Menu
EUR

Valtra 6600 tractor parts & technical data

Known as both the Valtra 6600 and the Valmet 6600, this Mezzo series tractor has more than 150 parts here, from steering and front axle to trailer couplings.

141 parts found for Valtra-Valmet 6600
Show:
Scharmüller Drawbar ball 50, rail 200 mm, pin Ø 16 mm, 150 kg
Scharmüller
Rail width: 200 mm. Guide width: 25 mm. Detent pin Ø: 16 mm. Load capacity: 150 kg. D-value: 17,2 kN. Overhang: 80 mm. Plate height: 90 mm. Hole: M16... More
Rail width: 200 mm. Guide width: 25 mm. Detent pin Ø: 16 mm. Load cap...
€561,80 €464,30
SANDEN Aircon compressor SD7H15 12 V, pulley Ø 132 mm, 2 grooves Valtra-Valmet
SANDEN
Oil quantity (ccm): 135 | Suitable oil: SP - 10 | Refrigerant: R 134a | Connection: A2 | Nominal voltage (V): 12 | Pulley Ø (mm): 132 | Menke no.: 67... More
Oil quantity (ccm): 135 | Suitable oil: SP - 10 | Refrigerant: R 134a ...
€562,03 €464,49 €533,90 €441,24
You save 5%
GRANIT Ball joint 220 mm, M22 x 1,5, M22 x 1,5, taper 23,5 - 26,4 mm
GRANIT
A: 220 mm. C: M22 x 1,5 mm. D: M22 x 1,5 mm. E: 23,5 mm. F: 26,4 mm. Taper: 23,5 - 26,4 mm. More
A: 220 mm. C: M22 x 1,5 mm. D: M22 x 1,5 mm. E: 23,5 mm. F: 26,4 mm. T...
€79,46 €65,67 €75,45 €62,36
You save 5%
Carraro Bronze bearing Ø 53 x 48 x 40 mm Massey Ferguson, Case IH, New Holland
Carraro
Outer Ø: 53 mm. Inner Ø: 48 mm. Length: 40 mm. More
Outer Ø: 53 mm. Inner Ø: 48 mm. Length: 40 mm.
€14,60 €12,07
GRANIT Wheel brake cylinder K1, DOT 4 Valtra-Valmet Mezzo 6000-6900
€176,09 €145,53 €167,25 €138,22
You save 5%
GRANIT Repair set brake cylinder Valtra-Valmet, Fendt
€37,73 €31,18 €35,80 €29,59
You save 5%
Thermostat Ø 67 mm, 83 °C Massey Ferguson, Case IH, Steyr
Ø: 67 mm. Temperature: 83 °C. More
Ø: 67 mm. Temperature: 83 °C.
€36,87 €30,47 €35,00 €28,93
You save 5%
Crankshaft seal for Ø 58 x 80 x 12 mm Massey Ferguson
Outer Ø: 80 mm. Width: 12 mm. Inner Ø: 58 mm. More
Outer Ø: 80 mm. Width: 12 mm. Inner Ø: 58 mm.
€14,80 €12,23
Cylinder head gasket engine Sisu 420
€146,11 €120,75 €138,80 €114,71
You save 5%
Door lock, right Fendt Farmer 240 S (Typ 294), GT 395
€54,33 €44,90 €51,60 €42,64
You save 5%
Scharmüller Drawbar K80 manual, rail 335 mm, pin Ø 22 mm, 3000 kg, AGCO gray
Scharmüller
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 3000 kg. D-value: 89,3 kN. Plate height: 150 mm. Colour: AGCO grey. Overh... More
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load cap...
€1.294,08 €1.069,49 €1.089,95 €900,79
You save 16%
Scharmüller Ball 80® ball inserts gray cast iron, rail width 335 mm, 4000 kg
Scharmüller
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 4000 kg. D-value: 89,3 kN. Plate height: 160 mm. Colour: AGCO grey. Overh... More
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load cap...
€1.221,12 €1.009,19 €1.028,50 €850,00
You save 16%
GRANIT Steering column switch indicator, main beam, horn, interval
GRANIT
Version: Functions: indicators, horn, dipped beam/full beam changeover, headlight flasher, wiper/washer intervals. Connection cable with 2 plugs. More
Version: Functions: indicators, horn, dipped beam/full beam changeover...
€250,30 €206,86
VDO Coolant temperature sensor M14 x 1,5, +40 - +120 °C, 98 °C
VDO
Version: Temperature measuring range: +40°C to +120°C, Thread: M14 x 1.5, Resistance values: 287.4 - 22.7 ohm, Outlet: 1-pin via earth, Warning cont... More
Version: Temperature measuring range: +40°C to +120°C, Thread: M14 x...
€163,00 €134,71 €147,45 €121,86
You save 10%
BOSCH Sensor hydraulic pressure lifting height
BOSCH
Version: Lifting height. More
Version: Lifting height.
€355,33 €293,66 €314,26 €259,72
You save 12%
FLEETGUARD Hydraulic oil filter HF35322
€99,05 €81,86 €89,60 €74,05
You save 10%
MAHLE Alternator 14 V, 120 A, flange 56 mm, compact, dust-tight
MAHLE
Direction of rotation: ↻ | Installation angle (°): l 30 | Pulley Ø (mm): - | Additional information: Compact alternator, dust-tight | Mounting L /... More
Direction of rotation: ↻ | Installation angle (°): l 30 | Pulley Ø...
€372,69 €308,01 €232,90 €192,48
You save 38%
MAHLE Alternator 14 V, 65 A, pulley-Ø 80 mm, form A
MAHLE
Pulley Ø (mm): 80.0 | Charging current (A): 65 | Form: A | Pulley spacing (mm): 37,0 | Nominal values (V / A): 14 / 65 | Mounting L / d / R (mm): 82,... More
Pulley Ø (mm): 80.0 | Charging current (A): 65 | Form: A | Pulley spa...
€224,58 €185,60 €140,35 €115,99
You save 38%
DANA Spicer Spacer as front axle 745, outer-Ø 150 mm, inner-Ø 120 mm, 1 mm
DANA Spicer
Thickness (mm): 1 | Outer Ø (mm): 150 | Inner Ø (mm): 120 More
Thickness (mm): 1 | Outer Ø (mm): 150 | Inner Ø (mm): 120
€44,85 €37,07 €42,60 €35,21
You save 5%
Seal kit hydraulic steering
€217,34 €179,62 €206,45 €170,62
You save 5%
GRANIT Hand brake cable 937 mm Valtra-Valmet Mezzo, Mega, HiTech, C
€199,41 €164,80 €189,40 €156,53
You save 5%
Starter ring gear Ø 405/373 mm, 133 teeth Valtra-Valmet
Version: Ø 405/373 mm, 133 teeth. More
Version: Ø 405/373 mm, 133 teeth.
€215,16 €177,82 €204,40 €168,93
You save 5%
Showing 25 - 48 of 141

Valtra 6600 parts: steering, fuel system and cab

Play in the steering, a cab door that will not latch, a weeping feed pump. Those are typical jobs on a Valtra 6600, a member of the Mezzo series that is also known as the Valmet 6600. More than 150 parts fit this tractor, from GRANIT, Scharmüller, GRAMMER, Walterscheid and DANA Spicer.

Steering and driveline

For the front axle there are ball joints, and for the main clutch there are clutch plates. Gear wheels and O-rings, including ones for the differential, complete this group. The quickest way to check a ball joint takes two people. One rocks the steering wheel back and forth with the engine running while the other holds a hand on the joint. If you feel a click before the wheel moves, the joint is worn. Replace a torn dust boot along with the joint, otherwise the new one will soon run dry.

Fuel and cooling

  • feed pumps and seals for the feed pump
  • engine seal kits
  • a water pump repair set
  • stop cables

The feed pump draws diesel from the tank and pushes it to the filter. If it weeps at the flange, a new seal is often enough. If the engine runs rough and you see air bubbles in a clear line, the pump itself is worn. After fitting, work the hand lever until the filter is full before you start. The water pump repair set lets you refresh the existing pump instead of buying a complete new one. Coolant dripping from the small weep hole under the pump means it is time. A stiff stop cable just needs a few drops of thin oil, but replace it at once if the inner wire is fraying, because a snapped cable leaves you unable to shut the engine down the usual way.

Cab and lighting

For the cab there are door locks, tractor seats, work lamps, indicator position lights and a flasher unit. If the indicators suddenly flash twice as fast, a bulb has usually failed rather than the flasher unit, so check the bulbs first. At the back, a drawbar with ball for the hitch rail fits this model.

Identifying the right part

The type plate shows whether your tractor is badged Valtra or Valmet 6600, as both names are in use. For the feed pump, water pump or a door lock, the number on the old part tells you which version you need. With door locks, also note which side, left or right, you need.

Other Mezzo tractors

Each of these models has a page listing the parts recorded for it:

All other Valtra and Valmet models start from Valtra parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart