Menu
EUR

Valtra 6750 tractor parts & technical data

Steering, front axle, electrics and lighting: more than 110 parts for the Valtra 6750 from the Hitech series are listed here. Some know it as the Valmet 6750.

116 parts found for Valtra-Valmet 6750
Show:
GRANIT Ball joint 220 mm, M22 x 1,5, M22 x 1,5, taper 23,5 - 26,4 mm
GRANIT
A: 220 mm. C: M22 x 1,5 mm. D: M22 x 1,5 mm. E: 23,5 mm. F: 26,4 mm. Taper: 23,5 - 26,4 mm. More
A: 220 mm. C: M22 x 1,5 mm. D: M22 x 1,5 mm. E: 23,5 mm. F: 26,4 mm. T...
€79,46 €65,67 €75,45 €62,36
You save 5%
Carraro Bronze bearing Ø 53 x 48 x 40 mm Massey Ferguson, Case IH, New Holland
Carraro
Outer Ø: 53 mm. Inner Ø: 48 mm. Length: 40 mm. More
Outer Ø: 53 mm. Inner Ø: 48 mm. Length: 40 mm.
€14,60 €12,07
GRANIT Wheel brake cylinder K1, DOT 4 Valtra-Valmet Mezzo 6000-6900
€176,09 €145,53 €167,25 €138,22
You save 5%
GRANIT Repair set brake cylinder Valtra-Valmet, Fendt
€37,73 €31,18 €35,80 €29,59
You save 5%
Brake disc Ø 224 mm, 27 teeth, thickness 5 mm, 50 km/h, for ceramic
Notes: Please check the rear axle version and take this into account when ordering.. More
Notes: Please check the rear axle version and take this into account w...
€38,45 €31,78
Thermostat Ø 67 mm, 83 °C Massey Ferguson, Case IH, Steyr
Ø: 67 mm. Temperature: 83 °C. More
Ø: 67 mm. Temperature: 83 °C.
€36,87 €30,47 €35,00 €28,93
You save 5%
Optibelt V-belt Massey Ferguson 3120, 5425-5460, 6180, 6445, 6455
€34,61 €28,60 €32,85 €27,15
You save 5%
Crankshaft seal for Ø 58 x 80 x 12 mm Massey Ferguson
Outer Ø: 80 mm. Width: 12 mm. Inner Ø: 58 mm. More
Outer Ø: 80 mm. Width: 12 mm. Inner Ø: 58 mm.
€14,80 €12,23
Cylinder head gasket engine Sisu 420
€146,11 €120,75 €138,80 €114,71
You save 5%
GRANIT Silencer at exhaust pipe hood Valtra-Valmet Mezzo, HiTech
€377,81 €312,24 €358,90 €296,61
You save 5%
Door lock, right Fendt Farmer 240 S (Typ 294), GT 395
€54,33 €44,90 €51,60 €42,64
You save 5%
Scharmüller Drawbar K80 manual, rail 335 mm, pin Ø 22 mm, 3000 kg, AGCO gray
Scharmüller
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 3000 kg. D-value: 89,3 kN. Plate height: 150 mm. Colour: AGCO grey. Overh... More
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load cap...
€1.294,08 €1.069,49 €1.089,95 €900,79
You save 16%
Scharmüller Ball 80® ball inserts gray cast iron, rail width 335 mm, 4000 kg
Scharmüller
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load capacity: 4000 kg. D-value: 89,3 kN. Plate height: 160 mm. Colour: AGCO grey. Overh... More
Rail width: 335 mm. Detent pin Ø: 22 mm. Guide width: 30 mm. Load cap...
€1.221,12 €1.009,19 €1.028,50 €850,00
You save 16%
GRANIT Seal kit Valtra-Valmet C 90 - 150, M 120-150, T 120-190
€86,97 €71,88 €82,60 €68,26
You save 5%
BOSCH Sensor hydraulic pressure lifting height
BOSCH
Version: Lifting height. More
Version: Lifting height.
€355,33 €293,66 €314,26 €259,72
You save 12%
FLEETGUARD Hydraulic oil filter HF35322
€99,05 €81,86 €89,60 €74,05
You save 10%
MAHLE Alternator 14 V, 120 A, flange 56 mm, compact, dust-tight
MAHLE
Direction of rotation: ↻ | Installation angle (°): l 30 | Pulley Ø (mm): - | Additional information: Compact alternator, dust-tight | Mounting L /... More
Direction of rotation: ↻ | Installation angle (°): l 30 | Pulley Ø...
€372,69 €308,01 €232,90 €192,48
You save 38%
DANA Spicer Spacer as front axle 745, outer-Ø 150 mm, inner-Ø 120 mm, 1 mm
DANA Spicer
Thickness (mm): 1 | Outer Ø (mm): 150 | Inner Ø (mm): 120 More
Thickness (mm): 1 | Outer Ø (mm): 150 | Inner Ø (mm): 120
€44,85 €37,07 €42,60 €35,21
You save 5%
Seal kit hydraulic steering
€217,34 €179,62 €206,45 €170,62
You save 5%
GRANIT Hand brake cable 937 mm Valtra-Valmet Mezzo, Mega, HiTech, C
€199,41 €164,80 €189,40 €156,53
You save 5%
Starter ring gear Ø 405/373 mm, 133 teeth Valtra-Valmet
Version: Ø 405/373 mm, 133 teeth. More
Version: Ø 405/373 mm, 133 teeth.
€215,16 €177,82 €204,40 €168,93
You save 5%
GRANIT Oil cooler Valtra-Valmet 6200-8950, X100-X120
€1.305,64 €1.079,04 €1.240,35 €1.025,08
You save 5%
Showing 25 - 48 of 116

Valtra 6750 parts, also sold as the Valmet 6750

Plenty of these tractors still wear the Valmet badge, and the Valmet 6750 and Valtra 6750 are one and the same machine. Given the hours these tractors have clocked, an engine overhaul is often next on the list, and that is where this page earns its place. More than 110 parts fit the 6750, from makers such as GRANIT, Scharmüller, DANA Spicer, MAHLE and Cobo.

Rebuilding the engine

For the bottom end and top end there are piston ring sets, connecting rod bolts, a crankshaft seal and a valve cover gasket, along with seal kits, O-rings and individual seals such as the one between the exhaust manifold and turbocharger.

Always fit new connecting rod bolts during a rebuild. They stretch slightly when torqued and will not hold the same clamping force a second time. Oil the threads and tighten in stages to the engine figures. Press the new crankshaft seal in square, and never drag its lip over a sharp edge or keyway, or it will weep before the tractor has done a day of work.

Electrics, cab and steering

  • An alternator, plus a flasher unit with holder and warning light connection.
  • Work lamps and combined indicator and position lights.
  • Door locks for left and right cab doors.
  • Ball joints for worn steering linkage.
  • A ball type drawbar and separate hitch balls.

If the indicators suddenly flash at double speed, a bulb has usually blown or a holder has a poor contact. Only once every bulb and earth connection checks out is the flasher unit itself the likely fault. The unit for this tractor comes with a holder and a connection for the warning lamp, so photograph the plug before pulling it off and every wire goes back where it belongs.

To check a ball joint, have someone rock the steering wheel while you watch the joint. Visible movement between ball and housing means it is worn. Count the turns as you unscrew the old one and wind the new joint in by the same amount, which keeps the toe setting close until it can be checked properly.

Getting the right fit

The data plate confirms the model. For engine parts and seals, the number cast or printed on the old component is the safest reference to check against the details given with each product.

Within the Hitech range the 6750 has plenty of company. If you also run another tractor from that range, it has its own page:

The Valtra 8950 is part of the same range. For that one and every other model, go to the overview of Valtra parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart