Menu
EUR

Deutz-Fahr Agrotron 115 MK3 tractor parts & technical data

Here you see more than 200 parts that fit the Deutz-Fahr Agrotron 115 MK3, sorted by group, such as trailer couplings, lighting and electrics.

229 parts found for Deutz-Fahr Agrotron 115 MK3
Show:
Reflector red 106 x 33 mm, thickness 11 mm, M5, hole spacing 55 mm
Form: Rectangular. Mounting type: Bolted. Colour: Red. Width: 106 mm. Height: 33 mm. Material thickness: 11 mm. Hole Ø: M5 mm. Hole spacing: 55 mm. M... More
Form: Rectangular. Mounting type: Bolted. Colour: Red. Width: 106 mm. ...
€25,00 €20,66
GRANIT Flasher unit electronic 12 V, 11 blade connections
GRANIT
Version: 12 V, control unit for indicator and hazard warning lights, 11 blade terminals. More
Version: 12 V, control unit for indicator and hazard warning lights, 1...
€306,01 €252,90 €290,70 €240,25
You save 5%
GRANIT Filter dryers airco 162 mm, #6 3/8 o-ring, M Deutz-Fahr
GRANIT
Length (mm): 162 | Thread: #6 3/8 O-Ring | Weight (g): 900 | Connection thread: M More
Length (mm): 162 | Thread: #6 3/8 O-Ring | Weight (g): 900 | Connectio...
€63,31 €52,32 €60,10 €49,67
You save 5%
GRAMMER Tractor seat Maximo Comfort Plus air suspended, 530 mm, Deutz VII
GRAMMER
Seat heater: Optional | Length (mm): 631 | Included in delivery: Seat supplied with seat contact switch and bracket for your existing control armrest.... More
Seat heater: Optional | Length (mm): 631 | Included in delivery: Seat ...
€2.082,30 €1.720,91
VICTOR REINZ Valve cover gasket SAME, Hürlimann, Deutz-Fahr, Lamborghini
€65,26 €53,93 €61,95 €51,20
You save 5%
GRANIT Cylinder head bolt M12 x 108 mm Fendt, Deutz-Fahr, Lamborghini
GRANIT
Engine types: BF4M1012, BF6M1012, BF4M2012, BF6M2012, TCD2012L04 2V, TCD2012L04 4V, TCD 2012L06 2V, TCD2012L06 V4, TCD3.6L04, TCD4.1L04, TCD6.1L06, TT... More
Engine types: BF4M1012, BF6M1012, BF4M2012, BF6M2012, TCD2012L04 2V, T...
€20,30 €16,78
GRANIT Cylinder head gasket 1,74 mm, 3 bores Deutz Agrotron 105-115
€111,31 €91,99 €105,70 €87,36
You save 5%
Outlet valve engine BF4M1012-BF6M1012 Deutz-Fahr
€54,87 €45,35 €52,10 €43,06
You save 5%
Cobo Lamp glass right, left, rear
Cobo
Installation location: Right, left, rear. More
Installation location: Right, left, rear.
€25,90 €21,41
Cylinder head bolt M12 x 178 mm Fendt, SAME, Hürlimann, Deutz-Fahr, Lamborghini
... More
Engine types: BF4M1012, BF6M1012, BF4M2012, BF6M2012, TCD2012L04 2V, T...
€24,20 €20,00
GRANIT Stop solenoid switch 12 V Deutz-Fahr, Fendt
€545,08 €450,48 €517,80 €427,93
You save 5%
GRANIT Injection nozzle Deutz-Fahr Agrotron 80-115, Agroplus 75-100
GRANIT
Type formula: DLLA147P360, 0433171257. Bosch no.: 2580433171257. More
Type formula: DLLA147P360, 0433171257. Bosch no.: 2580433171257.
€53,18 €43,95 €50,50 €41,74
You save 5%
Showing 217 - 229 of 229

Deutz-Fahr Agrotron 115 MK3 parts, from work lamps to the hydraulic pump

It is in the dark months that you notice how much good lighting and a clear view to the rear are worth. For the Deutz-Fahr Agrotron 115 MK3 this page carries more than 200 new parts, and part of that is for the cab: HELLA work lamps, wide-angle mirrors, gas struts for the roof window and a rocker switch for the driving lights. The engine, hydraulics and hitch are well covered too.

Cab and lighting

A flood beam work lamp lights up the ground beside and behind the tractor. If one goes out, check the plug and the earth connection before you swap the lamp, because moisture in a connector is often the real culprit. The gas strut on the roof window weakens with age. Replace it once the window no longer stays open by itself. For the seat you can choose between air-suspended GRAMMER tractor seats, including the Maximo Dynamic, and PROBOSS seats with seat heating.

Hydraulics, engine and steering

Under the bonnet the parts cover the hydraulic pump, the seal between pump and housing, the front cover gasket and the starter motor. When fitting a hydraulic pump, clean the mating faces thoroughly and make sure no grease is left on them. A thin seal only works on a smooth face with no traces of the old one left. For the front axle there are ball joints. Secure a new ball joint with a new split pin and make sure the dust boot is intact, as dirt inside the joint wears it out in no time.

Drawbar and linkage

At the rear you will find automatic drawbars, top drawbars, Piton Fix units and adapter plates, from makers such as Scharmüller and ROCKINGER. Measure the rail width of the mounting on your tractor before choosing a new drawbar. With adapter plates the hole pattern matters as well, so keep the old plate next to you when comparing.

Type plate and the rest of the MK3 line

The type plate tells you whether it really is an Agrotron 115 MK3. The old part often carries a reference number, which lets you confirm the choice before ordering. Every model in the MK3 line has a page of its own. If another one from this line sits in your shed, the parts are under the Agrotron 85 MK3, Agrotron 100 MK3, Agrotron 105 MK3, Agrotron 135 MK3 and Agrotron 150 MK3. Older and newer Deutz-Fahr models are listed under Deutz-Fahr parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart