Menu
EUR

Valtra 705 tractor parts & technical data

Valtra 705 or Valmet 705, this page covers both names. Browse more than 60 parts, including electrics, lighting and components for steering and front axle.

66 parts found for Valtra-Valmet 705
Show:
Brake disc Ø 224 mm, 27 teeth, thickness 5 mm, 50 km/h, for ceramic
Notes: Please check the rear axle version and take this into account when ordering.. More
Notes: Please check the rear axle version and take this into account w...
€40,13 €33,16
Water pump with seal Valtra-Valmet 505-815
€263,60 €217,85 €242,51 €200,42
You save 8%
Radiator hose, bottom inner-Ø 40 / 41 mm Valtra-Valmet
Inner Ø: 40 / 41 mm. More
Inner Ø: 40 / 41 mm.
€56,02 €46,30 €51,54 €42,59
You save 8%
Crankshaft seal for Ø 58 x 80 x 12 mm Massey Ferguson
Outer Ø: 80 mm. Width: 12 mm. Inner Ø: 58 mm. More
Outer Ø: 80 mm. Width: 12 mm. Inner Ø: 58 mm.
€15,49 €12,80
Stop cable 2250 / 2015 mm Valtra-Valmet 205-8600
A: 2250 mm. B: 2015 mm. More
A: 2250 mm. B: 2015 mm.
€34,18 €28,24
Start switch 12 V, Ø 26 mm - 1 key
Version: 12 V, with blade terminal, 0: off, 1: consumer, 2: preheat, 3: start, Mounting Ø 26 mm. More
Version: 12 V, with blade terminal, 0: off, 1: consumer, 2: preheat, 3...
€252,17 €208,41 €232,00 €191,73
You save 8%
Steering column switch indicator, main beam, horn, interval
Version: Functions: indicators, horn, dipped beam/full beam changeover, headlight flasher, wiper/washer intervals. Connection cable with 2 plugs. More
Version: Functions: indicators, horn, dipped beam/full beam changeover...
€250,30 €206,86
Starter ring gear Ø 405/373 mm, 133 teeth Valtra-Valmet
Version: Ø 405/373 mm, 133 teeth. More
Version: Ø 405/373 mm, 133 teeth.
€224,52 €185,55 €206,56 €170,71
You save 8%
Radiator filler cap grommet-Ø 57 mm, height 25 mm
Neck Ø: 57 mm. Height: 25 mm. More
Neck Ø: 57 mm. Height: 25 mm.
€25,20 €20,83
Main headlight insert left and right H4 12V 55W, T4W without marker light
Bulb: 12V55W / H4, 12V4WK / T4W. Nominal voltage: 12 V. Light function: with high beam, with low beam, without position light. More
Bulb: 12V55W / H4, 12V4WK / T4W. Nominal voltage: 12 V. Light function...
€63,07 €52,12 €58,02 €47,95
You save 8%
Repair set brake cylinder DOT4 with piston Valtra-Valmet, Steyr
Medium: DOT4. Additional information: With piston. More
Medium: DOT4. Additional information: With piston.
€61,12 €50,51 €56,23 €46,47
You save 8%
Toggle switch lighting black lever, 4 blade connections
Version: For lighting, 4 blade terminals 6.3 mm. More
Version: For lighting, 4 blade terminals 6.3 mm.
€32,44 €26,81
Showing 49 - 66 of 66

Valmet 705 and Valtra 705 parts

Many of these tractors still wear Valmet on the bonnet, while parts lists often call the same machine the Valtra 705. It is one and the same type. This page has more than 60 replacement parts for the 705, from GRANIT, MAHLE, VDO, Cobo and HELLA.

Fuel, starting and engine

If the engine is slow to fire or dies under load, the feed pump is a sensible place to start. There are feed pumps and separate feed pump seals. A leaking seal draws in air, which means bleeding the system again after every stop. The stop cable is here as well: one that drags or no longer springs back fully can keep the engine from shutting off cleanly.

For starting and charging there are starter motors, alternators and connection cables. On the engine itself you will find a rear crankshaft seal, radiator hoses and a coolant temperature sensor, so the gauge reads correctly again.

Brakes, clutch and steering

For the brakes there are wheel brake cylinders and repair kits for the brake cylinder. A repair kit makes sense as long as the bore is smooth. Once pitting or rust shows inside, a complete new cylinder is the better choice. The clutch side has a clutch plate, and for the steering there are ball joints.

The electrical parts also include a flasher unit with holder and a headlight.

A tip on the crankshaft seal

Oil at the bottom between engine and clutch housing may well come from the rear crankshaft seal. Replace it while the clutch is out anyway, when it is only a small extra job. Check the running surface on the crankshaft: if there is a groove, set the new seal slightly deeper or shallower so the lip runs on a clean surface. Oil the lip lightly with engine oil and press the seal in straight and evenly. A seal fitted at an angle soon leaks again, and the oil ends up on your new clutch plate.

Finding the matching part

The type plate tells you whether the tractor is a 705, sometimes still under the Valmet name. Then compare the number on the old part with the description on this page. For a stop cable, measure the length of the old one, and for a radiator hose note whether it is the upper or lower.

The 705 belongs to the 05 series from Valtra and Valmet. The other types in that series each have their own page:

Brand-wide items are under Valtra parts.

Brands
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison
This product has been added to your cart