Menu
EUR

Valtra N 104 tractor parts & technical data

Every item on this page fits the Valtra N 104. Pick from more than 50 parts, including trailer couplings, electrics and parts for the steering and front axle.

51 parts found for Valtra-Valmet N 104
Show:
Signal transmitter exhaust aftertreatment Valtra-Valmet N4
€569,99 €471,07 €541,45 €447,48
You save 5%
GRANIT AdBlue-feed unit Valtra-Valmet A84-A134
GRANIT
Description: AdBlue supply units ensure even metering of AdBlue depending on the load on the common rail engine. It is important that only filtered ur... More
Description: AdBlue supply units ensure even metering of AdBlue depend...
€1.004,11 €829,84 €953,90 €788,35
You save 5%
Temperature sensor Fendt, Massey Ferguson, Valtra-Valmet
€90,81 €75,05 €86,25 €71,28
You save 5%
Rail pressure sensor Fendt 5255L-9470X, Massey Ferguson Series 5600-9530
Wabco Solenoid valve 3/2-way, 12 V, 1,41 A, M16 x 1,5, standard closed
Wabco
Eligible: Environmental protection and safety (formerly de minimis) More
Eligible: Environmental protection and safety (formerly de minimis)
€413,58 €341,80 €392,90 €324,71
You save 5%
GRANIT Ball joint 247 mm, D M24 x 1,5, tube Ø 36 mm
GRANIT
A: 247 mm. D: M24 x 1,5 mm. E: 27 mm. F: 30,2 mm. Tube Ø: 36 mm. More
A: 247 mm. D: M24 x 1,5 mm. E: 27 mm. F: 30,2 mm. Tube Ø: 36 mm.
€77,43 €63,99 €73,55 €60,79
You save 5%
BOSCH Pressure regulator CP4 Valtra-Valmet, Fendt, Massey Ferguson
€177,02 €146,30 €156,56 €129,39
You save 12%
GRANIT AdBlue injection unit Valtra-Valmet, Fendt
€687,61 €568,27 €653,20 €539,83
You save 5%
Scharmüller Forced steering inner part left Ball 80 to K50 250 mm, 2 ton
Scharmüller
Assembly notes: Anticlockwise. Steering power: 2 t. Lock: K50. Description: Approved for steering forces up to 20 kN (2 t). Load capacity: 2 t. Load c... More
Assembly notes: Anticlockwise. Steering power: 2 t. Lock: K50. Descrip...
€472,38 €390,40 €417,75 €345,25
You save 12%
Denso Air conditioning compressor 12 V, pulley Ø 120 mm, 8 grooves
Denso
No. of grooves: 8 | Nominal voltage (V): 12 | Fixing: DM | Oil quantity (ccm): 220 | Pulley Ø (mm): 120 | Refrigerant: R 134a | Suitable oil: ND-oil More
No. of grooves: 8 | Nominal voltage (V): 12 | Fixing: DM | Oil quantit...
€951,15 €786,07
Scharmüller Forced steering 250 mm, K50, left, 2 ton, black, 4,86 kg
Scharmüller
Steering power (t): 2 | Colour: Black | Lock: K50 | Assembly notes: Anticlockwise | Description: Approved for steering forces up to 20 kN (2 t) | Conn... More
Steering power (t): 2 | Colour: Black | Lock: K50 | Assembly notes: An...
€472,38 €390,40 €417,75 €345,25
You save 12%
GRANIT Pressure pipe Fendt, Massey Ferguson
GRANIT
Designation: For 38015243. More
Designation: For 38015243.
€133,70 €110,50
Temperature sensor A84-A134
€90,81 €75,05 €86,25 €71,28
You save 5%
Showing 25 - 48 of 51

Valtra N 104 parts with a focus on hitching

A Valtra N 104 spends plenty of its life pulling a tipping trailer, a bale cart or a slurry tanker. That is why a good share of the more than 50 parts on this page are for the rear of the tractor, alongside parts for cooling, hydraulics and the cab.

Hitching gear

For towing you will find drawbars with a ball, a ball hitch and screw-in ball adapters. For a pick-up hitch there are inserts and Piton Fix pins, and to mount it all there are adapter plates and support plates. Trailers with a self-steering axle are covered too, with parts for forced steering. Scharmüller and Walterscheid are among the makers here. A screw-in ball adapter turns an existing drawbar into a ball hitch, which is handy if you switch between trailers with a ring eye and ones with a ball cup. Recheck the nut after the first few loaded runs.

Look after the ball hitch

A ball hitch is meant to run greased. Left dry, the ball and the cup in the drawbar eye wear quickly, and you will hear it as a hard knock when pulling away and braking. Clean the ball regularly and apply a thin layer of grease. Measure it now and then as well, and if it has clearly worn out of round, fit a new one. With forced steering, also check the mountings of the steering rods, which take heavy loads on headland turns.

Cooling, lines and cab

  • Radiator hoses, including the bottom hose
  • Temperature sensors
  • A pressure pipe, a return line and seals for the pressure pipe
  • A rear-view mirror for the cab
  • A lockable fuel tank cap

Besides GRANIT, brands such as Wabco and BOSCH are represented.

Ordering for your N 104

The type plate confirms you have an N 104. For hitch parts, two more measurements matter, and you take them on the tractor itself: the rail width of the existing hitch mounting and the diameter of the locking pin. With those, you can pick the right adapter plate or Piton Fix. For hoses, sensors and pipes, look for a reference number on the part you removed.

The rest of the N series

The N 104 has siblings in the same series, and each one has its own page so you can see exactly what fits that tractor: Valtra N 134, Valtra N 154 and Valtra N 174. For older Valmet tractors and every other model, start at Valtra parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart