, gaskets and seals
  • External clutch plates for transmission work
  • Work lamps, with HELLA among the brands

Wabco is also represented among the makers of these parts.

Getting the right fit

The type plate tells you the model and serial number of your tractor, which is your starting point for any order. For belt kits, look at the equipment on your engine first: a kit meant for a tractor without air compressor and air conditioning follows a different belt path from one for a fully equipped machine. For seals and sensors, read the reference number off the old part and compare it with the number shown with each item.

A thermostat that sticks shows up as an engine that never reaches working temperature or one that runs hot under load. When you change it, fit a new regulator housing gasket and make sure the small bleed hole sits at the top so trapped air can escape.

The rest of the 6020 series

The 6520 sits in a family of tractors that look alike from the outside, but each has its own page so you only see parts that fit: the John Deere 6120, John Deere 6220, John Deere 6320, John Deere 6420, John Deere 6620 and John Deere 6820. The 6020 and 6420S belong to the same series. For the whole brand, see John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart