Menu
EUR

John Deere 4440 tractor parts & technical data

Is your John Deere 4440 due for maintenance? Choose from more than 170 parts that fit, from lighting and trailer couplings to engine parts for the 40 series.

167 parts found for John Deere 4440
Show:
GRANIT Thermostat gasket 74703012, 74712048 John Deere
GRANIT
Thermostat gasket 74703012, 74712048 John Deere
€15,20 €12,56
 
Piston ring set Ø 115,5 mm, 4 mm trapezoidal ring / 3,2 mm / 4,1 mm
5%
Piston ring set Ø 115,5 mm, 4 mm trapezoidal ring / 3,2 mm / 4,1 mm
Dimensions: 3 rings, Ø 115.5 mm, 4 mm (trapezoidal ring) / 3.2 mm / 4.1 mm.
€72,35 €59,79 €68,70 €56,78
 
GRANIT Flange rear hydraulic pump John Deere series 30-60
5%
GRANIT
Flange rear hydraulic pump John Deere series 30-60
€56,33 €46,55 €53,50 €44,21
 
GRANIT Valve hydraulic pump John Deere 830-8650
5%
GRANIT
Valve hydraulic pump John Deere 830-8650
€35,82 €29,60 €34,00 €28,10
 
GRANIT Bolt hydraulic pump drive shaft 3/8 inch John Deere 830-3650
GRANIT
Bolt hydraulic pump drive shaft 3/8 inch John Deere 830-3650
Drive shaft: 3/8".
€17,30 €14,30
 
Hydraulic pump 65 cm³/rpm. John Deere 4020-8640
5%
Hydraulic pump 65 cm³/rpm. John Deere 4020-8640
Output volume: 65 cc/rev.
€2.196,15 €1.815,00 €2.086,30 €1.724,21
 
GRANIT Bolt hood John Deere 940-8970
GRANIT
Bolt hood John Deere 940-8970
€1,54 €1,27
 
GRANIT Stop cable with detent A 2200 mm, B 2100 mm John Deere 840-4450
5%
GRANIT
Stop cable with detent A 2200 mm, B 2100 mm John Deere 840-4450
A: 2200 mm. B: 2100 mm.
€78,05 €64,50 €74,10 €61,24
 
Connecting rod bolt 63 mm John Deere
Connecting rod bolt 63 mm John Deere
Dimensions: 63 mm long.
€15,35 €12,69
 
GRANIT Piston set, complete Ø 116 mm, combustion chamber Ø 68,6 mm John Deere
10%
GRANIT
Piston set, complete Ø 116 mm, combustion chamber Ø 68,6 mm John Deere
Dimensions: 3 rings, Ø 116 mm, Gudgeon pin Ø 47.6 x 91.4 mm, Combustion chamber ...
€575,47 €475,60 €520,65 €430,29
 
GRANIT Cylinder head gasket engine 6076, 6466 John Deere
5%
GRANIT
Cylinder head gasket engine 6076, 6466 John Deere
€104,02 €85,97 €98,80 €81,65
 
Thrust bearing standard without thrust washer John Deere
Thrust bearing standard without thrust washer John Deere
Menke no.: 59710.
€31,25 €25,83
 
GRANIT Flange hydraulic pump John Deere series 40-50
5%
GRANIT
Flange hydraulic pump John Deere series 40-50
€54,27 €44,85 €51,55 €42,60
 
GRANIT Thrust washer 24,5 x 47 x 1 mm John Deere 2030-4630, 4040-4640
GRANIT
Thrust washer 24,5 x 47 x 1 mm John Deere 2030-4630, 4040-4640
Dimensions: 24.5 x 47 x 1 mm.
€1,95 €1,61
 
GRANIT Filter dryer airco Ø 102 mm, 190 mm, F/M #6 O-ring, steel
5%
GRANIT
Filter dryer airco Ø 102 mm, 190 mm, F/M #6 O-ring, steel
Length (mm): 190 | Outer Ø (mm): 102 | Connection thread: F/M #6 O-ring | Dimens...
€62,65 €51,78 €59,50 €49,17
 
GRANIT Nozzle John Deere Al 8225R, WTS 2066
GRANIT
Nozzle John Deere Al 8225R, WTS 2066
€16,45 €13,60
 
Showing 145 - 167 of 167

John Deere 4440 parts to keep a classic working

Keeping a John Deere 4440 in daily use often comes down to a stop cable that moves freely, injection nozzles with a clean spray pattern and wiring without a sticking relay. More than 170 replacement parts fit this model, made by GRANIT and by HELLA, GRAMMER, BOSCH and VICTOR REINZ.

Fuel system and engine

For the fuel side there are injection nozzles, a stop cable and a lockable tank cap with a vent. That vent gets overlooked. When it blocks, the tank goes into vacuum and after a while the engine starves of diesel. If your 4440 dies after an hour of work and restarts after a short wait, loosen the tank cap first and listen for air rushing in.

Around the engine you will find thermostats, gaskets such as the turbocharger oil return line gasket, and seals for parts like the rear engine cover. VICTOR REINZ gaskets and sealing rings round off an overhaul.

Injection nozzles are best replaced as a set. An engine that smokes black, starts poorly or runs rough often has a nozzle that dribbles instead of atomising. Always fit new copper washers under the nozzles, or compression blows past and the holder is leaking again within a week.

Lights, brakes and electrics

Anyone driving a 4440 on the road needs working headlights, brake lights and indicators. For that there are HELLA headlights with dipped and main beam, a brake light switch and a flasher unit. Also relays and a solenoid switch for the starter. On the brake side there is an O-ring for the master brake cylinder.

  • cab: air suspended tractor seats from GRAMMER
  • rear: drawbars finished in John Deere green
  • servicing: thermostats, gaskets and sealing rings

Getting the right John Deere 4440 parts first time

The serial plate tells you whether it really is a 4440. Within the John Deere line-up it sits in the 40 series. Where parts changed during production, the serial number on the plate helps you pick the right one. If the old part still carries a number, on an injection nozzle or a thermostat for example, compare it with the details shown with the product.

From the same 40 series, the John Deere 1640, John Deere 2040S, John Deere 3640, John Deere 4040 and John Deere 4240 each have a page with the parts that fit them. Handy if you keep several of these green classics side by side. All models from the brand are listed under John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart