Menu
EUR

Valtra A 75 tractor parts & technical data

More than 100 parts for the Valtra A 75 from the A series on one page, from trailer couplings and electrics to steering and front axle components.

101 parts found for Valtra-Valmet A 75
Show:
DANA Spicer Intermediate bush as front axle 745, 120 x 127 x 40 mm
DANA Spicer
Dimensions (mm): 120 x 127 x 40 | Inner Ø (mm): 120 | Height (mm): 40 | Outer Ø (mm): 127 More
Dimensions (mm): 120 x 127 x 40 | Inner Ø (mm): 120 | Height (mm): 40...
€134,56 €111,21 €127,80 €105,62
You save 5%
GRANIT Wheel brake cylinder S1 / S4 Valtra-Valmet 600 - 900, A 65 - A 95
€182,83 €151,10 €173,65 €143,51
You save 5%
Starter ring gear Ø 390/357 mm, 128 teeth Fendt, Massey Ferguson
Version: Ø 390/357 mm, 128 teeth. More
Version: Ø 390/357 mm, 128 teeth.
€97,09 €80,24 €92,20 €76,20
You save 5%
GRANIT Radiator hose, bottom inner-Ø 40 / 41 mm Valtra-Valmet
GRANIT
Inner Ø: 40 / 41 mm. More
Inner Ø: 40 / 41 mm.
€53,69 €44,37 €51,00 €42,15
You save 5%
Thermostat Ø 67 mm, 83 °C
Ø: 67 mm. Temperature: 83 °C. More
Ø: 67 mm. Temperature: 83 °C.
€37,90 €31,32 €36,00 €29,75
You save 5%
Cylinder head bolt 12 x 140 mm Massey Ferguson, Case IH, Steyr
Dimensions: M12 x 140 mm. More
Dimensions: M12 x 140 mm.
€14,60 €12,07
Main bearing standard Ø 85 mm
€48,38 €39,98 €45,95 €37,98
You save 5%
GRANIT Starter switch with 2 keys
€70,07 €57,91 €66,55 €55,00
You save 5%
GRANIT Aircon compressor 12 V, pulley Ø 132 mm, 2 grooves, 135 ccm oil
GRANIT
Reference no.: QP7H15-8024 | Suitable oil: PAG 46 | For compressor: 7H15 | Nominal voltage (V): 12 | Pulley Ø (mm): 132 | Fixing: EM | Oil quantity (... More
Reference no.: QP7H15-8024 | Suitable oil: PAG 46 | For compressor: 7H...
€343,01 €283,48 €325,85 €269,30
You save 5%
GRANIT Alternator 14 V / 95 A, flange 56 mm Valtra-Valmet
GRANIT
Belt tension hole Ø / R (mm): 8,2 / 86,0 | Nominal voltage (V): 14 | Mounting L / d / R (mm): 56,0 / 8,2 / 86,0 | Charging current (A): 95 | Nominal ... More
Belt tension hole Ø / R (mm): 8,2 / 86,0 | Nominal voltage (V): 14 | ...
€252,07 €208,32 €239,45 €197,89
You save 5%
Alternator 14 V / 65 A, pulley-Ø 80 mm, flange 82 mm Valtra-Valmet
Form: A | Installation angle (°): l 60 | Mounting hole Ø / R (mm): 8,2 / 86,0 | Flange size (mm): 82,0 | Mounting L / d / R (mm): 82,0 / 8,2 / 86,0 ... More
Form: A | Installation angle (°): l 60 | Mounting hole Ø / R (mm): 8...
€227,53 €188,04 €216,15 €178,64
You save 5%
GRANIT Tie rod 5 notches taper 16,2 - 18,3 mm, 310 mm, M14 x 1,5
GRANIT
A: 310 mm. C: M14 x 1,5 mm. D: 18 mm. E: 16,2 mm. F: 18,3 mm. Taper: 16,2 - 18,3 mm. More
A: 310 mm. C: M14 x 1,5 mm. D: 18 mm. E: 16,2 mm. F: 18,3 mm. Taper: 1...
€76,34 €63,09 €72,50 €59,92
You save 5%
GRANIT Water pump with gasket Valtra-Valmet, Massey Ferguson
€175,18 €144,78 €166,40 €137,52
You save 5%
Foot throttle cable A 1365 mm, B 1270 mm Valtra-Valmet, Massey Ferguson
€119,40 €98,68 €113,40 €93,72
You save 5%
Piston ring set 3 rings Ø 108 mm, 2,5 mm / 2,5 mm / 4 mm
Dimensions: 3 rings, Ø 108 mm, 2.5 mm / 2.5 mm / 4 mm. More
Dimensions: 3 rings, Ø 108 mm, 2.5 mm / 2.5 mm / 4 mm.
€39,58 €32,71 €37,60 €31,07
You save 5%
Water pump Massey Ferguson 3630-4455, Valtra-Valmet A 75 - A 95
€318,62 €263,32 €302,65 €250,12
You save 5%
Showing 73 - 96 of 101

Valtra A 75 parts

The Valtra A 75 is a tractor most owners still service themselves, and the parts on this page reflect that kind of work. More than 100 of them fit this model, from GRANIT and from manufacturers such as DANA Spicer, Walterscheid, Scharmüller and GRAMMER.

Cooling and engine

Water pumps are listed together with their gaskets. On the engine side there are valve cover gaskets, seals for the valve cover, crankshaft seals, O-rings for the feed pump and a gasket between the exhaust silencer and the turbocharger. Alternators complete this group.

When a crankshaft seal starts to weep, look closely at the shaft before fitting the new one. If the old lip has worn a groove into the running surface, a new seal sitting in that same groove will not last. Drive the new seal in square with a suitable drift, oil the lip lightly and make sure it does not fold back on fitting. For the water pump, a new gasket and fresh coolant go with every replacement, and the system needs bleeding with the engine warm.

Hitch, steering, cab and lights

  • Drawbar frames and drawbars with ball, from makers including Scharmüller and Walterscheid.
  • Ball joints for the steering linkage.
  • Door locks and tractor seats, with GRAMMER among the seat brands.
  • Work lamps, indicator and position lights and flasher units.

If the battery is not charging properly, the alternator is not automatically to blame. Measure the charging voltage with the engine running and check the belt, the earth strap and the plug connections first. And when a tractor seat sags or rocks, the cause usually sits in the suspension or the slide rails underneath rather than in the cushion, so look there before replacing the whole seat.

Getting the right part for your A 75

The A 75 is part of the Valtra A series. Confirm the model on the type plate, then look for a stamped or printed number on the part you are replacing. Water pumps usually carry it on the housing, alternators on a small plate at the back. Door locks, ball joints and lights also come in left and right versions, so note the side before ordering.

Other tractors in the A series have their own pages, which saves time if your fleet includes more than one of them:

For any other model of the brand, start at Valtra parts, where every type with replacement parts available is listed.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart