Menu
EUR

Deutz-Fahr Agrotron TTV 620 tractor parts & technical data

Browse more than 200 parts for the Deutz-Fahr Agrotron TTV 620 from the Agrotron TTV series, including trailer couplings, lighting and electrics.

225 parts found for Deutz-Fahr Agrotron TTV 620
Show:
GRANIT Sensor waterniveau fuel pre-filter
5%
GRANIT
Sensor waterniveau fuel pre-filter
Version: Fuel pre-filter - water level indicator.
€371,86 €307,32 €353,25 €291,94
 
MAHLE Aircon compressor 12 V, pulley Ø 132 mm, 2 grooves, 135 ccm oil, H/OR
6%
MAHLE
Aircon compressor 12 V, pulley Ø 132 mm, 2 grooves, 135 ccm oil, H/OR
Suitable oil: PAG 46 | Refrigerant: R 134a | Pulley Ø (mm): 132 | No. of grooves...
€543,40 €449,09 €509,40 €420,99
 
HELLA Work lamp flood beam xenon D1S 42 W, 12 V, 162 x 192 x 134 mm
HELLA
Work lamp flood beam xenon D1S 42 W, 12 V, 162 x 192 x 134 mm
Nominal voltage (V): 12 | Bulbs included: - | Protection class: IP5K4K/IPX9K | D...
€456,00 €376,86
 
Scharmüller Automatic hitch adjustable, rail 270 mm, pin 38 mm, 82,4 kN
Scharmüller
Automatic hitch adjustable, rail 270 mm, pin 38 mm, 82,4 kN
Colour: Kubota grey | D-value (kN): 82,4 | Load capacity (kg): 2000 | Plate heig...
€1.128,50 €932,64
 
GRANIT Pilot bearing 20 x 52 x 15 mm Deutz-Fahr, Lamborghini
GRANIT
Pilot bearing 20 x 52 x 15 mm Deutz-Fahr, Lamborghini
Dimensions (mm): 20 x 52 x 15
€11,15 €9,21
 
FEBI Cab filter for C55102 and AF26108
72%
FEBI
Cab filter for C55102 and AF26108
€40,38 €33,37 €11,43 €9,45
 
Ball joint right and left 305 mm, M20 x 1,5, taper 23,5 - 26,5 mm
5%
Ball joint right and left 305 mm, M20 x 1,5, taper 23,5 - 26,5 mm
A: 305 mm. C: M20 x 1,5 mm. D: M24 x 1,5 mm. E: 23,5 mm. F: 26,5 mm. Taper: 23,5...
€119,08 €98,41 €113,10 €93,47
 
LUK Pilot bearing 20 x 52 x 15 mm
5%
LUK
Pilot bearing 20 x 52 x 15 mm
Dimensions: 20 x 52 x 15 mm.
€34,18 €28,25 €32,45 €26,82
 
GRANIT Intercooler SAME, Hürlimann, Deutz-Fahr, Lamborghini Series R6
5%
GRANIT
Intercooler SAME, Hürlimann, Deutz-Fahr, Lamborghini Series R6
€2.549,49 €2.107,02 €2.422,00 €2.001,65
 
GRANIT Oil cooler height 60 mm
5%
GRANIT
Oil cooler height 60 mm
Height: 60 mm.
€344,51 €284,72 €327,25 €270,45
 
Thermostat Ø 66,5 mm, 87 °C SAME, Hürlimann, Deutz-Fahr, Lamborghini
5%
Thermostat Ø 66,5 mm, 87 °C SAME, Hürlimann, Deutz-Fahr, Lamborghini
Ø: 66,5 mm.
€80,84 €66,81 €76,75 €63,43
 
GRANIT Bleed valve Fendt, Deutz-Fahr
5%
GRANIT
Bleed valve Fendt, Deutz-Fahr
€241,85 €199,88 €229,75 €189,88
 
Injector Hürlimann, Lamborghini, Same
5%
Injector Hürlimann, Lamborghini, Same
€639,18 €528,25 €607,20 €501,82
 
GRANIT Cylinder head gasket 1,2 mm, 1 bore engine TCD2012 L06 4V
5%
GRANIT
Cylinder head gasket 1,2 mm, 1 bore engine TCD2012 L06 4V
€202,05 €166,98 €191,90 €158,60
 
GRANIT Feed pump Lamborghini Mach 200 ST - 250 VRT, R6.100-R6.190
5%
GRANIT
Feed pump Lamborghini Mach 200 ST - 250 VRT, R6.100-R6.190
€64,52 €53,32 €61,25 €50,62
 
Air hose intercooler inner-Ø 69 / 79 mm
Air hose intercooler inner-Ø 69 / 79 mm
Inner Ø: 69 / 79 mm.
€625,60 €517,02
 
GRANIT Tank cap with ventilation and lock, thread Ø 60 / 65 mm, collar Ø 65 mm
5%
GRANIT
Tank cap with ventilation and lock, thread Ø 60 / 65 mm, collar Ø 65 mm
Thread Ø mm: 60 / 65. Filler neck Ø: 65 mm.
€36,18 €29,90 €34,35 €28,39
 
Seal Ø 27 x 2,5 mm Fendt, SAME, Deutz-Fahr, Lamborghini
Seal Ø 27 x 2,5 mm Fendt, SAME, Deutz-Fahr, Lamborghini
Ø: 27 x 2,5 mm.
€21,25 €17,56
 
Showing 97 - 120 of 225

Deutz-Fahr Agrotron TTV 620 parts by job

Parts for an Agrotron TTV 620 tend to be needed in three places: the driver's seat and cab, the engine with its seals, and the hitch at the rear. This page brings together more than 200 parts that fit this tractor, from brands such as GRANIT, HELLA, Sauermann, GRAMMER and PROBOSS.

Hitching at the rear

For trailers there are drawbars, including automatic versions, and the Piton Fix system for heavier work. Before ordering, measure the rail width and the pin thickness of the drawbar currently fitted to your TTV 620 so the new one slides straight into the guide.

Engine, injection and cooling

An oily valve cover usually means the gasket has gone hard. You will find valve cover gaskets here, together with O-rings for the injection pump, injection lines and individual seals, for example for the hydraulic pump. Starter motors, air hoses and the fan clutch complete the engine side.

A workshop tip for the valve cover gasket: clean both the cylinder head face and the cover thoroughly, then tighten the bolts evenly in a crosswise pattern. Overtightening distorts the cover, and a new gasket will leak just like the old one. Never refit a used gasket, even when it still looks reasonable.

Seat, cab and lighting

A worn seat makes long days in the field harder than they need to be. There are complete tractor seats such as the air suspended GRAMMER Maximo Dynamic, plus PROBOSS seats, one of which comes with a seat heater. Flood beam work lamps help when the evenings draw in, a fresh gas strut keeps the roof window open again, and the aircon compressor is available too.

Matching the right part to your tractor

The quickest route is the number on the part you are replacing. Starter motors, gaskets and gas struts often carry a stamped or printed reference number that you can compare in the shop. Also check the type plate on the tractor to be sure you are working on a TTV 620 and not another model from the Agrotron TTV range. If you are unsure about a dimension, hold the old part next to the new one.

Every model has its own page. The smaller tractors in the range are on the pages for the Deutz-Fahr Agrotron TTV 410, the Agrotron TTV 420 and the Agrotron TTV 430, while the closest neighbours are the Agrotron TTV 610 and the Agrotron TTV 630. Always order from the page of your own model, because a part listed for one type does not automatically fit another. Everything else from this manufacturer is collected under Deutz-Fahr parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart