Which parts fit the Deutz-Fahr AgroXtra 6.07? More than 300 are listed for this AgroXtra tractor, with lighting, trailer couplings and electrics among them.
When the clutch on an AgroXtra 6.07 starts to slip or drag, the tractor has to be split. That is a serious job, and once it is apart you want everything at the joint sorted in one go. That is why this page leads with the driveline: clutch kits, thrust bearings and crankshaft seals, with LUK among the manufacturers.
With the engine and gearbox separated, the rear crankshaft seal is right there in front of you. A seal that is only just holding today will be weeping before long, and that means splitting the tractor all over again. Replace it together with the clutch plate and thrust bearing. Clean the running surface on the crankshaft, check it for a worn groove, and press the new seal in square rather than tapping it in at an angle. Also look for oil traces on the flywheel side, because oil on a fresh plate means it will slip again.
In total there are more than 300 parts on this page that fit the Deutz-Fahr AgroXtra 6.07. Besides the clutch you will find:
Manufacturers include GRANIT, HELLA, ROCKINGER, LUK and MAHLE.
The type plate on the tractor carries the Typ number, which together with the AgroXtra series name identifies your machine. For starters, alternators and clutch plates the old part is your best reference, as there is nearly always a number on the housing or the plate that you can compare with the details of the new product. For a clutch plate, it is also worth counting the splines on the old hub before you order.
From the same AgroXtra range, the Deutz-Fahr AgroXtra 4.57 has its own page listing just the parts meant for it, handy if both run on your farm. For every other model from the make, go to the Deutz-Fahr parts overview.