Menu
EUR

Valtra N 113 tractor parts & technical data

Got a Valtra N 113 from the N3 series in the yard? Find more than 100 parts here, such as trailer couplings, electrics, and steering and front axle parts.

110 parts found for Valtra-Valmet N 113
Show:
AdBlue supply unit Fendt, Massey Ferguson, SAME, Lamborghini
Description: AdBlue supply units ensure even metering of AdBlue depending on the load on the common rail engine. It is important that only filtered ur... More
Description: AdBlue supply units ensure even metering of AdBlue depend...
€1.457,72 €1.204,73 €1.384,80 €1.144,46
You save 5%
Thermostat Ø 67 mm, 83 °C
Ø: 67 mm. Temperature: 83 °C. More
Ø: 67 mm. Temperature: 83 °C.
€37,90 €31,32 €36,00 €29,75
You save 5%
Main bearing standard Ø 85 mm
€48,38 €39,98 €45,95 €37,98
You save 5%
GRANIT PTO shaft end piece 1 3/8 inch, 6 splines, 245 mm Valtra-Valmet
GRANIT
Version: 1 3/8"", 6 grooves | Length (mm): 245 More
Version: 1 3/8"", 6 grooves | Length (mm): 245
€397,91 €328,85 €378,00 €312,40
You save 5%
Internal plate PTO clutch Ø 133,4 x 93 mm, 1,8 mm, 45 teeth
Version: Thickness: 1.8 mm, inner: 93 mm, outer: 133.4 mm, 45 splines More
Version: Thickness: 1.8 mm, inner: 93 mm, outer: 133.4 mm, 45 splines
€17,98 €14,86 €17,00 €14,05
You save 5%
SANDEN Aircon compressor 12 V, Ø 119 mm, 6 grooves Valtra-Valmet
SANDEN
Fixing: DM | Refrigerant: R 134a | No. of grooves: 6 | Nominal voltage (V): 12 | Oil quantity (ccm): 190 | Suitable oil: SP 10 | Pulley Ø (mm): 119 More
Fixing: DM | Refrigerant: R 134a | No. of grooves: 6 | Nominal voltage...
€619,57 €512,04 €588,55 €486,41
You save 5%
GRANIT Clutches set 7+7 Valtra-Valmet 6250 - 8950, C90 - XM150
€164,08 €135,60 €155,85 €128,80
You save 5%
DANA Spicer Intermediate bush as front axle 745, 120 x 127 x 40 mm
DANA Spicer
Dimensions (mm): 120 x 127 x 40 | Inner Ø (mm): 120 | Height (mm): 40 | Outer Ø (mm): 127 More
Dimensions (mm): 120 x 127 x 40 | Inner Ø (mm): 120 | Height (mm): 40...
€134,56 €111,21 €127,80 €105,62
You save 5%
Gear wheel main shaft 31 teeth Valtra-Valmet
Number of teeth: 31. More
Number of teeth: 31.
€405,59 €335,20 €385,30 €318,43
You save 5%
GRANIT Injector Fendt 200, Valtra-Valmet N3, T3, Massey Ferguson 5600
€643,72 €532,00 €611,50 €505,37
You save 5%
Cooling fan electric Ø 596 mm Valtra-Valmet, Case IH, New Holland
€907,46 €749,97 €862,00 €712,40
You save 5%
Fan clutch Valtra N103.4-N163, T132-T202, T133-T203
€695,98 €575,19 €661,15 €546,41
You save 5%
GRANIT Starter switch with 2 keys
€70,07 €57,91 €66,55 €55,00
You save 5%
Showing 73 - 96 of 110

Valtra N 113 parts

Once a Valtra N 113 has racked up serious hours, the hitch, the driveline and the cooling system are where the work starts. There are more than 100 replacement parts that fit it, from GRANIT, DANA Spicer, Scharmüller, Walterscheid and BOSCH.

Hitching up

At the rear there are ball type drawbars and separate ball inserts from Scharmüller. A ball hitch wears on the top surface where the trailer eye bears down, so check it regularly and replace the insert before the coupling starts to knock. For the cab there is a door lock, and for working after dark a work lamp.

Driveline

Transmission parts include clutch sets, gear wheels, adapter plates and differential bevel gears, along with a gear reduction starter. Differential bevel gears and planet pinions wear as a group. If one gear shows pitting or chipped teeth, inspect its partners and the thrust washers too.

Cooling and engine

  • thermostats
  • a fan clutch and an electric cooling fan
  • temperature sensors
  • seals, such as the exhaust manifold seal at the turbocharger
  • O-rings, for instance for the oil filler cap

A slipping fan clutch lets the fan lag behind and the engine runs hot under load. Spin the fan by hand while the engine is still cold and it should resist noticeably. If it spins freely or there is oil around the clutch, replace it.

With the electric cooling fan, check the fuse and the plug before anything else. If the fan feels rough when turned by hand or makes noise, its motor is worn and a new fan is the answer. Replacement adapter plates and gear wheels are easiest to match using the number stamped on the old part.

A gear reduction starter that only clicks is not always faulty itself. Check the battery, the earth strap and the solenoid terminal before replacing it, since a poor connection gives the same symptom. If the door lock no longer catches, the lock is usually to blame rather than the door. After fitting a new one, adjust the striker so the door closes without force and does not rattle. A work lamp that keeps failing from vibration needs a firm bracket and a clean earth connection.

Choosing correctly

The serial number is on the type plate of the N 113. When in doubt, go by the number on the old part, on the starter or fan clutch for example, and search the shop with it. The other tractors in the N series each have a separate page:

All Valtra tractors are listed under Valtra parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart