Menu
EUR

Valtra N 122 tractor parts & technical data

Looking for parts for a Valtra N 122 from the N2 series? This page lists more than 110 items, including trailer couplings, lighting and electrics.

110 parts found for Valtra-Valmet N 122
Show:
Alternator 12 V / 65 A Challenger, JCB, Massey Ferguson, Valtra-Valmet
5%
Alternator 12 V / 65 A Challenger, JCB, Massey Ferguson, Valtra-Valmet
Installation angle (°): l 60 | Charging current (A): 65 | Additional information...
€245,47 €202,87 €233,15 €192,69
 
DANA Spicer King pin final drive front axle 755
5%
DANA Spicer
King pin final drive front axle 755
€109,73 €90,69 €104,20 €86,12
 
DANA Spicer Differential bevel gear final drive front axle 725
DANA Spicer
Differential bevel gear final drive front axle 725
€103,30 €85,37
 
DANA Spicer Sealing ring final drive front axle 755, 40 x 65 x 18 mm
5%
DANA Spicer
Sealing ring final drive front axle 755, 40 x 65 x 18 mm
Dimensions (mm): 40 x 65 x 18
€32,42 €26,79 €30,75 €25,41
 
DANA Spicer Grooved nut bevel gear differential front axle 730
DANA Spicer
Grooved nut bevel gear differential front axle 730
€78,80 €65,12
 
Hand brake cable 1005 mm Valtra-Valmet HiTech, C, M, N, T, X, XM
5%
Hand brake cable 1005 mm Valtra-Valmet HiTech, C, M, N, T, X, XM
Length: 1005 mm.
€207,39 €171,40 €197,00 €162,81
 
GRANIT Gear wheel planetary set rear axle 82 teeth Valtra-Valmet
5%
GRANIT
Gear wheel planetary set rear axle 82 teeth Valtra-Valmet
Number of teeth: 82.
€857,65 €708,80 €814,75 €673,35
 
Piston set Massey Ferguson, Valtra-Valmet, Fendt
5%
Piston set Massey Ferguson, Valtra-Valmet, Fendt
€145,28 €120,07 €138,00 €114,05
 
Thermostat Ø 67 mm, 83 °C
5%
Thermostat Ø 67 mm, 83 °C
Ø: 67 mm. Temperature: 83 °C.
€37,90 €31,32 €36,00 €29,75
 
Air hose to intercooler Valtra-Valmet T140-T170
5%
Air hose to intercooler Valtra-Valmet T140-T170
€108,96 €90,05 €103,50 €85,54
 
Seal kit top and bottom Valtra-Valmet Mezzo 6000-6850
5%
Seal kit top and bottom Valtra-Valmet Mezzo 6000-6850
€422,97 €349,56 €401,80 €332,07
 
Main bearing standard Ø 85 mm
5%
Main bearing standard Ø 85 mm
€48,38 €39,98 €45,95 €37,98
 
GRANIT PTO shaft end piece 1 3/8 inch, 6 splines, 245 mm Valtra-Valmet
5%
GRANIT
PTO shaft end piece 1 3/8 inch, 6 splines, 245 mm Valtra-Valmet
Version: 1 3/8"", 6 grooves | Length (mm): 245
€397,91 €328,85 €378,00 €312,40
 
Internal plate PTO clutch Ø 133,4 x 93 mm, 1,8 mm, 45 teeth
5%
Internal plate PTO clutch Ø 133,4 x 93 mm, 1,8 mm, 45 teeth
Version: Thickness: 1.8 mm, inner: 93 mm, outer: 133.4 mm, 45 splines
€17,98 €14,86 €17,00 €14,05
 
GRANIT Filter dryer Ø 76 mm, 228 mm, connection thread M
5%
GRANIT
Filter dryer Ø 76 mm, 228 mm, connection thread M
Outer Ø (mm): 76 | Connection: O-ring A = male thread 3/8"" - 18UNF O-ring B = m...
€61,13 €50,52 €58,00 €47,93
 
GRANIT Clutches set 7+7 Valtra-Valmet 6250 - 8950, C90 - XM150
5%
GRANIT
Clutches set 7+7 Valtra-Valmet 6250 - 8950, C90 - XM150
€164,08 €135,60 €155,85 €128,80
 
DANA Spicer Hollow wheel carrier final drive front axle 212, 5,22 kg
DANA Spicer
Hollow wheel carrier final drive front axle 212, 5,22 kg
€513,00 €423,97
 
DANA Spicer Intermediate bush as front axle 745, 120 x 127 x 40 mm
5%
DANA Spicer
Intermediate bush as front axle 745, 120 x 127 x 40 mm
Dimensions (mm): 120 x 127 x 40 | Inner Ø (mm): 120 | Height (mm): 40 | Outer Ø ...
€134,56 €111,21 €127,80 €105,62
 
Showing 73 - 96 of 110

Valtra N 122 parts: brakes, engine seals and lighting

On an N 122, wear tends to announce itself. The brake pedal goes soft, or the exhaust manifold starts to blow at the turbo. This page brings together more than 110 parts that fit this Valtra from the N2 line, made by GRANIT, DANA Spicer, Scharmüller, Walterscheid and BOSCH.

Brake cylinders and repair kits

There are master brake cylinders, wheel brake cylinders and repair kits. A repair kit makes sense while the cylinder body is sound and only the cups and seals have given up. If the bore shows rust or scoring, a complete cylinder is the better buy.

Once it is fitted, bleed the whole brake system and use exactly the fluid named in the tractor's operator manual. The wrong fluid attacks the rubber parts, and the same cylinder will be weeping again within a season.

Sealing the Sisu engine

Engine work on this tractor revolves around seals of one sort or another. You can fit a rear crankshaft seal, an upper seal kit for the Sisu engine, an exhaust manifold seal at the turbocharger and an O-ring for the oil filler cap. Thermostats cover the cooling side. Oil dripping between engine and gearbox points to that rear crankshaft seal, and because the tractor has to be split to reach it, replace anything else in that area while it is apart.

Lights, door lock and drawbar

For lighting there are headlights, LED headlights with dipped and main beam, and flood beam work lamps. The cab door lock can be ordered on its own. At the rear, drawbars with a ball, separate balls and an adapter plate for the hitch rail all fit.

Thinking of swapping the old headlights for LED units? Check first that the new lamp fits the existing housing and that the plug matches. A flood beam work lamp lights up a wide area close to the tractor, which helps when hitching up or loading after dark. Re-aim new headlights once they are fitted so you do not dazzle oncoming traffic.

Matching parts to your tractor

Note the chassis number from the type plate on your N 122. For engine parts, have the engine number to hand as well, so the seals match your engine exactly. If the old part is still on the bench, look for the number stamped or printed on it. With lamps and brake parts that is usually the fastest way in.

Have another tractor from the same line in the shed? Its parts sit on a separate page: Valtra N 92 or Valtra N 142. Every other Valtra and Valmet model can be reached from Valtra parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart