Menu
EUR

John Deere 8530 tractor parts & technical data

On this page you will find more than 200 parts for the John Deere 8530. Trailer couplings, lighting and electrics are sorted by product group for you.

230 parts found for John Deere 8530
Show:
GRANIT Cylinder head gasket John Deere 8245R-8360R, 8320RT-8360RT
€105,85 €87,48 €100,55 €83,10
You save 5%
GRANIT Valve hydraulic pump John Deere 830-8650
€35,82 €29,60 €34,00 €28,10
You save 5%
GRANIT As for for- and rear window John Deere SE6100-6930 PR
€48,64 €40,20 €46,20 €38,18
You save 5%
Sleeve John Deere 7200R-8530
GRANIT Sensor air temperature
GRANIT
Version: For air temperature. More
Version: For air temperature.
€46,11 €38,11 €43,80 €36,20
You save 5%
GRANIT Rail pressure sensor pressure control valve fuel injectors rail
GRANIT
Version: Pressure control valve - fuel (common rail). More
Version: Pressure control valve - fuel (common rail).
€157,66 €130,30 €149,75 €123,76
You save 5%
Wabco Trailer control valve 8 bar, M22 x 1,5, screw distance 117 x 117 mm
€814,45 €673,10 €736,85 €608,97
You save 10%
Sauermann Cast lid Ø 8,2 mm John Deere
€195,17 €161,30 €185,40 €153,22
You save 5%
Torsion damper pulley Ø 280 x 48 mm, width 88 mm, John Deere
Outer Ø (mm): 280 | Width (mm): 88 | Inner Ø (mm): 48 More
Outer Ø (mm): 280 | Width (mm): 88 | Inner Ø (mm): 48
€935,68 €773,29 €846,55 €699,63
You save 10%
Torsion damper pulley Ø 270 x 76 mm, width 36 mm, John Deere
Reference no.: RE57604 | Inner Ø (mm): 76 | Outer Ø (mm): 270 | Width (mm): 36 More
Reference no.: RE57604 | Inner Ø (mm): 76 | Outer Ø (mm): 270 | Widt...
€952,22 €786,96 €904,60 €747,60
You save 5%
GRANIT Internal plate Hi-Lo 3 mm, inner 138 mm, outer 230 mm, 66 teeth
GRANIT
Version: Inner: 138 mm Outer: 230 mm | Teeth: 66 | Thickness (mm): 3 More
Version: Inner: 138 mm Outer: 230 mm | Teeth: 66 | Thickness (mm): 3
€102,50 €84,71 €97,35 €80,45
You save 5%
GRANIT Expansion valve 3/8 inch o-ring John Deere 6010 - 9620RX
GRANIT
Equipment: O-ring | Connection thread E: # 6, 3/8"" O-ring | Connection thread A: - More
Equipment: O-ring | Connection thread E: # 6, 3/8"" O-ring | Connectio...
€64,61 €53,40 €61,35 €50,70
You save 5%
GRANIT PTO shaft end piece 244,5 mm, 1 3/4" 20 splines, 33 teeth John Deere
GRANIT
Version: 540 rpm, length 244,5 mm, 1 3/4", 20 splines, 33 teeth, Ø 51,5 mm. Reference no.: R562721. More
Version: 540 rpm, length 244,5 mm, 1 3/4", 20 splines, 33 teeth, Ø 51...
€278,98 €230,56 €265,00 €219,01
You save 5%
Tensioning pulley Ø 75 mm, width 40 mm John Deere
€79,88 €66,02 €75,85 €62,69
You save 5%
GRANIT Seal thermostat John Deere
€21,35 €17,64
GRANIT Injector John Deere 8130-8530
€674,27 €557,25 €640,55 €529,38
You save 5%
V-belt tensioner Ø 75 mm, 40 mm wide, 24,5 Nm John Deere
€261,59 €216,19 €248,50 €205,37
You save 5%
GRANIT Seal kit upper John Deere
€233,80 €193,22
Showing 193 - 216 of 230

John Deere 8530 parts for hitching, braking and the engine bay

The 8530 is the big one of the 8030 family, and it spends its days in front of the heaviest trailers and cultivators on the farm. More than 200 parts on this page fit it, supplied by GRANIT, Scharmüller, Sauermann, Rockinger, Walterscheid and others.

Hitch and drawbar

At the rear you can replace drawbars with a ball, drawbar frames and adapter plates. For trailers with a steered axle there are forced steering components, such as an insert that converts a ball hitch to a K50 connection. Fit depends on the rail width and pin diameter of the linkage already on your tractor, so measure before you order.

Air brakes on the trailer

Connector heads and trailer control valves cover the air brake side. If you hear a hiss when coupling up, the rubber seal inside the connector head is a more likely culprit than the line itself. Keep the heads clean and close the dust cover whenever no trailer is attached, since grit and moisture wear that seal quickly. When replacing a head, check the colour: red is for the supply line.

Engine, air conditioning and electrics

  • Sensors, including an engine oil pressure sender and temperature sensors.
  • Seals, sealing rings and O-rings, among them one for the EGR valve.
  • Gear reduction starters for an engine that cranks slowly or not at all.
  • An air conditioning compressor with pulley.
  • LED work lights and beacons for long days and nights.

If you are fitting a new aircon compressor because the old one seized, flush the system and fit a new receiver drier. Otherwise metal debris left in the lines will go straight through the replacement.

At busy times an 8530 often keeps going well after dark. LED work lights give plenty of light while drawing little current, which takes load off the alternator when the air conditioning and beacons are running as well. When swapping old halogen lamps for LED, check that the mounting and plug match, and aim the lamps so they do not dazzle oncoming traffic. A beacon makes the tractor easier to spot when you move wide equipment on the road.

Confirming the fit

Start with the data plate to be certain the tractor is an 8530. For sensors, seals and starters, compare the number on the part you removed with the details listed with each product.

The smaller models in the same range each have their own page with parts matched to that tractor:

Every other tractor from the brand is reachable through the John Deere parts overview.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart