Menu
EUR

Valtra 6850 tractor parts & technical data

The Valtra 6850, also known as the Valmet 6850, has its own page here with more than 130 parts for steering and front axle, trailer couplings and electrics.

137 parts found for Valtra-Valmet 6850
Show:
DANA Spicer Sealing ring final drive front axle 755, 40 x 65 x 18 mm
5%
DANA Spicer
Sealing ring final drive front axle 755, 40 x 65 x 18 mm
Dimensions (mm): 40 x 65 x 18
€32,42 €26,79 €30,75 €25,41
 
Ball joint 295 mm, M24 x 1,5, M22 x 1,5, taper 29 - 32,2 mm
5%
Ball joint 295 mm, M24 x 1,5, M22 x 1,5, taper 29 - 32,2 mm
A: 295 mm. C: M24 x 1,5 mm. D: M22 x 1,5 mm. E: 29 mm. F: 32,2 mm. Taper: 29 - 3...
€99,37 €82,12 €94,40 €78,02
 
Hand brake cable 1005 mm Valtra-Valmet HiTech, C, M, N, T, X, XM
5%
Hand brake cable 1005 mm Valtra-Valmet HiTech, C, M, N, T, X, XM
Length: 1005 mm.
€207,39 €171,40 €197,00 €162,81
 
GRANIT Gear wheel planetary set rear axle 82 teeth Valtra-Valmet
5%
GRANIT
Gear wheel planetary set rear axle 82 teeth Valtra-Valmet
Number of teeth: 82.
€857,65 €708,80 €814,75 €673,35
 
Thermostat Ø 67 mm, 83 °C
5%
Thermostat Ø 67 mm, 83 °C
Ø: 67 mm. Temperature: 83 °C.
€37,90 €31,32 €36,00 €29,75
 
Seal kit top and bottom Valtra-Valmet Mezzo 6000-6850
5%
Seal kit top and bottom Valtra-Valmet Mezzo 6000-6850
€422,97 €349,56 €401,80 €332,07
 
Main bearing standard Ø 85 mm
5%
Main bearing standard Ø 85 mm
€48,38 €39,98 €45,95 €37,98
 
GRANIT PTO shaft end piece 1 3/8 inch, 6 splines Valtra-Valmet
5%
GRANIT
PTO shaft end piece 1 3/8 inch, 6 splines Valtra-Valmet
Version: 1 3/8"", 6 grooves
€198,20 €163,80 €188,25 €155,58
 
Internal plate PTO clutch Ø 133,4 x 93 mm, 1,8 mm, 45 teeth
5%
Internal plate PTO clutch Ø 133,4 x 93 mm, 1,8 mm, 45 teeth
Version: Thickness: 1.8 mm, inner: 93 mm, outer: 133.4 mm, 45 splines
€17,98 €14,86 €17,00 €14,05
 
GRANIT Clutches set 7+7 Valtra-Valmet 6250 - 8950, C90 - XM150
5%
GRANIT
Clutches set 7+7 Valtra-Valmet 6250 - 8950, C90 - XM150
€164,08 €135,60 €155,85 €128,80
 
DANA Spicer Hollow wheel carrier final drive front axle 212, 5,22 kg
DANA Spicer
Hollow wheel carrier final drive front axle 212, 5,22 kg
€513,00 €423,97
 
DANA Spicer O-ring differential front axle 745, 2 g
DANA Spicer
O-ring differential front axle 745, 2 g
€2,23 €1,84
 
DANA Spicer Intermediate bush as front axle 745, 120 x 127 x 40 mm
5%
DANA Spicer
Intermediate bush as front axle 745, 120 x 127 x 40 mm
Dimensions (mm): 120 x 127 x 40 | Inner Ø (mm): 120 | Height (mm): 40 | Outer Ø ...
€134,56 €111,21 €127,80 €105,62
 
Seal kit hydraulic steering
5%
Seal kit hydraulic steering
€338,41 €279,68 €321,45 €265,66
 
Ball joint 260 mm, taper 24 - 26 mm, M20 x 1,5 / M24 x 1,5
5%
Ball joint 260 mm, taper 24 - 26 mm, M20 x 1,5 / M24 x 1,5
A: 260 mm. C: M20 x 1,5 mm. D: M24 x 1,5 mm. E: 24 mm. F: 26 mm. Taper: 24 - 26 ...
€78,72 €65,06 €74,75 €61,78
 
Gear wheel main shaft 31 teeth Valtra-Valmet
5%
Gear wheel main shaft 31 teeth Valtra-Valmet
Number of teeth: 31.
€405,59 €335,20 €385,30 €318,43
 
GRANIT Water pump with gasket Valtra-Valmet, Massey Ferguson
5%
GRANIT
Water pump with gasket Valtra-Valmet, Massey Ferguson
€175,18 €144,78 €166,40 €137,52
 
GRANIT Seal timing case Massey Ferguson, Valtra-Valmet
GRANIT
Seal timing case Massey Ferguson, Valtra-Valmet
€28,80 €23,80
 
Showing 97 - 120 of 137

Valtra 6850 parts, Valmet 6850 included

If the bonnet of your 6850 still says Valmet rather than Valtra, you are in the right place all the same. It is the same tractor from the Hitech range with a different name on the bonnet. This page holds more than 130 replacement parts that fit this model, from GRANIT, DANA Spicer, Scharmüller, Walterscheid and MAHLE.

Engine and exhaust

For the engine there are seal kits, valve cover gaskets and piston ring sets from MAHLE, plus an engine speed sensor. Before new piston rings go on, check the end gap of each ring inside its own cylinder. On the exhaust side you will find seals for the exhaust manifold at the turbocharger and silencers.

A tip on that manifold seal: clean both faces back to bare metal with no trace of the old gasket, then tighten the nuts in several stages working crosswise. Let the engine warm up and check that they are still tight. A manifold with a small leak gives itself away as a ticking noise under throttle, and it blows hot gas past the turbo.

Steering, hitch and driveline

The front axle is covered by ball joints and a bolt set for the steering valve. At the rear there are ball drawbars and separate balls, from Scharmüller and Walterscheid among others. For the driveline there are O-rings, for instance for the differential and the feed pump.

Lighting and cab

Work lamps, combined indicator and position lights and a flasher unit keep the tractor visible on the road. For the cab there are door locks. A stiff lock is worth a little graphite or light oil before you replace it. If you convert the lights to LED, bear in mind that a conventional flasher unit will blink too fast with the lower load, so choose a unit designed for it.

Getting the fit right

The rating plate shows the model whether the tractor left the factory as a Valtra or a Valmet. Go by that, since each model in the Hitech range has a page of its own. If the old part carries a number, use it to compare with the parts on this page. With door locks and lamps, check the side as well.

These models from the same range have their own pages, useful when more than one Valtra works on the farm:

The Valtra 8950 belongs to this range too. For that model and every other one, start at Valtra parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart