Menu
EUR

John Deere 1550 tractor parts & technical data

More than 550 parts fit the John Deere 1550. From lighting and electrics to trailer couplings, everything is gathered here so you can skip the long search.

555 parts found for John Deere 1550
Show:
GRAMMER Seat Compacto COMFORT W MSG93/721, air suspended, PVC, 482 mm
GRAMMER
Suspension: Air suspension. Upholstery type: PVC. Seat contact switch: Optional. Track gauge: 227 mm. Seat width: 482 mm. Fore/aft isolator: Yes. Rest... More
Suspension: Air suspension. Upholstery type: PVC. Seat contact switch:...
€1.364,09 €1.127,35 €1.295,85 €1.070,95
You save 5%
GRANIT Eye rear window lock with pin John Deere Series 40-2850
€183,99 €152,06 €174,75 €144,42
You save 5%
Torsie as 497 mm, Ø 25,4 mm John Deere series 20-50
Dimensions: Length = 497, Ø = 1", 25.4 mm. More
Dimensions: Length = 497, Ø = 1", 25.4 mm.
€127,29 €105,20 €120,90 €99,92
You save 5%
GRANIT Thrust washer 21,5 x 36,4 x 1 mm John Deere 840-2120, 1350-1950
GRANIT
Dimensions: 21.5 x 36.4 x 1 mm. More
Dimensions: 21.5 x 36.4 x 1 mm.
€1,54 €1,27
Shim lift arm shaft 21 x 25 x 5 mm John Deere 830-1850
Dimensions: 21 x 25 x 5 mm. More
Dimensions: 21 x 25 x 5 mm.
€2,50 €2,07
GRANIT Bush for lower link shaft 21,5 x 29,5 x 34 mm John Deere 830-1850
GRANIT
Dimensions: 21.5 x 29.5 x 34 mm. More
Dimensions: 21.5 x 29.5 x 34 mm.
€34,00 €28,10
Pin 19 x 92 mm John Deere
Dimensions: 19 x 92 mm. More
Dimensions: 19 x 92 mm.
€29,65 €24,50
GRANIT Bush for lower link strut 57 x 65,5 x 57 mm John Deere 820-2850
GRANIT
Dimensions: 57 x 65.5 x 57 mm. More
Dimensions: 57 x 65.5 x 57 mm.
€22,25 €18,39
GRANIT Threaded spindle left 7/8" thread, length 470 mm John Deere 820-2850
GRANIT
Dimensions: Length = 470, Ø = 7/8" mm. More
Dimensions: Length = 470, Ø = 7/8" mm.
€111,20 €91,90 €105,60 €87,27
You save 5%
Ball cat. 1, 46 x 35 mm John Deere 820-3350
Dimensions: Cat. 1, 46 x 35 mm. More
Dimensions: Cat. 1, 46 x 35 mm.
€22,00 €18,18
GRANIT Washer John Deere Series 50-3650
GRANIT Pin Ø 3/4 inch John Deere 820-3350
GRANIT
Dimensions: Ø = 3/4" mm. More
Dimensions: Ø = 3/4" mm.
€30,85 €25,50
GRANIT Base fender John Deere Series 6M-7980, SE6010-SE6920
€183,32 €151,50 €174,10 €143,88
You save 5%
Transmission-oil pump ball bearing John Deere 830-2135
€548,60 €453,39 €496,35 €410,21
You save 10%
Shim hood John Deere
GRANIT Warning buzzer dashboard alarm - parking brake
GRANIT
Version: Alarm - parking brake. More
Version: Alarm - parking brake.
€98,86 €81,70 €93,90 €77,60
You save 5%
HELLA Beacon H1 KL Rota Compact 12 V, 55 W, Ø 133 mm, 217 mm, push-on pin
HELLA
Nominal voltage: 12 V. Bulbs included: Yes. Light function: Rotating. Diameter: 133 mm. Total height: 217 mm. Connection: Socket pipe. Protection clas... More
Nominal voltage: 12 V. Bulbs included: Yes. Light function: Rotating. ...
€80,21 €66,29
GRANIT Housing right metal, also als plastic housing available
€56,45 €46,65 €53,60 €44,30
You save 5%
Showing 457 - 480 of 555

John Deere 1550 parts

More than 550 parts fit the John Deere 1550, enough to take care of a full service in one go, from the clutch to the headlights. Brands include GRANIT, HELLA, MAHLE, LUK and Wabco.

Clutch

For the clutch there are clutch plates with a torsion damper and single clutch pressure plates. Replace the plate and pressure plate together where you can. The tractor has to be split either way, and a new plate running against a worn pressure plate will not last. While it is apart, inspect the flywheel too: scoring or blue heat marks should be skimmed out before the new plate goes in.

Engine, cooling and electrics

  • Water pumps, plus seals for the lift pump and the coolant circuit
  • Exhaust gaskets and a lift housing gasket
  • O-rings, including one for the brake master cylinder
  • Starter motors and alternators
  • Left and right headlights

Coolant seeping from the weep hole on the water pump means the shaft seal has gone and the pump will not last much longer. Replace it as a unit and clean the gasket faces on the block thoroughly. Look over the belt and hoses at the same time, then refill with fresh coolant. Warm the engine up with the heater valve open and top up as the level drops. Headlights are available separately for left and right, so only the damaged side needs replacing.

Linkage, steering and air brakes

Lift arm bushes and washers take the play out of the rear linkage. On the steering side you can replace track rods and ball joints. Connector heads cover the air brake supply to a trailer, and gas struts hold the cab door or window where they should.

When changing a track rod, measure the old one first so the toe setting stays roughly where it was, then have the alignment checked, since wrong toe wears front tyres quickly.

Making sure it fits

First confirm on the data plate that the tractor is a 1550. Some parts are made for a group of John Deere models, such as a lift housing gasket that fits from the 820 up to the 3650 and a pressure plate for the 840 up to the 2650. The product details show this. Also compare the number on the old part, especially for the clutch, where the spline count and plate diameter have to match.

The 1550 is part of the 50 series. Two other tractors from that series have pages of their own:

For any other John Deere you look after, go to the overview of John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart