Menu
EUR

Deutz-Fahr 5100 C tractor parts & technical data

Need a seat, a light or a trailer coupling for the Deutz-Fahr 5100 C? This page lists more than 40 parts that fit this model, sorted into clear groups.

43 parts found for Deutz-Fahr 5100 C
Show:
Fender bracket left complete SAME, Hürlimann, Deutz-Fahr, Lamborghini
GRAMMER Seat MSG95G/721 air suspended 12 V, seat width 480 mm
GRAMMER
Fore/aft isolator: Optional | Upholstery type: Fabric | Height (mm): 685 → 745 | Joystick console: Optional | On-board voltage (V): 12 | Restraint s... More
Fore/aft isolator: Optional | Upholstery type: Fabric | Height (mm): 6...
€2.181,17 €1.802,62
GRAMMER Seat contact switches IHC, New Holland, Deutz 125 mm, 4-pin
GRAMMER
Sitzoberteil: 721, 722, 731, 741 | Seat contact switch CASE / NEW HOLLAND / DEUTZ version Cable length 125 mm with 4-pin AMP connector plug Make conta... More
Sitzoberteil: 721, 722, 731, 741 | Seat contact switch CASE / NEW HOLL...
€106,34 €87,88 €97,83 €80,85
You save 8%
Pressure sensor intake air engine TCD3.6L04
Description: For intake air. More
Description: For intake air.
€88,01 €72,74 €80,97 €66,92
You save 8%
Fender bracket right complete
€376,68 €311,31 €346,55 €286,40
You save 8%
Clutch slave cylinder mineral oil Agrofarm, Agrolux, Agroplus
€116,00 €95,87 €106,72 €88,20
You save 8%
LED headlight dipped beam 12 / 24 V, 84 x 89 x 92 mm, HB3/9005
Current (A): [email protected] [email protected] | Voltage range (V): 10 - 30 | Light function: Dipped beam | EMC: CISPR 25 class 3 | Housing material: Aluminium | Bu... More
Current (A): [email protected] [email protected] | Voltage range (V): 10 - 30 | Light ...
€90,15 €74,50 €82,94 €68,54
You save 8%
HELLA Indicator rear left / right 12V21WK / P21W, yellow, round, 12 V
HELLA
Bulb: 12V21WK / P21W, Silver bulb 8GA 002073121. Colour: Lens: yellow, grey. Attachment: Rear. Connection: AMP plug connection. Form: Round. Thread: M... More
Bulb: 12V21WK / P21W, Silver bulb 8GA 002073121. Colour: Lens: yellow,...
€43,56 €36,00 €41,95 €34,67
You save 4%
Headlight 12 V, H4, R2, W5W, Ø 139 mm, vertical
Bulb: H4, R2, W5W | Dimensions W x H x D (mm): Ø139/131x75 | Protection class: IP66 | Light function: Dipped beam, full beam, position light | Mounti... More
Bulb: H4, R2, W5W | Dimensions W x H x D (mm): Ø139/131x75 | Protecti...
€98,49 €81,40 €90,61 €74,89
You save 8%
Bosch/Rexroth Hydraulic pump 16 cm³ anticlockwise, spline-as B 17 x 14, 9 splines
Bosch/Rexroth
Min. speed (1/min.): 500 | Adaptor plate hole pattern (mm): 60 x 60 (2 x) | Drive shaft: Splined shaft 17 x 14 9 splines | Capacity Q (cc/rev): 16 | F... More
Min. speed (1/min.): 500 | Adaptor plate hole pattern (mm): 60 x 60 (2...
€551,52 €455,80 €507,40 €419,34
You save 8%
GRAMMER Tractor seat Maximo Professional air suspended 530 mm
GRAMMER
Track gauge (mm): 260 | Rückenverlängerung: Yes | Lordosenstütze: Mechanical | Seat contact switch: Yes | Upholstery type: Fabric | Armrest: Yes | ... More
Track gauge (mm): 260 | Rückenverlängerung: Yes | Lordosenstütze: M...
€3.612,71 €2.985,71
Sauermann Cover trailer coupling Ø 16,2 mm HS 1700-1KUD / 3KUD 390 mm
Sauermann
Description: SDF Ø 16.2 mm More
Description: SDF Ø 16.2 mm
€55,93 €46,22 €51,46 €42,53
You save 8%
MAHLE Alternator 14 V, 120 A, flange 56 mm, fan, W-connection
MAHLE
Nominal voltage (V): 14 | Mounting hole Ø / R (mm): 10,2 / 90,0 | Direction of rotation: ↻ | Flange size (mm): 56,0 | Belt width (mm) / type: - | A... More
Nominal voltage (V): 14 | Mounting hole Ø / R (mm): 10,2 / 90,0 | Dir...
€549,52 €454,15 €329,14 €272,01
You save 40%
Sauermann Drawbar 38 mm, 330 / 25 / 32 mm, 2500 kg, 97,1 kN
Sauermann
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecting pin: 38 mm. Load capacity: 2500 kg. D-value: 97,1 kN. Colour: Black. Referenc... More
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecti...
€1.018,93 €842,09 €937,42 €774,72
You save 8%
Fan clutch with cooling fan
€529,49 €437,60 €487,13 €402,59
You save 8%
Spring fender left SAME, Hürlimann, Deutz-Fahr, Lamborghini
€89,14 €73,67 €82,01 €67,78
You save 8%
Sauermann Drawbar inner part 330 mm, coupling pin 31 mm, 2500 kg
Sauermann
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecting pin: 32 mm. Load capacity: 2500 kg. D-value: 97,1 kN. Colour: Black. Version:... More
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecti...
€809,65 €669,13 €744,88 €615,60
You save 8%
HELLA LED tail light Ø 112,3 x 38,9 mm, red, Amp, 12 V
HELLA
Nominal voltage: 12 V. Installation location: Left/right. Bulb: LED. Bulbs included: Yes. Light function: Rear light, brake light. Colour: Red. Connec... More
Nominal voltage: 12 V. Installation location: Left/right. Bulb: LED. B...
€97,85 €80,87 €94,24 €77,88
You save 4%
HELLA LED tail light Ø 112,3 x 38,9 mm, clear white, Amp, 12 V
HELLA
Nominal voltage: 12 V. Installation location: Left/right. Bulb: LED. Bulbs included: Yes. Light function: Rear light, brake light. Colour: Lens: trans... More
Nominal voltage: 12 V. Installation location: Left/right. Bulb: LED. B...
€97,85 €80,87 €94,24 €77,88
You save 4%
Sauermann Drawbar deep jaw 38 mm, 330 / 25 / 32 mm, 2000 kg, 97,1 kN
Sauermann
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecting pin: 38 mm. Load capacity: 2000 kg. D-value: 97,1 kN. Colour: Black. Drawbar ... More
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Connecti...
€997,77 €824,60 €917,95 €758,64
You save 8%
Sensor kit rail pressure Hürlimann, Deutz-Fahr, Lamborghini
Version: Rail pressure. More
Version: Rail pressure.
€328,97 €271,88 €302,65 €250,13
You save 8%
Water pump Nitro 90-130, Virtus 90-130, XM 90-130
€557,29 €460,57 €512,71 €423,72
You save 8%
Tank cap for expansion tank
Version: For expansion tank. More
Version: For expansion tank.
€33,84 €27,97 €31,13 €25,73
You save 8%
Cylinder head bolt M12 x 134 mm engine TCD2012L04 4V-TCD3.6 L04
Engine types: TCD2012L04 4V, TCD2012L06 4V, TCD3.6 L04. Dimensions: M12 x 134 mm. More
Engine types: TCD2012L04 4V, TCD2012L06 4V, TCD3.6 L04. Dimensions: M1...
€24,86 €20,55
Fuel pressure sensor engines TCD4.1L4, TCD6.1L6, TTCD6.1L6, TTCD7.8L06
Dayco V-belt tensioner engine cooling series 5 5100-5130
€339,48 €280,56 €312,32 €258,12
You save 8%
Gasket EGR-line engine TCD3.6L04
Description: For EGR line. More
Description: For EGR line.
€6,54 €5,40
EGR valve Deutz series 5, 5 C, 5 TTV 5090-5130
€691,41 €571,41 €636,10 €525,70
You save 8%
Feed pump Deutz-Fahr series 5, 6 Agrotron, Hürlimann XM, Same Virtus
€269,83 €223,00 €248,24 €205,16
You save 8%
Injector Deutz-Fahr, Hürlimann, Lamborghini, Same
€647,73 €535,31 €595,91 €492,49
You save 8%
Oil seal crankshaft rear 105 x 125 x 13 mm
Outer Ø: 125 mm. Width: 13 mm. Inner Ø: 105 mm. More
Outer Ø: 125 mm. Width: 13 mm. Inner Ø: 105 mm.
€58,35 €48,22 €53,68 €44,37
You save 8%
Spring fender right SAME, Hürlimann, Deutz-Fahr, Lamborghini
€89,02 €73,57 €81,90 €67,68
You save 8%
Cylinder Deutz-Fahr, Hürlimann, Lamborghini
€257,50 €212,81 €236,90 €195,79
You save 8%
Dayco V-belt tensioner engine cooling
€230,52 €190,51 €212,08 €175,27
You save 8%

Deutz-Fahr 5100 C parts for the turbo, charge air and cooling

If a 5100 C has lost pulling power or whistles as it accelerates, the air side of the engine is the obvious place to start. This page carries a remanufactured turbocharger, air hoses to the intercooler, radiator hoses and a V-belt tensioner. In total there are more than 40 parts for this tractor, made by GRANIT, Sauermann, HELLA, GRAMMER and Dayco.

Replacing a turbocharger properly

Turbos rarely fail for no reason. Oil starvation or dirty intake air is usually behind it. Change the engine oil and filter before the new unit runs for the first time, and make sure the oil feed pipe is clear. Prime the turbo with clean oil before fitting it, then let the engine idle for a while after starting. Inspect the intercooler hoses at the same time. A split hose or an oily film inside points to a leak that will otherwise stay with you.

Fuel system and engine block

Feed pumps, a fuel pressure sensor and a rail pressure sensor kit cover the fuel side. For the block there is a cylinder, a cylinder head bolt and an oil seal. Press a new oil seal in squarely using a suitable drift, because a seal that sits at an angle will soon weep.

A fuel pressure sensor sending false readings can leave you with hard starting or an engine in limp mode. Check the plug for corrosion and the lead for chafing before replacing the sensor itself. Work on the fuel side with clean hands and clean tools, and cap open connections at once.

Exterior and hitch

Fender brackets with springs, LED tail lights and rear indicators look after the outside, and a drawbar inner part is available for the hitch.

A V-belt tensioner that rattles or jerks lets the belt slip and squeal. Replace it as soon as the roller has play or feels rough, and inspect the belt for fine cracks and glazed flanks while you are there.

Identifying the correct part

The type plate shows the tractor as a 5100 C from Series 5 C. A turbocharger nearly always has a tag or stamped number on its housing. Compare it with the reference number listed with the product, and do the same for sensors and the cylinder. For hoses, hold the old one next to the product photo and compare the shape and connections.

Each Deutz-Fahr model has its own page showing only the parts for that tractor. For the rest of the brand, start from the Deutz-Fahr overview and work down by series.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison
This product has been added to your cart