Menu
EUR

Deutz-Fahr Agroplus 95 tractor parts & technical data

Does it fit the Deutz-Fahr Agroplus 95? For the more than 170 parts on this page that question is settled, from trailer couplings to lighting and electrics.

172 parts found for Deutz-Fahr Agroplus 95
Show:
Internal plate powershift 2,5 mm, 80,1 mm, 129,3 mm, 32 teeth
Version: Thickness: 2.5 mm Inner: 80.1 mm Outer: 129.3 mm 32 teeth More
Version: Thickness: 2.5 mm Inner: 80.1 mm Outer: 129.3 mm 32 teeth
€24,00 €19,83
Bosch/Rexroth Hydraulic pump 16 cm³ anticlockwise, spline-as B 17 x 14, 9 splines
Bosch/Rexroth
Min. speed (1/min.): 500 | Adaptor plate hole pattern (mm): 60 x 60 (2 x) | Drive shaft: Splined shaft 17 x 14 9 splines | Capacity Q (cc/rev): 16 | F... More
Min. speed (1/min.): 500 | Adaptor plate hole pattern (mm): 60 x 60 (2...
€528,53 €436,80 €502,10 €414,96
You save 5%
Track rod A 1250 mm, E 32 mm
A: 1250 mm. E: 32 mm. More
A: 1250 mm. E: 32 mm.
€403,14 €333,17 €382,95 €316,49
You save 5%
GRANIT Hand brake cable SAME, Hürlimann, Deutz-Fahr, Lamborghini
€96,56 €79,80 €91,70 €75,79
You save 5%
GRANIT Oil drain valve M18 x 1,5
GRANIT
Thread: M18 x 1.5. More
Thread: M18 x 1.5.
€65,32 €53,98 €62,00 €51,24
You save 5%
GRANIT Stud bolt exhaust M8 / M10, 72 mm Deutz-Fahr
GRANIT
Version: Thread M8, M10, Length: 72 mm. Thread: M8 / M10. Length: 72 mm. More
Version: Thread M8, M10, Length: 72 mm. Thread: M8 / M10. Length: 72 m...
€23,25 €19,21
ROCKINGER Drawbar K80 rail width 330 mm, locking pin Ø 25 mm
ROCKINGER
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Load capacity: 4000 kg. D-value: 102 kN. Description: Manual ball hitch with height-adju... More
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 32 mm. Load cap...
€1.231,99 €1.018,17 €990,51 €818,60
You save 20%
Push button switch PTO shaft 48 V link voltage, button yellow, Ø 30 mm
Version: 48 V switching voltage, Yellow button, make contact, Total button travel: 5 mm, Ø 30 mm, plug connection (AMP Superseal 3 x 1.5), dustproof ... More
Version: 48 V switching voltage, Yellow button, make contact, Total bu...
€37,39 €30,90 €35,50 €29,34
You save 5%
Cobo Lamp glass right
Cobo
Installation location: Right. More
Installation location: Right.
€31,30 €25,87
Cobo Work lamp H3 55 / 70 W, 12 V, 158 x 86 x 68 mm, screwed M10
Cobo
Bulb: H3. Form: Square. Material: Housing: plastic. Dimensions W x H x D: 158 x 86 x 68 mm. Nominal voltage: 12 V. Power consumption: 55 / 70 W. Mount... More
Bulb: H3. Form: Square. Material: Housing: plastic. Dimensions W x H x...
€60,44 €49,95 €57,40 €47,44
You save 5%
Cobo Rear light right 185 x 85 x 72 mm, 12 V, hole spacing 80 mm
Cobo
Bulb: 12V10WK / R10W, 12V21WK / P21W. Connection: Plug connection M42 x 1.5. Width: 185 mm. Form: Rectangular. Height: 85 mm. Hole spacing: 80 mm. Dim... More
Bulb: 12V10WK / R10W, 12V21WK / P21W. Connection: Plug connection M42 ...
€71,77 €59,31 €64,90 €53,64
You save 10%
GRANIT Lamp glass right, left
GRANIT
Installation location: Right, left. More
Installation location: Right, left.
€38,80 €32,07
ROCKINGER Trailer coupling hitch pin 30,6 mm, rail 330 mm, 2000 kg, black
ROCKINGER
Rail width (mm): 330 | Guide width (mm): 32 | Drawbar eye: DIN 11026 40 mm, DIN 11043 40 mm, DIN 74054 40 mm | D-value (kN): 120,0 | Type: RO 850 D | ... More
Rail width (mm): 330 | Guide width (mm): 32 | Drawbar eye: DIN 11026 4...
€1.079,32 €892,00 €867,75 €717,15
You save 20%
MAHLE Starter motor 12 V, 3,1 kW, 9 teeth, 232 mm, clockwise
€635,10 €524,88 €396,90 €328,02
You save 38%
GRANIT Exhaust gasket exhaust manifold inner Ø 39 mm, hole spacing 64 mm
GRANIT
Dimensions: innen Ø 39 mm, Lochabstand 64 mm, Schrauben Ø 10 mm. More
Dimensions: innen Ø 39 mm, Lochabstand 64 mm, Schrauben Ø 10 mm.
€3,65 €3,02
Piston ring set 3 rings Deutz-Fahr
€47,36 €39,14 €44,95 €37,15
You save 5%
Pressure retention valve Deutz-Fahr, Fendt
€34,21 €28,27 €32,45 €26,82
You save 5%
Walterscheid Top drawbar rail 309 mm, pin Ø 22 mm, coupling pin 37 mm
Walterscheid
Rail width: 309 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Connecting pin: 37 mm. Load capacity: 2000 kg. D-value: 120,5 kN. Colour: Black. Descrip... More
Rail width: 309 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Connecti...
€1.832,06 €1.514,10 €1.439,45 €1.189,63
You save 21%
Seal kit Deutz-Fahr, Lamborghini, Hürlimann, Same
€81,75 €67,56 €77,65 €64,17
You save 5%
MANN-FILTER Fuel filter WK731
€10,25 €8,47
Showing 25 - 48 of 172

Deutz-Fahr Agroplus 95 parts

A blown head gasket, a starter that gives up on a cold morning, a roof window that will not stay open. When one of those happens on a Deutz-Fahr Agroplus 95, this page has more than 170 new parts to choose from, made by GRANIT, ROCKINGER, Cobo, VICTOR REINZ and MAHLE.

Engine sealing

Cylinder head gaskets, valve cover gaskets, seal kits and seals, including the one for the hydraulic pump, are all here. The front cover gasket and vibration dampers complete the engine side.

Picking the right head gasket

Head gaskets for these engines come in more than one thickness, and the correct one depends on how far the pistons stand proud of the block. You can tell the thickness of the old gasket by the holes or notches at its edge. After a rebuild, measure piston protrusion again with a dial gauge. Tighten the head bolts in stages and in the correct sequence, and use new bolts where the engine calls for them.

Starting, charging and cab

  • starter motors and gear reduction starters, which use a reduction gear for more cranking torque
  • alternators
  • gas struts for the roof window
  • unheated mirrors
  • air conditioning compressors
  • automatic drawbars and Piton Fix hitches

Finding a match

Check the serial plate to be sure it is an Agroplus 95. Starters, alternators and compressors carry a plate with a number. For gaskets, take the old one and compare its shape. Then match that against the product details.

Getting the air conditioning back

If the air conditioning no longer blows cold, the compressor is not always at fault. Have the charge checked first. If the compressor does need replacing, change the drier and have the system flushed, because dirt and moisture from the old compressor will soon kill a new one. Use the correct amount of compressor oil and the right refrigerant. When fitting, check the pulley and its number of grooves, which must suit the belt drive on the engine. A vibration damper with cracked rubber makes the whole engine run rougher, and that is easiest to spot with the belts off.

For a starter that turns over reluctantly, test the battery and the earth cable before anything else. Only when those are in order is the starter motor or gear reduction starter itself the next step.

From the same Agroplus series

The Deutz-Fahr Agroplus 87 and the Deutz-Fahr Agroplus 100 each have a page with the parts for that model, which keeps things simple if you run more than one Agroplus. Any other Deutz-Fahr on the farm can be found by starting from Deutz-Fahr parts and picking the model there.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart