Menu
EUR

John Deere 8530 tractor parts & technical data

On this page you will find more than 200 parts for the John Deere 8530. Trailer couplings, lighting and electrics are sorted by product group for you.

230 parts found for John Deere 8530
Show:
GRANIT Cylinder head gasket John Deere 8245R-8360R, 8320RT-8360RT
5%
GRANIT
Cylinder head gasket John Deere 8245R-8360R, 8320RT-8360RT
€105,85 €87,48 €100,55 €83,10
 
GRANIT Valve hydraulic pump John Deere 830-8650
5%
GRANIT
Valve hydraulic pump John Deere 830-8650
€35,82 €29,60 €34,00 €28,10
 
GRANIT As for for- and rear window John Deere SE6100-6930 PR
5%
GRANIT
As for for- and rear window John Deere SE6100-6930 PR
€48,64 €40,20 €46,20 €38,18
 
Sleeve John Deere 7200R-8530
Sleeve John Deere 7200R-8530
€35,20 €29,09
 
Thrust washer John Deere 7200R-8530
Thrust washer John Deere 7200R-8530
€18,60 €15,37
 
GRANIT Sensor air temperature
5%
GRANIT
Sensor air temperature
Version: For air temperature.
€46,11 €38,11 €43,80 €36,20
 
GRANIT Rail pressure sensor pressure control valve fuel injectors rail
5%
GRANIT
Rail pressure sensor pressure control valve fuel injectors rail
Version: Pressure control valve - fuel (common rail).
€157,66 €130,30 €149,75 €123,76
 
Wabco Trailer control valve 8 bar, M22 x 1,5, screw distance 117 x 117 mm
10%
Wabco
Trailer control valve 8 bar, M22 x 1,5, screw distance 117 x 117 mm
€814,45 €673,10 €736,85 €608,97
 
Sauermann Cast lid Ø 8,2 mm John Deere
5%
Sauermann
Cast lid Ø 8,2 mm John Deere
€195,17 €161,30 €185,40 €153,22
 
Torsion damper pulley Ø 280 x 48 mm, width 88 mm, John Deere
10%
Torsion damper pulley Ø 280 x 48 mm, width 88 mm, John Deere
Outer Ø (mm): 280 | Width (mm): 88 | Inner Ø (mm): 48
€935,68 €773,29 €846,55 €699,63
 
Torsion damper pulley Ø 270 x 76 mm, width 36 mm, John Deere
5%
Torsion damper pulley Ø 270 x 76 mm, width 36 mm, John Deere
Reference no.: RE57604 | Inner Ø (mm): 76 | Outer Ø (mm): 270 | Width (mm): 36
€952,22 €786,96 €904,60 €747,60
 
GRANIT Internal plate Hi-Lo 3 mm, inner 138 mm, outer 230 mm, 66 teeth
5%
GRANIT
Internal plate Hi-Lo 3 mm, inner 138 mm, outer 230 mm, 66 teeth
Version: Inner: 138 mm Outer: 230 mm | Teeth: 66 | Thickness (mm): 3
€102,50 €84,71 €97,35 €80,45
 
GRANIT Expansion valve 3/8 inch o-ring John Deere 6010 - 9620RX
5%
GRANIT
Expansion valve 3/8 inch o-ring John Deere 6010 - 9620RX
Equipment: O-ring | Connection thread E: # 6, 3/8"" O-ring | Connection thread A...
€64,61 €53,40 €61,35 €50,70
 
GRANIT PTO shaft end piece 244,5 mm, 1 3/4" 20 splines, 33 teeth John Deere
5%
GRANIT
PTO shaft end piece 244,5 mm, 1 3/4" 20 splines, 33 teeth John Deere
Version: 540 rpm, length 244,5 mm, 1 3/4", 20 splines, 33 teeth, Ø 51,5 mm. Refe...
€278,98 €230,56 €265,00 €219,01
 
Tensioning pulley Ø 75 mm, width 40 mm John Deere
5%
Tensioning pulley Ø 75 mm, width 40 mm John Deere
€79,88 €66,02 €75,85 €62,69
 
GRANIT Seal thermostat John Deere
GRANIT
Seal thermostat John Deere
€21,35 €17,64
 
GRANIT Injector John Deere 8130-8530
5%
GRANIT
Injector John Deere 8130-8530
€674,27 €557,25 €640,55 €529,38
 
V-belt tensioner Ø 75 mm, 40 mm wide, 24,5 Nm John Deere
5%
V-belt tensioner Ø 75 mm, 40 mm wide, 24,5 Nm John Deere
€261,59 €216,19 €248,50 €205,37
 
GRANIT Seal kit upper John Deere
GRANIT
Seal kit upper John Deere
€233,80 €193,22
 
Showing 193 - 216 of 230

John Deere 8530 parts for hitching, braking and the engine bay

The 8530 is the big one of the 8030 family, and it spends its days in front of the heaviest trailers and cultivators on the farm. More than 200 parts on this page fit it, supplied by GRANIT, Scharmüller, Sauermann, Rockinger, Walterscheid and others.

Hitch and drawbar

At the rear you can replace drawbars with a ball, drawbar frames and adapter plates. For trailers with a steered axle there are forced steering components, such as an insert that converts a ball hitch to a K50 connection. Fit depends on the rail width and pin diameter of the linkage already on your tractor, so measure before you order.

Air brakes on the trailer

Connector heads and trailer control valves cover the air brake side. If you hear a hiss when coupling up, the rubber seal inside the connector head is a more likely culprit than the line itself. Keep the heads clean and close the dust cover whenever no trailer is attached, since grit and moisture wear that seal quickly. When replacing a head, check the colour: red is for the supply line.

Engine, air conditioning and electrics

  • Sensors, including an engine oil pressure sender and temperature sensors.
  • Seals, sealing rings and O-rings, among them one for the EGR valve.
  • Gear reduction starters for an engine that cranks slowly or not at all.
  • An air conditioning compressor with pulley.
  • LED work lights and beacons for long days and nights.

If you are fitting a new aircon compressor because the old one seized, flush the system and fit a new receiver drier. Otherwise metal debris left in the lines will go straight through the replacement.

At busy times an 8530 often keeps going well after dark. LED work lights give plenty of light while drawing little current, which takes load off the alternator when the air conditioning and beacons are running as well. When swapping old halogen lamps for LED, check that the mounting and plug match, and aim the lamps so they do not dazzle oncoming traffic. A beacon makes the tractor easier to spot when you move wide equipment on the road.

Confirming the fit

Start with the data plate to be certain the tractor is an 8530. For sensors, seals and starters, compare the number on the part you removed with the details listed with each product.

The smaller models in the same range each have their own page with parts matched to that tractor:

Every other tractor from the brand is reachable through the John Deere parts overview.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart