Working on a Deutz-Fahr Agrotron TTV 410? This page brings together more than 110 matching parts, such as trailer couplings, engine components and electrics.
A head gasket job or a weeping valve cover on an Agrotron TTV 410 calls for clean gaskets, fresh bolts and the right lines. That is where this page puts its weight, though hitch and cab parts are covered too. More than 110 parts are matched to this tractor, from GRANIT and from VICTOR REINZ, ROCKINGER, Sauermann and Walterscheid.
When the head gasket comes off, the head goes back on with new bolts. Cylinder head bolts are tightened into their stretch range and will not hold the same clamping force a second time. Reusing them looks like a saving, but a gasket that fails shortly after the repair is an expensive lesson. Tighten in the specified sequence and in stages, and clean the faces of head and block thoroughly before the new gasket goes on.
Injection lines follow a similar logic. Once a line end has been tightened hard, it is deformed. Replace a leaking line rather than giving it another heave with the spanner.
The rear rail can carry a clevis drawbar, a Piton Fix with a fixed pin or a top drawbar. Which one you need depends on the eye of the trailer drawbar. Two measurements of the existing bracket decide the fit, the rail width and the locking pin diameter. Check both before ordering. With the rail pressure sensor kit, inspect the plug and wiring for chafing first, as a damaged cable gives the same false readings as a failed sensor.
The type plate tells you whether the tractor really is a TTV 410 and not another model from the Agrotron TTV range. For engine parts, the part you removed is the best guide. Gaskets, lines and sensors usually carry a stamped or printed number, and that reference number can be checked against the product details.
Other Agrotron TTV models with a page of their own:
For any other tractor from the make, head to Deutz-Fahr parts.
