Menu
EUR

John Deere 6010 tractor parts & technical data

Trailer couplings, lighting and electrics are just a few of the more than 450 parts listed for the John Deere 6010 from the 6010/6010SE series.

462 parts found for John Deere 6010
Show:
GRANIT Strainer oil- and fuel cooler John Deere
GRANIT
Strainer oil- and fuel cooler John Deere
€68,40 €56,53
 
GRANIT Thermostat Ø 54 mm, 85 °C John Deere
GRANIT
Thermostat Ø 54 mm, 85 °C John Deere
€37,50 €30,99
 
VICTOR REINZ Cylinder head gasket engine 4039D, 4039T, 4045, 4045T, 4239 John Deere
5%
VICTOR REINZ
Cylinder head gasket engine 4039D, 4039T, 4045, 4045T, 4239 John Deere
€72,24 €59,70 €68,60 €56,69
 
Arm for throttle linkage John Deere Series 30-8970, SE6010-SE6610
5%
Arm for throttle linkage John Deere Series 30-8970, SE6010-SE6610
€68,61 €56,70 €65,15 €53,84
 
GRANIT O-ring injection pump flange John Deere Series 11-7610, SE6010-SE6610
GRANIT
O-ring injection pump flange John Deere Series 11-7610, SE6010-SE6610
Description: For flange.
€7,85 €6,49
 
GRANIT Thermostat Ø 54 mm, 82 °C John Deere Series 5M-6930, SE6010-SE6920
GRANIT
Thermostat Ø 54 mm, 82 °C John Deere Series 5M-6930, SE6010-SE6920
Ø: 54 mm. Temperature: 82 °C.
€24,80 €20,50
 
GRANIT Radiator with frame John Deere 6010-6510S, SE6010-SE6410
5%
GRANIT
Radiator with frame John Deere 6010-6510S, SE6010-SE6410
To fit as: John Deere Series 6L: 6510L; Series 6000/6000SE: 6100–6400, SE6100–SE...
€776,22 €641,50 €737,40 €609,42
 
GRANIT Damper engine rubber John Deere Series 3000-6420S, SE6010-SE6420
5%
GRANIT
Damper engine rubber John Deere Series 3000-6420S, SE6010-SE6420
€39,64 €32,76 €37,65 €31,12
 
GRANIT Push rod 265 mm John Deere Series 5G-7610, SE6010-SE6920
GRANIT
Push rod 265 mm John Deere Series 5G-7610, SE6010-SE6920
Dimensions: Length 265 mm.
€15,50 €12,81
 
GRANIT Oil dipstick engine 267 mm, A 67,5 mm John Deere
5%
GRANIT
Oil dipstick engine 267 mm, A 67,5 mm John Deere
Length: 267 mm. A: 67,5 mm.
€49,74 €41,11 €47,25 €39,05
 
GRANIT O-ring cylinder head Ø 18,72 x 2,61 mm John Deere
GRANIT
O-ring cylinder head Ø 18,72 x 2,61 mm John Deere
Description: Ø 18.72 x 2.61 mm.
€2,71 €2,24
 
Seal kit feed pump John Deere
5%
Seal kit feed pump John Deere
€34,09 €28,17 €32,35 €26,74
 
Set of parts pre-separator John Deere
5%
Set of parts pre-separator John Deere
€43,02 €35,55 €40,85 €33,76
 
Cylinder head gasket set upper engine 4039D-4239 John Deere
5%
Cylinder head gasket set upper engine 4039D-4239 John Deere
€142,66 €117,90 €135,50 €111,98
 
Gasket set complete engine 4039, 4045, 4239 John Deere
5%
Gasket set complete engine 4039, 4045, 4239 John Deere
€235,74 €194,83 €223,95 €185,08
 
Exhaust gasket inner Ø 44 mm, hole spacing 76 mm John Deere
Exhaust gasket inner Ø 44 mm, hole spacing 76 mm John Deere
Dimensions: innen Ø 44 mm, Lochabstand 76 mm, Schrauben Ø 11 mm.
€18,00 €14,88
 
GRANIT Silencer horizontal John Deere Al 6100, Se 6010-SE6100
5%
GRANIT
Silencer horizontal John Deere Al 6100, Se 6010-SE6100
Menke no.: 59869.
€554,89 €458,59 €527,10 €435,62
 
Showing 337 - 360 of 462

John Deere 6010 parts

More than 450 replacement parts fit the John Deere 6010, from a small O-ring for the oil pump to a complete tractor seat. Here is how they break down across the tractor.

Engine, cooling and electrics

For the engine there are thermostats and thermostat housing gaskets, O-rings and seals for the oil circuit, hoses and bushes. The electrical side includes starter motors, alternators and micro relays.

A slow cranking starter is not always a starter problem. Check the battery and the earth cable first, because a new starter on a corroded earth will turn just as slowly. If you only hear a click, look at the relay and the supply before anything else.

Plates for the PTO and front axle

Internal plates for the PTO clutch and external plates for the front axle are on this page too. When the PTO slips under load or the front axle lock no longer holds, replace the complete pack rather than just the worst plates. Soak new plates in the specified oil for a while before fitting them, as dry plates can burn on first engagement.

Seats and hitching

  • tractor seats and seat cushions, partly from GRAMMER
  • drawbar balls and automatic drawbars
  • forced steering parts from Scharmüller and Walterscheid
  • further parts from HELLA and GRANIT

Whenever the thermostat comes out, fit a new housing gasket and scrape the mating faces clean. Old gasket residue causes leaks even with a fresh gasket. Bleed the cooling system carefully afterwards, because an air pocket at the thermostat makes it open late. A hose that feels soft or swollen is worth replacing at the same time, so you do not have to drain the coolant again shortly after.

Check the forced steering ball and its socket for play from time to time. A little grease prevents it from running dry and wearing unevenly. A worn drawbar ball shows itself through knocks when pulling away and braking.

Getting the right fit for your 6010

The 6010 also exists as the 6010SE, and the identification plate tells you which one you have. For clutch plates, compare the number on an old plate. Starters and alternators carry a label on the housing with a reference number to check against.

The same John Deere range includes these tractors, each with its own page:

For any other model, go to John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart