Menu
EUR

John Deere 1550 tractor parts & technical data

More than 550 parts fit the John Deere 1550. From lighting and electrics to trailer couplings, everything is gathered here so you can skip the long search.

555 parts found for John Deere 1550
Show:
GRANIT Gasket exhaust John Deere 820-2450
GRANIT Stop cable without detent 2270 mm, 2100 mm John Deere 840-3650
GRANIT
A: 2270 mm. B: 2100 mm. More
A: 2270 mm. B: 2100 mm.
€24,75 €20,45
GRANIT Bush for crankshaft John Deere
€37,86 €31,29 €35,95 €29,71
You save 5%
O-ring oil pump 24,994 x 3,531 mm John Deere
Dimensions: 24.994 x 3.531 mm. More
Dimensions: 24.994 x 3.531 mm.
€4,26 €3,52
GRANIT Exhaust manifold outer-Ø 62 mm John Deere 820-3210
GRANIT
Version: Outer Ø: 62 mm. More
Version: Outer Ø: 62 mm.
€163,33 €134,98 €155,15 €128,22
You save 5%
Crankshaft, 3-cylinder John Deere 820-1850
Notes: Please follow the instructions in the installation guide. Please complete the test instruction report contained therein, and return it to garan... More
Notes: Please follow the instructions in the installation guide. Pleas...
€940,09 €776,93 €893,00 €738,02
You save 5%
GRANIT Intake gasket inner Ø 54,5 mm, hole spacing 87 mm John Deere, Renault
GRANIT
Dimensions: innen Ø54,5 mm, Lochabstand 87 mm, Schrauben Ø 11 mm. More
Dimensions: innen Ø54,5 mm, Lochabstand 87 mm, Schrauben Ø 11 mm.
€2,94 €2,43
GRANIT Seal feed pump John Deere
€2,03 €1,68
GRANIT Cylinder head gasket Ø 119 mm John Deere
€43,38 €35,85 €41,20 €34,05
You save 5%
Connecting rod bolt 59 mm John Deere
Dimensions: 59 mm long. More
Dimensions: 59 mm long.
€16,00 €13,22
GRANIT Thrust bearing standard without thrust washer Ø 80 mm
GRANIT
Dimensions: Ø 80 mm. More
Dimensions: Ø 80 mm.
€40,29 €33,30 €38,25 €31,61
You save 5%
Crankshaft seal rear Ø 117,8 x 146,25 x 13,8 mm John Deere, Renault
Tube vertical 1200 mm, inner-Ø 75 mm, exhaust Ø 75 mm John Deere
Version: Length: 1200 mm, Inner Ø: 75 mm, Outlet Ø: 75 mm. Outer Ø: 75 mm. Inner Ø: 75 mm. Length: 1200 mm. More
Version: Length: 1200 mm, Inner Ø: 75 mm, Outlet Ø: 75 mm. Outer Ø:...
€51,29 €42,39 €48,70 €40,25
You save 5%
Tube vertical 1050 mm, inner-Ø 75 mm, outer-Ø 75 mm John Deere
Version: Length: 1050 mm, Inner Ø: 75 mm, Outlet Ø: 75 mm. Outer Ø: 75 mm. Inner Ø: 75 mm. Length: 1050 mm. Menke no.: 59865. More
Version: Length: 1050 mm, Inner Ø: 75 mm, Outlet Ø: 75 mm. Outer Ø:...
€66,00 €54,55
GRANIT Tank cap with ventilation, tank collar Ø 80 mm
GRANIT
Filler neck Ø: 80 mm. More
Filler neck Ø: 80 mm.
€18,65 €15,41
GRANIT Feed pump 2 hole, hole spacing 45 mm, flange up to end lever 32 mm
GRANIT
Version: 2 holes, Hole spacing: 45 mm, Flange to lever end: 32 mm. More
Version: 2 holes, Hole spacing: 45 mm, Flange to lever end: 32 mm.
€52,41 €43,31 €49,75 €41,12
You save 5%
GRANIT Drive shaft steering valve John Deere 830-3650
€95,12 €78,61 €90,35 €74,67
You save 5%
Showing 337 - 360 of 555

John Deere 1550 parts

More than 550 parts fit the John Deere 1550, enough to take care of a full service in one go, from the clutch to the headlights. Brands include GRANIT, HELLA, MAHLE, LUK and Wabco.

Clutch

For the clutch there are clutch plates with a torsion damper and single clutch pressure plates. Replace the plate and pressure plate together where you can. The tractor has to be split either way, and a new plate running against a worn pressure plate will not last. While it is apart, inspect the flywheel too: scoring or blue heat marks should be skimmed out before the new plate goes in.

Engine, cooling and electrics

  • Water pumps, plus seals for the lift pump and the coolant circuit
  • Exhaust gaskets and a lift housing gasket
  • O-rings, including one for the brake master cylinder
  • Starter motors and alternators
  • Left and right headlights

Coolant seeping from the weep hole on the water pump means the shaft seal has gone and the pump will not last much longer. Replace it as a unit and clean the gasket faces on the block thoroughly. Look over the belt and hoses at the same time, then refill with fresh coolant. Warm the engine up with the heater valve open and top up as the level drops. Headlights are available separately for left and right, so only the damaged side needs replacing.

Linkage, steering and air brakes

Lift arm bushes and washers take the play out of the rear linkage. On the steering side you can replace track rods and ball joints. Connector heads cover the air brake supply to a trailer, and gas struts hold the cab door or window where they should.

When changing a track rod, measure the old one first so the toe setting stays roughly where it was, then have the alignment checked, since wrong toe wears front tyres quickly.

Making sure it fits

First confirm on the data plate that the tractor is a 1550. Some parts are made for a group of John Deere models, such as a lift housing gasket that fits from the 820 up to the 3650 and a pressure plate for the 840 up to the 2650. The product details show this. Also compare the number on the old part, especially for the clutch, where the spline count and plate diameter have to match.

The 1550 is part of the 50 series. Two other tractors from that series have pages of their own:

For any other John Deere you look after, go to the overview of John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart