Menu
EUR

Deutz-Fahr Agrotron TTV 430 tractor parts & technical data

Choose from more than 110 parts for the Deutz-Fahr Agrotron TTV 430. Trailer couplings, engine parts and electrics are best represented on this page.

112 parts found for Deutz-Fahr Agrotron TTV 430
Show:
Mirror with mirror arm right
Installation location: Right. More
Installation location: Right.
€261,35 €215,99 €236,45 €195,41
You save 10%
Sauermann Ball drawbar ball 80, rail 330 mm, nose weight 3000 kg John Deere
Sauermann
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 31,4 mm. Load capacity: 3000 kg. Colour: Black. D-value: 92 kN. Version: Sliding bolt. Lock: ba... More
Rail width: 330 mm. Detent pin Ø: 25 mm. Guide width: 31,4 mm. Load c...
€1.521,39 €1.257,35 €1.445,30 €1.194,46
You save 5%
GRANIT Mirror holder right SAME, Deutz-Fahr
GRANIT Internal plate PTO clutch 2 mm, 38 teeth
GRANIT
Version: thickness = 2 mm 38 teeth More
Version: thickness = 2 mm 38 teeth
€42,93 €35,48 €40,75 €33,68
You save 5%
Aircon compressor 12 V, Ø 132 mm, 2 grooves, 135 ccm
Fixing: EM | Nominal voltage (V): 12 | Suitable oil: PAG 46 | Oil quantity (ccm): 135 | Refrigerant: R 134a | No. of grooves: 2 | Pulley Ø (mm): 132 ... More
Fixing: EM | Nominal voltage (V): 12 | Suitable oil: PAG 46 | Oil quan...
€460,01 €380,17 €437,00 €361,16
You save 5%
Elring Seal glow plug
€15,00 €12,40
VICTOR REINZ Valve cover gasket upper Hürlimann, Lamborghini, Deutz-Fahr, Same
€83,73 €69,20 €79,50 €65,70
You save 5%
Bolt exhaust aftertreatment M8 x 70 mm
Description: M8 x 70 mm. Thread: M8. Length: 70 mm. More
Description: M8 x 70 mm. Thread: M8. Length: 70 mm.
€40,62 €33,57 €38,55 €31,86
You save 5%
GRANIT O-ring 30 x 5 mm Fendt, SAME, Hürlimann, Deutz-Fahr, Lamborghini
GRANIT
Dimensions: 30 x 5 mm. More
Dimensions: 30 x 5 mm.
€7,45 €6,16
GRANIT Cylinder head bolt M12 x 100 mm engine TCD2012L04 4V-TCD6.1L06
GRANIT
Engine types: TCD2012L04 4V, TCD2012L06 4V, TCD2013L06 4V, TCD6.1L06. Dimensions: M12 x 100 mm. More
Engine types: TCD2012L04 4V, TCD2012L06 4V, TCD2013L06 4V, TCD6.1L06. ...
€22,60 €18,68
GRANIT Cylinder head bolt M12 x 108 mm Fendt, Deutz-Fahr, Lamborghini
GRANIT
Engine types: BF4M1012, BF6M1012, BF4M2012, BF6M2012, TCD2012L04 2V, TCD2012L04 4V, TCD 2012L06 2V, TCD2012L06 V4, TCD3.6L04, TCD4.1L04, TCD6.1L06, TT... More
Engine types: BF4M1012, BF6M1012, BF4M2012, BF6M2012, TCD2012L04 2V, T...
€20,30 €16,78
Showing 97 - 112 of 112

Deutz-Fahr Agrotron TTV 430 parts with a focus on fuel injection

Under the bonnet of an Agrotron TTV 430 sits a common rail engine with injection lines, a rail pressure sensor and a feed pump, and that part of the tractor is well covered here. In total, more than 110 parts on this page fit the Deutz-Fahr Agrotron TTV 430.

Fuel and injection

On the fuel side you will find injection lines, O-rings for the injection pump, a feed pump and a rail pressure sensor kit. When the engine drops into limp mode or cuts out, that sensor is one of the first things a mechanic reads out.

Tip for injection work: cleanliness comes first. Clean around a line before loosening it and cap any open connection straight away. A single grain of grit in a common rail system can do more harm than the leak you set out to fix.

Engine gaskets and seals

For the engine itself there is a valve cover gasket, front gaskets, a crankshaft seal and individual seals, some from VICTOR REINZ. The exhaust aftertreatment uses a dedicated bolt that is better not reused once removed. Tighten a new valve cover gasket evenly in a crosswise pattern so it is pressed down equally all round.

If the engine is reluctant to fire after a filter change or a new injection line, there is often air in the low pressure side. The feed pump moves fuel from the tank to the filter and on to the high pressure pump. Bleed the system as the workshop manual describes before cranking for long. When fitting an injection line, make sure it sits without tension and that every clamp goes back on, because a vibrating line can crack.

Cab and hitch

Cab parts include gas struts for the front or rear window, mirrors and an aircon compressor. At the rear, automatic drawbars, top drawbars and Piton Fix units from ROCKINGER, Walterscheid and Sauermann all fit.

The right part and the other TTV models

The type plate shows which TTV you are running. That matters, because from the outside the models look very much alike. For gaskets and sensors, compare the number on the old part with the product details.

These models from the Agrotron TTV series each have a page of their own, useful for contractors running several TTVs:

Other series from the brand, from older tractors to current models, are listed under Deutz-Fahr parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart