Menu
EUR

Deutz-Fahr Agrotron 120 tractor parts & technical data

Our range for the Deutz-Fahr Agrotron 120 counts more than 200 parts, including trailer couplings, lighting and electrics for this tractor.

247 parts found for Deutz-Fahr Agrotron 120
Show:
GRANIT Hydraulic lifting strut 720 mm, stroke 190 mm Deutz, Hürlimann
5%
GRANIT
Hydraulic lifting strut 720 mm, stroke 190 mm Deutz, Hürlimann
Type: Clevis joint/ball joint. A: 28 mm. B: 32 mm. L: 720 mm. C: 45 mm. D: 90 mm...
€959,53 €793,00 €911,55 €753,35
 
GRANIT Brake mechanism foot brake Ø 227 mm, knott version Deutz-Fahr Agrotron
5%
GRANIT
Brake mechanism foot brake Ø 227 mm, knott version Deutz-Fahr Agrotron
€383,40 €316,86 €364,20 €300,99
 
Piston ring set 3 rings Ø 108 mm, 3 mm / 2 mm / 3,5 mm
5%
Piston ring set 3 rings Ø 108 mm, 3 mm / 2 mm / 3,5 mm
Dimensions: 3 rings, Ø 108 mm, 3 mm / 2 mm / 3.5 mm.
€41,77 €34,52 €39,65 €32,77
 
Lifting strut complete 710 - 800 mm, M36 x 3 Steyr, Deutz-Fahr
5%
Lifting strut complete 710 - 800 mm, M36 x 3 Steyr, Deutz-Fahr
Dimensions: Length = 710 - 800, Ball joint Ø = 25.4, Clevis Ø = 28, Clevis width...
€300,01 €247,94 €285,00 €235,54
 
Showing 241 - 247 of 247

Agrotron 120 parts for Deutz-Fahr owners

A blown head gasket, or a roof hatch that will not stay open: both are familiar on the Agrotron 120. This page brings together more than 200 parts for the Deutz-Fahr Agrotron 120, from makers such as GRANIT, HELLA, Walterscheid, ROCKINGER and VICTOR REINZ.

Engine: head, intake and belts

For the engine there are cylinder head gaskets, air intake gaskets, V-belts and starter motors. With the head gasket, thickness matters. On these engines it is chosen according to how far the pistons stand proud of the block, and the old gasket tells you which one was fitted through the notches or holes along its edge. Count them before you order. If in doubt, measure piston protrusion with a dial gauge, then torque the head in the specified sequence and stages.

A V-belt is best replaced before it snaps. Cracks on the inside, glazed flanks or squealing on a cold start are signs that it is slipping. Tension the new belt correctly and check it again after the first hours of work, because a new belt beds in slightly. When a rocker switch only works if you wiggle it, it is worn inside. Note which wire goes to which terminal before you unplug it.

Cab, hitching and steering

The Agrotron cab has a lot of glass, and the parts reflect that. There are gas struts for the roof hatch, wide-angle mirrors, windscreen symbols, rocker switches for the lights and work lamps, including HELLA flood lamps. Where two gas struts work side by side, replace them as a pair so the hatch is not loaded on one side only.

At the rear you can fit ball-type drawbars, drawbar frames, adapter plates and Piton Fix. For the steering there are complete ball joints for left and right. Check the thread size at both ends of a ball joint, because it differs between versions, and keep the old one next to you when comparing. Connection cables for the trailer socket and work lights are also available.

Type plate, range and neighbouring models

The type plate shows the model and serial number, and most VICTOR REINZ gaskets carry a stamped number you can check against the description. That way your Agrotron 120 gets the right part first time.

The Agrotron range contains many models that look alike from the outside. Each one has its own page listing only the parts that fit it:

Every other tractor from the brand is reached through Deutz-Fahr parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart