Menu
EUR

Valtra 705 tractor parts & technical data

Valtra 705 or Valmet 705, this page covers both names. Browse more than 60 parts, including electrics, lighting and components for steering and front axle.

66 parts found for Valtra-Valmet 705
Show:
MAHLE Starter motor 12 V, 3,0 kW, 11 teeth, mounting Ø 89 mm, mounting angle r 45
38%
MAHLE
Starter motor 12 V, 3,0 kW, 11 teeth, mounting Ø 89 mm, mounting angle r 45
€484,86 €400,71 €303,00 €250,41
 
Water pump with seal Valtra-Valmet 505-815
5%
Water pump with seal Valtra-Valmet 505-815
€252,61 €208,77 €239,95 €198,31
 
GRANIT Radiator hose, bottom inner-Ø 40 / 41 mm Valtra-Valmet
5%
GRANIT
Radiator hose, bottom inner-Ø 40 / 41 mm Valtra-Valmet
Inner Ø: 40 / 41 mm.
€53,69 €44,37 €51,00 €42,15
 
GRANIT Turbocharger Valtra-Valmet 705
GRANIT
Turbocharger Valtra-Valmet 705
€1.219,50 €1.007,85
 
GRANIT Cylinder head gasket Valtra-Valmet 705, 805, 865
5%
GRANIT
Cylinder head gasket Valtra-Valmet 705, 805, 865
€68,49 €56,60 €65,00 €53,72
 
GRANIT Seal feed pump Valtra-Valmet, Steyr, Case IH
GRANIT
Seal feed pump Valtra-Valmet, Steyr, Case IH
€21,35 €17,64
 
GRANIT Main headlight insert left and right H4 12V 55W, T4W without marker light
10%
GRANIT
Main headlight insert left and right H4 12V 55W, T4W without marker light
Bulb: 12V55W / H4, 12V4WK / T4W. Nominal voltage: 12 V. Light function: with hig...
€63,46 €52,45 €57,40 €47,44
 
GRANIT Starter motor with reduction 12 V, 2,7 kW, 11 teeth, 193 mm, Ø 89 mm
5%
GRANIT
Starter motor with reduction 12 V, 2,7 kW, 11 teeth, 193 mm, Ø 89 mm
€237,27 €196,09 €225,40 €186,28
 
GRANIT Ball joint taper 16,2 - 18,3 mm, length 100 mm, M14 x 1,5, M22 x 1,5 L
5%
GRANIT
Ball joint taper 16,2 - 18,3 mm, length 100 mm, M14 x 1,5, M22 x 1,5 L
A: 100 mm. C: M14 x 1,5 mm. D: M22 x 1,5 L mm. E: 16,2 mm. F: 18,3 mm. Taper: 16...
€68,70 €56,78 €65,25 €53,93
 
GRANIT Radiator hose, top inner-Ø 40 mm Valtra-Valmet Mezzo 6000-6800
5%
GRANIT
Radiator hose, top inner-Ø 40 mm Valtra-Valmet Mezzo 6000-6800
Inner Ø: 40 mm.
€49,44 €40,86 €46,95 €38,80
 
GRANIT Inlet valve engine Sisu 311-611 Valtra-Valmet
5%
GRANIT
Inlet valve engine Sisu 311-611 Valtra-Valmet
€109,14 €90,20 €103,65 €85,66
 
GRANIT Oil sump gasket Valtra-Valmet engine 411DS
GRANIT
Oil sump gasket Valtra-Valmet engine 411DS
€25,90 €21,41
 
GRANIT Injection nozzle Valtra-Valmet 205-855
5%
GRANIT
Injection nozzle Valtra-Valmet 205-855
Type formula: DLLA150S804, 0433271856.
€39,07 €32,29 €37,10 €30,66
 
GRANIT O-clamp set 115 x 3,5 mm Steyr, Massey Ferguson - 3 pieces
5%
GRANIT
O-clamp set 115 x 3,5 mm Steyr, Massey Ferguson - 3 pieces
Dimensions: All rings 115 x 3.5 mm.
€33,54 €27,72 €31,85 €26,32
 
Showing 49 - 66 of 66

Valmet 705 and Valtra 705 parts

Many of these tractors still wear Valmet on the bonnet, while parts lists often call the same machine the Valtra 705. It is one and the same type. This page has more than 60 replacement parts for the 705, from GRANIT, MAHLE, VDO, Cobo and HELLA.

Fuel, starting and engine

If the engine is slow to fire or dies under load, the feed pump is a sensible place to start. There are feed pumps and separate feed pump seals. A leaking seal draws in air, which means bleeding the system again after every stop. The stop cable is here as well: one that drags or no longer springs back fully can keep the engine from shutting off cleanly.

For starting and charging there are starter motors, alternators and connection cables. On the engine itself you will find a rear crankshaft seal, radiator hoses and a coolant temperature sensor, so the gauge reads correctly again.

Brakes, clutch and steering

For the brakes there are wheel brake cylinders and repair kits for the brake cylinder. A repair kit makes sense as long as the bore is smooth. Once pitting or rust shows inside, a complete new cylinder is the better choice. The clutch side has a clutch plate, and for the steering there are ball joints.

The electrical parts also include a flasher unit with holder and a headlight.

A tip on the crankshaft seal

Oil at the bottom between engine and clutch housing may well come from the rear crankshaft seal. Replace it while the clutch is out anyway, when it is only a small extra job. Check the running surface on the crankshaft: if there is a groove, set the new seal slightly deeper or shallower so the lip runs on a clean surface. Oil the lip lightly with engine oil and press the seal in straight and evenly. A seal fitted at an angle soon leaks again, and the oil ends up on your new clutch plate.

Finding the matching part

The type plate tells you whether the tractor is a 705, sometimes still under the Valmet name. Then compare the number on the old part with the description on this page. For a stop cable, measure the length of the old one, and for a radiator hose note whether it is the upper or lower.

The 705 belongs to the 05 series from Valtra and Valmet. The other types in that series each have their own page:

Brand-wide items are under Valtra parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart