Menu
EUR

Valtra T 213 tractor parts & technical data

Maintaining a Valtra T 213 from the T3 series? Choose from more than 120 parts here, with trailer couplings, lighting and electrics at the top of the list.

122 parts found for Valtra-Valmet T 213
Show:
Door lock, right Fendt Farmer 240 S (Typ 294), GT 395
€54,33 €44,90 €51,60 €42,64
You save 5%
Scharmüller Ball 80® ball inserts gray cast iron, rail width 335 mm, 4000 kg
Scharmüller
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 4000 kg. D-value: 89,3 kN. Plate height: 160 mm. Colour: AGCO grey. Overh... More
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load cap...
€1.221,12 €1.009,19 €1.028,50 €850,00
You save 16%
BOSCH Sensor hydraulic pressure lifting height
BOSCH
Version: Lifting height. More
Version: Lifting height.
€355,33 €293,66 €314,26 €259,72
You save 12%
SACHS Shock absorber rear, gas pressure MSE27/13X47A2 Valtra-Valmet
SACHS
Dimensions (mm): MSE27/13X47A2 | Installation location: Rear | Design: Gas pressure | To fit: Valtra | System: Twin-tube More
Dimensions (mm): MSE27/13X47A2 | Installation location: Rear | Design:...
€669,43 €553,25 €635,95 €525,58
You save 5%
DANA Spicer Gear ring final drive front axle 750/201
DANA Spicer Spacer as front axle 745, outer-Ø 150 mm, inner-Ø 120 mm, 1 mm
DANA Spicer
Thickness (mm): 1 | Outer Ø (mm): 150 | Inner Ø (mm): 120 More
Thickness (mm): 1 | Outer Ø (mm): 150 | Inner Ø (mm): 120
€44,85 €37,07 €42,60 €35,21
You save 5%
GRANIT Gear reduction starter 12 V, 4,2 kW, 11 teeth, 226 mm, clockwise
€317,36 €262,28 €301,45 €249,13
You save 5%
Engine preheater, complete connection Ø 40 mm, press
Connection: Ø 40 mm press fitting. More
Connection: Ø 40 mm press fitting.
€427,72 €353,49 €406,30 €335,79
You save 5%
Thermostat Ø 67 mm, 83 °C Massey Ferguson, Case IH, Steyr
Ø: 67 mm. Temperature: 83 °C. More
Ø: 67 mm. Temperature: 83 °C.
€36,87 €30,47 €35,00 €28,93
You save 5%
GRANIT Cylinder head gasket engine Sisu
€79,42 €65,64 €75,40 €62,31
You save 5%
Thermostat Ø 54 mm, 80 °C Massey Ferguson, Valtra, Fendt, Challenger
Ø: 54 mm. Temperature: 80 °C. More
Ø: 54 mm. Temperature: 80 °C.
€25,00 €20,66
Scharmüller Drawbar ball 50, rail 200 mm, pin Ø 16 mm, 150 kg
Scharmüller
Rail width: 200 mm. Guide width: 25 mm. Detent pin Ø: 16 mm. Load capacity: 150 kg. D-value: 17,2 kN. Overhang: 80 mm. Plate height: 90 mm. Hole: M16... More
Rail width: 200 mm. Guide width: 25 mm. Detent pin Ø: 16 mm. Load cap...
€561,80 €464,30
Scharmüller Drawbar K80 manual, rail 335 mm, pin Ø 22 mm, 3000 kg, AGCO gray
Scharmüller
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 3000 kg. D-value: 89,3 kN. Plate height: 150 mm. Colour: AGCO grey. Overh... More
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load cap...
€1.294,08 €1.069,49 €1.089,95 €900,79
You save 16%
Scharmüller Support plate Piton Fix manual, 445 x 220 x 40 mm, 3 ton, AGCO gray
Scharmüller
D-value (kN): 71,9 | Category: Support plates | Lock: Piton Fix manual | Version: Standard | Colour: AGCO grey | Load capacity (t): 3 | Length (mm): 4... More
D-value (kN): 71,9 | Category: Support plates | Lock: Piton Fix manual...
€950,65 €785,66
Scharmüller Drawbar frame 10 kN, rail width 200 mm, nose weight 350 kg
Scharmüller
Version: Standard | Category: Bearing supports | Guide width (mm): 25 | Rail width (mm): 200 | D-value (kN): 10 | Colour: Black | Detent pin Ø (mm): ... More
Version: Standard | Category: Bearing supports | Guide width (mm): 25 ...
€643,75 €532,02
CARLISLE External plate Hi-Lo 1,5 mm, inner 98,9 mm, outer 142,5 mm, 6 teeth
CARLISLE
Version: thickness = 1,5 mm inner = 98,9 mm outer = 142,5 mm 6 teeth More
Version: thickness = 1,5 mm inner = 98,9 mm outer = 142,5 mm 6 teeth
€13,18 €10,89 €12,50 €10,33
You save 5%
BOSCH Fuel pre-filter line filter D 37 mm, H 105 mm, connection 6 mm
BOSCH
C (mm): 35 | F: 6 | D (mm): 37 | H (mm): 105 | Height (mm): 105 | Version: Leitungsfilter | G (mm): 6 | Additional information: Typformel: F4058 | Ø ... More
C (mm): 35 | F: 6 | D (mm): 37 | H (mm): 105 | Height (mm): 105 | Vers...
€3,83 €3,17
DANA Spicer O-ring as front axle 745, 4 g
€16,85 €13,93
DANA Spicer Plug front axle 745
€19,40 €16,03
Showing 25 - 48 of 122

Valtra T 213 parts with a focus on cooling

When the temperature gauge on a Valtra T 213 starts creeping up, the cause is often a small component. A thermostat that no longer opens, a radiator hose gone soft, a sensor sending the wrong reading. This page holds more than 120 replacement parts for the T 213, from GRANIT, BOSCH, Walterscheid, DANA Spicer and Scharmüller.

Cooling and engine

On the cooling side there are thermostats, radiator hoses, a cooling fan and engine temperature sensors. Always fit a thermostat with a fresh gasket and bleed the system properly afterwards, since an air pocket at the thermostat makes it open late. There is also a tensioning pulley for the belt drive. If you hear a hum or rattle at the front of the engine, spin the pulley by hand: roughness or play means it is time for a new one.

You will also find gaskets, including one at the exhaust by the turbocharger, seals for pressure lines and O-rings such as the one on the oil filler cap.

Lights, cab and hitch

For working after dark there are work lamps, headlights and an LED headlight, along with connection cables for tidy wiring. In the cab there is a door lock. At the rear, a drawbar ball and a separate ball fit the hitch rail.

A tip on the cooling fan

If the cooling fan is not doing its job, the temperature climbs under heavy work or in hot weather while staying normal under light load. With the engine off, look for chipped or cracked blades and feel whether the hub has play. Blow the radiator and the coolers in front of it clean with compressed air regularly, working from the inside out. Dust and chaff between the fins hold back more heat than you would expect. If the temperature sensor gives odd readings, check its plug for corrosion before replacing the sensor.

Identifying the right part

The Valtra T series comes in several types, so check the type plate first to confirm the tractor is a T 213, then compare the reference number on the old part. With a thermostat, the opening temperature printed on it matters too, and with a radiator hose the position, upper or lower.

The other types in the T series each have a page with their own parts:

Brand-wide items are collected under Valtra parts, together with parts that are not tied to a single type.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart