Menu
EUR

John Deere 1550 tractor parts & technical data

More than 550 parts fit the John Deere 1550. From lighting and electrics to trailer couplings, everything is gathered here so you can skip the long search.

555 parts found for John Deere 1550
Show:
GRANIT Radiator John Deere 1350-1750
GRANIT
To fit as: John Deere Series 50: 1350, 1550, 1750 More
To fit as: John Deere Series 50: 1350, 1550, 1750
€597,15 €493,51 €567,25 €468,80
You save 5%
GRANIT Radiator hose, top inner-Ø 37 mm John Deere 840-1140, 1350-1850
€12,20 €10,08
GRANIT Repair set water pump John Deere 1350-2850, 5500
€142,73 €117,96 €135,55 €112,02
You save 5%
Sealing ring John Deere
Intake gasket John Deere
GRANIT Cylinder head gasket multi-layer steel gasket John Deere
GRANIT
Reference no.: 0011460471. Version: The cylinder head gasket is a multi-layer steel gasket.. Assembly notes: Tightening instructions for cylinder head... More
Reference no.: 0011460471. Version: The cylinder head gasket is a mult...
€55,41 €45,79 €52,60 €43,47
You save 5%
GRANIT Tube vertical enamelled 500 mm, inner-Ø 48 mm, exhaust Ø 47 mm
GRANIT
Version: Length: 500 mm, Inner Ø: 48 mm, Outlet Ø: 47 mm. Outer Ø: 47 mm. Inner Ø: 48 mm. Length: 500 mm. More
Version: Length: 500 mm, Inner Ø: 48 mm, Outlet Ø: 47 mm. Outer Ø: ...
€40,04 €33,09 €38,00 €31,41
You save 5%
GRANIT Flange rear hydraulic pump John Deere series 30-60
€56,33 €46,55 €53,50 €44,21
You save 5%
GRANIT Valve hydraulic pump John Deere 830-8650
€35,82 €29,60 €34,00 €28,10
You save 5%
GRANIT Gas strut hood 200 N, 285 mm, stroke 100 mm John Deere
GRANIT
suitable for: Motorhaube. Newtons: 200. A: 285 mm. B: 135 mm. C: 8 mm. D: 8 mm. Form: 1. d1: 8 mm. d2: 18 mm. Stroke: 100 mm. To fit: Bonnet. More
suitable for: Motorhaube. Newtons: 200. A: 285 mm. B: 135 mm. C: 8 mm....
€33,90 €28,02
Lift arm shaft 510 mm, Ø 1 1/8 inch, 28 mm John Deere 1350-2850
Dimensions: Length = 510, Ø = 1 1/8", 28 mm. Menke no.: 73807. More
Dimensions: Length = 510, Ø = 1 1/8", 28 mm. Menke no.: 73807.
€164,32 €135,80 €156,10 €129,01
You save 5%
GRANIT Sealing ring 28 x 39 x 6,5 mm John Deere 1350-3650
GRANIT
Dimensions: 28 x 39 x 6.5 mm. More
Dimensions: 28 x 39 x 6.5 mm.
€12,75 €10,54
Seal filler cap 34 x 50 x 3 mm John Deere
Dimensions: 34 x 50 x 3 mm. More
Dimensions: 34 x 50 x 3 mm.
€9,85 €8,14
GRANIT Seal set piston 82,5 mm, 75 x 81 x 8 mm John Deere 830-1850
GRANIT
Dimensions: 75 x 81 x 8 mm. More
Dimensions: 75 x 81 x 8 mm.
€21,30 €17,60
Yoke 300 mm, yoke inner 18 mm, bore 20 x 42 mm John Deere
Dimensions: Length = 300, Clevis inside = 18, Clevis outside = 42, Bore = 20 x 42 mm. More
Dimensions: Length = 300, Clevis inside = 18, Clevis outside = 42, Bor...
€92,81 €76,70 €88,15 €72,85
You save 5%
GRANIT Mirror 404 x 216 mm, unheated, rod-Ø 16 - 28 mm John Deere, JCB
GRANIT
Dimensions: 404 x 216 mm. Width: 216 mm. Height: 404 mm. Version: Unheated. Rod Ø: 16 - 28 mm. More
Dimensions: 404 x 216 mm. Width: 216 mm. Height: 404 mm. Version: Unhe...
€71,87 €59,40 €68,25 €56,41
You save 5%
Showing 505 - 528 of 555

John Deere 1550 parts

More than 550 parts fit the John Deere 1550, enough to take care of a full service in one go, from the clutch to the headlights. Brands include GRANIT, HELLA, MAHLE, LUK and Wabco.

Clutch

For the clutch there are clutch plates with a torsion damper and single clutch pressure plates. Replace the plate and pressure plate together where you can. The tractor has to be split either way, and a new plate running against a worn pressure plate will not last. While it is apart, inspect the flywheel too: scoring or blue heat marks should be skimmed out before the new plate goes in.

Engine, cooling and electrics

  • Water pumps, plus seals for the lift pump and the coolant circuit
  • Exhaust gaskets and a lift housing gasket
  • O-rings, including one for the brake master cylinder
  • Starter motors and alternators
  • Left and right headlights

Coolant seeping from the weep hole on the water pump means the shaft seal has gone and the pump will not last much longer. Replace it as a unit and clean the gasket faces on the block thoroughly. Look over the belt and hoses at the same time, then refill with fresh coolant. Warm the engine up with the heater valve open and top up as the level drops. Headlights are available separately for left and right, so only the damaged side needs replacing.

Linkage, steering and air brakes

Lift arm bushes and washers take the play out of the rear linkage. On the steering side you can replace track rods and ball joints. Connector heads cover the air brake supply to a trailer, and gas struts hold the cab door or window where they should.

When changing a track rod, measure the old one first so the toe setting stays roughly where it was, then have the alignment checked, since wrong toe wears front tyres quickly.

Making sure it fits

First confirm on the data plate that the tractor is a 1550. Some parts are made for a group of John Deere models, such as a lift housing gasket that fits from the 820 up to the 3650 and a pressure plate for the 840 up to the 2650. The product details show this. Also compare the number on the old part, especially for the clutch, where the spline count and plate diameter have to match.

The 1550 is part of the 50 series. Two other tractors from that series have pages of their own:

For any other John Deere you look after, go to the overview of John Deere parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart