Menu
EUR

John Deere 6010 tractor parts & technical data

Trailer couplings, lighting and electrics are just a few of the more than 450 parts listed for the John Deere 6010 from the 6010/6010SE series.

462 parts found for John Deere 6010
Show:
GRANIT Pin for throttle linkage Ø 6 x 16 mm John Deere
€2,88 €2,38
Radiator hose to transmission Ø 22 mm John Deere
Inner Ø: 22 mm. Description: For transmission oil cooling. More
Inner Ø: 22 mm. Description: For transmission oil cooling.
€53,03 €43,83 €50,35 €41,61
You save 5%
GRANIT Vibration damper John Deere
GRANIT Hose upper, engine with two coolant thermostats John Deere 6010-6410
€63,60 €52,56 €60,40 €49,92
You save 5%
GRANIT Oil cooler 405 x 416 x 32 mm John Deere 6010-6410
€893,59 €738,50 €848,90 €701,57
You save 5%
MANN-FILTER Filter set engine oil-, fuel-, 2x air-, transmission filter
MANN-FILTER
To fit: John Deere. To fit type: Series 6010. Set consisting of: Engine oil filter, Main fuel filter, Air filter, Secondary element, Transmission oil ... More
To fit: John Deere. To fit type: Series 6010. Set consisting of: Engin...
€318,67 €263,36 €199,15 €164,59
You save 38%
VICTOR REINZ Seal kit upper John Deere Series 3010-6420S, SE6010-SE6420
€239,22 €197,70 €227,25 €187,81
You save 5%
Borg Warner Fan clutch John Deere Series 6005-6810, SE6010-SE6610
€385,92 €318,94 €338,75 €279,96
You save 12%
Shim rocker arm shaft Ø 20,65 x 29,46 x 0,5 mm John Deere
Dimensions: Ø 20.65 x 29.46 x 0.5 mm. More
Dimensions: Ø 20.65 x 29.46 x 0.5 mm.
€11,15 €9,21
Fuel hose of filter to fuel pump 1/2" UNF John Deere
Dimensions: Thread: 1/2" UNF mm. Description: From the filter to the injection pump. More
Dimensions: Thread: 1/2" UNF mm. Description: From the filter to the i...
€19,95 €16,49
Spacer cylinder liner Ø 120,8 x 125,3 x 0,10 mm John Deere
Ø: 120,8 x 125,3 x 0,10 mm. More
Ø: 120,8 x 125,3 x 0,10 mm.
€26,95 €22,27
Lever for throttle linkage John Deere Series 30-8970, SE6010-SE6610
GRANIT Sealing washer filler neck Ø 70 x 4,5 mm John Deere
GRANIT
Dimensions: Ø 70 x 4.5 mm. Description: For filler neck. More
Dimensions: Ø 70 x 4.5 mm. Description: For filler neck.
€12,90 €10,66
GRANIT Clamp exhaust John Deere
€39,10 €32,31 €37,10 €30,66
You save 5%
Ball bearing fan drive Ø 25,4 x 47,6 x 70 mm John Deere
Ø: 25,4 x 47,6 x 70 mm. Shaft length: 123,5 mm. Description: For fan drive. More
Ø: 25,4 x 47,6 x 70 mm. Shaft length: 123,5 mm. Description: For fan ...
€91,51 €75,63 €86,90 €71,82
You save 5%
GRANIT Tensioning pulley Ø 78 / 31 mm John Deere 5070M-5100M, 6010-6920
GRANIT
Outer Ø: 78 mm. Width: 31 mm. Menke no.: 221661. More
Outer Ø: 78 mm. Width: 31 mm. Menke no.: 221661.
€64,87 €53,61 €61,60 €50,91
You save 5%
GRANIT Radiator hose, bottom inner-Ø 60 / 52 mm John Deere
GRANIT
Inner Ø: 60 / 52 mm. More
Inner Ø: 60 / 52 mm.
€31,67 €26,17 €30,00 €24,79
You save 5%
Thermostat Ø 54 mm, 78 °C John Deere Series 5M-7405, SE6010-SE6920
Ø: 54 mm. Temperature: 78 °C. More
Ø: 54 mm. Temperature: 78 °C.
€34,55 €28,55
Showing 241 - 264 of 462

John Deere 6010 parts

More than 450 replacement parts fit the John Deere 6010, from a small O-ring for the oil pump to a complete tractor seat. Here is how they break down across the tractor.

Engine, cooling and electrics

For the engine there are thermostats and thermostat housing gaskets, O-rings and seals for the oil circuit, hoses and bushes. The electrical side includes starter motors, alternators and micro relays.

A slow cranking starter is not always a starter problem. Check the battery and the earth cable first, because a new starter on a corroded earth will turn just as slowly. If you only hear a click, look at the relay and the supply before anything else.

Plates for the PTO and front axle

Internal plates for the PTO clutch and external plates for the front axle are on this page too. When the PTO slips under load or the front axle lock no longer holds, replace the complete pack rather than just the worst plates. Soak new plates in the specified oil for a while before fitting them, as dry plates can burn on first engagement.

Seats and hitching

  • tractor seats and seat cushions, partly from GRAMMER
  • drawbar balls and automatic drawbars
  • forced steering parts from Scharmüller and Walterscheid
  • further parts from HELLA and GRANIT

Whenever the thermostat comes out, fit a new housing gasket and scrape the mating faces clean. Old gasket residue causes leaks even with a fresh gasket. Bleed the cooling system carefully afterwards, because an air pocket at the thermostat makes it open late. A hose that feels soft or swollen is worth replacing at the same time, so you do not have to drain the coolant again shortly after.

Check the forced steering ball and its socket for play from time to time. A little grease prevents it from running dry and wearing unevenly. A worn drawbar ball shows itself through knocks when pulling away and braking.

Getting the right fit for your 6010

The 6010 also exists as the 6010SE, and the identification plate tells you which one you have. For clutch plates, compare the number on an old plate. Starters and alternators carry a label on the housing with a reference number to check against.

The same John Deere range includes these tractors, each with its own page:

For any other model, go to John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart