Menu
EUR

Deutz D3607 tractor parts

Do you need parts for your Deutz D3607 oldtimer tractor? In this category you’ll find all parts that fit this oldtimer tractor.

181 parts found for Deutz-Fahr D 3607
Show:
GRANIT Valve seat ring inlet valve Fendt, Deutz-Fahr
9%
GRANIT
Valve seat ring inlet valve Fendt, Deutz-Fahr
Engine types: F2L912, F3L912, F4L912, F6L912, F4L913, F6L913, BF6L913.
€35,57 €29,40 €32,35 €26,74
 
Steering valve dw not blocked 210 bar, 70 l/min, system SD60
9%
Steering valve dw not blocked 210 bar, 70 l/min, system SD60
Technical data: Max. operating pressure: 210 bar, Nominal flow rate: max. 70 l/m...
€663,73 €548,54 €604,25 €499,38
 
End plate steering valve SD60 250 bar, 50 l/min, 100 x 118 x 25 mm
9%
End plate steering valve SD60 250 bar, 50 l/min, 100 x 118 x 25 mm
Technical data: Max. operating pressure: 250 bar, Nominal flow rate: max. 50 l/m...
€170,59 €140,98 €155,30 €128,35
 
Bosch/Rexroth Hydraulic pump 16 cm³/rpm., taper 1:5, Ø 17 x 17, left Fendt, Deutz-Fahr
9%
Bosch/Rexroth
Hydraulic pump 16 cm³/rpm., taper 1:5, Ø 17 x 17, left Fendt, Deutz-Fahr
Output volume: 16 cc/rev. Drive shaft: Taper 1:5, Ø 17 x 17. Operating pressure ...
€643,00 €531,41 €585,35 €483,76
 
Bush left lift arm 71 x 80 x 85 mm Deutz-Fahr
9%
Bush left lift arm 71 x 80 x 85 mm Deutz-Fahr
Dimensions: 71 x 80 x 85 mm.
€147,22 €121,67 €134,00 €110,74
 
Bush right lift arm 74 x 80 x 85 mm Deutz-Fahr
9%
Bush right lift arm 74 x 80 x 85 mm Deutz-Fahr
Dimensions: 74 x 80 x 85 mm.
€179,42 €148,28 €163,30 €134,96
 
GRANIT Protective grille upper Deutz D 2807 - D 7807
9%
GRANIT
Protective grille upper Deutz D 2807 - D 7807
€226,01 €186,79 €205,75 €170,04
 
Brake light switch mechanical M14 x 1, break contact, blade terminal 6,3 mm
Brake light switch mechanical M14 x 1, break contact, blade terminal 6,3 mm
Version: Thread M14 x 1, break contact, normally on, Blade terminals 6.3 mm. Men...
€35,35 €29,21
 
HELLA Headlight left / right 12 V, R2, Ø 180 mm, built-in
4%
HELLA
Headlight left / right 12 V, R2, Ø 180 mm, built-in
Bulb: 12V45/40WAS / R2, or 12V45/40W halogen / R2 (Bilux). Outer Ø: 180 mm. Form...
€118,44 €97,88 €114,00 €94,21
 
GRANIT Lamp socket intermediate part rear
9%
GRANIT
Lamp socket intermediate part rear
€36,81 €30,42 €33,50 €27,69
 
Gaiter Ø 13 mm upper, Ø 50 mm lower Deutz 3006-7807
Gaiter Ø 13 mm upper, Ø 50 mm lower Deutz 3006-7807
To fit as: Deutz 3006, 4006, 5206, 6206, 6806, 7206, 2807, 3607, 4007, 4507, 480...
€19,20 €15,87
 
Tank cap tank collar Ø 106 mm with ventilation Lockable
Tank cap tank collar Ø 106 mm with ventilation Lockable
To fit as: Deutz 2506, 3006, 4006, 4506, 5006, 5206, 5506, 6006, 6206, 6806, 700...
€33,50 €27,69
 
Return spring brake pedal left Deutz 3006-13006
Return spring brake pedal left Deutz 3006-13006
To fit as: Deutz 3006, 4006, 5206, 6206, 8006, 10006, 13006
€20,70 €17,11
 
SACHS Double clutch DoT 225 36 x 40 mm, 20 splines Deutz-Fahr
9%
SACHS
Double clutch DoT 225 36 x 40 mm, 20 splines Deutz-Fahr
Flywheel design: Flat | Dimensions (mm): 36 x 40 20 grooves
€1.272,29 €1.051,48 €1.158,25 €957,23
 
SACHS Thrust bearing 50 x 82 x 16 mm Deutz-Fahr, Fendt
9%
SACHS
Thrust bearing 50 x 82 x 16 mm Deutz-Fahr, Fendt
Dimensions (mm): 50 x 82 x 16
€83,21 €68,77 €75,75 €62,60
 
Thrust bearing 50 x 81,6 x 21,8 mm Deutz-Fahr, Fendt
Thrust bearing 50 x 81,6 x 21,8 mm Deutz-Fahr, Fendt
Dimensions (mm): 50 x 81.6 x 21.8
€34,45 €28,47
 
Elring Cylinder head gasket set without cylinder head gasket engine FL912, FL913, BFL913
Elring
Cylinder head gasket set without cylinder head gasket engine FL912, FL913, BFL913
Supplementary set: For one cylinder head | Additional information: Without cylin...
€33,10 €27,36
 
GRANIT Seal kit Deutz-Fahr D 2807, DX 3.90 VC
GRANIT
Seal kit Deutz-Fahr D 2807, DX 3.90 VC
€200,50 €165,70
 
GRANIT Brake shoe Hand brake 180 x 30 mm Deutz
9%
GRANIT
Brake shoe Hand brake 180 x 30 mm Deutz
€48,99 €40,49 €44,60 €36,86
 
Starter ring gear Ø 382,5/354 mm, 126 teeth Deutz-Fahr D 2506-3607
9%
Starter ring gear Ø 382,5/354 mm, 126 teeth Deutz-Fahr D 2506-3607
Version: Ø 382,5/354 mm, 126 teeth.
€432,54 €357,47 €393,75 €325,41
 
VICTOR REINZ Cylinder head gasket 1,1 mm, outer-Ø 120 mm Fendt, Deutz-Fahr
VICTOR REINZ
Cylinder head gasket 1,1 mm, outer-Ø 120 mm Fendt, Deutz-Fahr
Engine types: FL912, FL913, BFL912, BFL913. Colour: A-Form. Outer Ø: 120 mm. Inn...
€10,25 €8,47
 
GRANIT Push rod tube 220 mm Deutz-Fahr
GRANIT
Push rod tube 220 mm Deutz-Fahr
Engine types: FL912, FL913, FL812. Length: 220 mm.
€25,40 €20,99
 
Showing 97 - 120 of 181

Deutz D3607 oldtimer tractor parts

For the Deutz D3607 oldtimer tractor, you'll find a wide selection of parts in our shop. From engine and fuel system components to metal body parts like hoods and fenders – we’ve got what you need. Popular parts include the seat, headlights, taillights, steering wheel, and various electrical components. Many parts are shared with other models in the Deutz 07 oldtimer series. All parts for this type can be easily found and ordered in our webshop.

Technical specs Deutz D3607

The Deutz D3607 was produced between 1978 and 1982 and features a 3-cylinder air-cooled F3L912 diesel engine with a displacement of 2.7 liters. It delivers approximately 36 hp. The original color is Deutz green (RAL 6018) with grey accents.

Still need parts for your Deutz D3607 oldtimer tractor? Simply order them through the Techniek Totaal webshop. Use the categories or search by part number to quickly find what you need. Need help or can’t find a specific part? Our customer service is happy to assist you.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart